Próbki mięsa wieprzowego, pakowano próżniowo w torebki z folii PAPE, poddawano działaniu ciśnienia izostatycznego 400 Mpa i przechowywano w 4C do wystąpienia wyraźnych objawów zepsucia. W określonych odstępach czasu część próbek poddawano badaniom sensorycznym i mikrobiologicznym oraz instrumentalnym badaniom tekstury i barwy. Próbki prasowane dłużej zachowywały przydatność do spożycia i posiadały lepszą teksturę, niż próby kontrolne. Ujemną cechąpróbek ciśnieniowanych było nadmierne rozjaśnienie naturalnej czerwonej barwy mięsa. Ciśnieniowanie obniżało znacznie ogólną liczbę drobnoustrojów w mięsie, jednak w czasie przechowywania przyrost jednostek tworzących kolonie był w próbach prasowanych wyższy, niż w próbachkontrolnych. Wysokie ciśnienie niszczyło nieodwracalnie bakterie Escherichia coli. W oddzielnej serii doświadczeń z zastosowaniem ciśnień rzędu 50-300 MPa ustalono, że ciśnienie hydrostatyczne powyżej 200 MPa powoduje pełną dekontaminację mięsa zainfekowanego larwami włośnią Trichinella spiralis.
EN
Samples of fresh pork meat were vacuum-packed in polyamide-polyethylene foil, subjected to isostatic pressure of 400 MPa and stored at 4°C until visible symptoms of spoiling. In definite time intervals certain numbers of the samples, as well as of non-pressurized control samples, were subjected to sensoric and instrumental quality assessments involving determinations of general appearence, flavour, hardness, colour, texture etc. both in raw and boiled state. Total no. of colony-forming units and coli titre were also determined. The pressurisation increased the shelf life of the meat and improved its sensoric properties except of the coulour which appeared too bright because of hemoglobine destruction. The pressure applied reduced the total no. of colony-forming units by about two log units, but the overall growth of bacteria during the storage was much more rapid in pressurised samples than that in the controls. The pressurisation destroyed completely and irreversibly the Escherichia coli in the meat samples.
A new method of determination of dimensional changes of sintered parts and green compacts has been proposed. The method is potentially applicable in production technologies. It is based on measurements of the density changes of formed parts which occur during pressing and sintering. The method has been verified by comparison with the method of direct measurements of dimensional changes. Determination of technological coefficients by means of the proposed method provides higher precision than the direct measurement of dimensions.
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.