Wyniki wyszukiwania - BazTech

Ograniczanie wyników

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Sortuj według:

Ogranicz wyniki do:

Delamination analysis in single-point incremental forming of steel/steel bi-layer sheet metal

Hassan M., Hussain G., Ilyas M., Ali A.

Archives of Civil and Mechanical Engineering

2020

Vol. 20, no. 2

124--137

Layered metallic materials (LMMs) offer superior properties in comparison to their counterpart monolithic sheets. Single-point incremental forming (SPIF) has emerged as an economical solution to produce LMM parts. However, delamination can limit the formability of such parts. In this study, the delamination analysis during SPIF of layered sheets was performed. Steel/steel bi-layer sheets were fabricated by roll bonding. These sheets were produced at thickness reduction ratios of 47%, 58% and 70%. The bond strength and fracture toughness in mode I and mode II were determined by T-peel and tensile shear tests, respectively. When the thickness reduction ratio was increased from 47 to 70%, an increase in bond strength was observed with 572% increase in mode I and 15.6% in mode II, respectively. On the other hand, with the same percent increase in thickness reduction, the critical strain energy release showed an increase of 3992% in mode I and 20% decrease in mode II. Surface-based cohesive zone model was used to define the interface between layers during numerical simulation of SPIF for delamination analysis. To validate the numerical results, SPIF of given bi-layer sheet was performed experimentally and a good agreement between the numerical and experimental results was observed.

Seasonal variations, environmental parameters, and standing crop assessment of benthic foraminifera in eastern Bahrain, Arabian Gulf

Arslan M., Kaminski M. A., Tawabini B. S., Ilyas M., Babalola L. O., Frontalini F.

Geological Quarterly

2016

Vol. 60, No. 1

26--37

Living benthic foraminifera in a relatively unpolluted site offshore Bahrain in the Arabian Gulf, were studied to determine the seasonal variability of their populations, as well as environmental parameters that may affect their distribution. The maximum foraminiferal density was observed during winter with the assemblages primarily dominated by rotaliids and secondarily by miliolids. The high population is attributed to an increased number of juveniles. A relationship between sediment grain size and the foraminiferal density reveals that juveniles were most abundant on coarse-grained sandy substrate and less abundant on fine-grained substrates. In spring, the foraminiferal density decreased, and the lowest values were observed during summer. The population increased again in autumn with highest juvenile/adult ratios. Moreover, results of relative abundance and species consistency show that Ammonia and Glabratellina are consistent from the shallowest to the deepest station, whereas miliolids occurred only at deeper stations. The numbers of peneroplidae and Elphidium also increased along the depth transect. Environmental characterization reveals that although the site is subject to eutrophication caused by nitrates and sulfates, pollution caused by hydrocarbons and heavy metals is not significant. The assessment of 63 heavy metals showed that none of the metals had concentrations that exceed internationally accepted norms [the devised level of Effect Range-Low], but with high concentration of strontium. The lack of a significant environmental effect of heavy metals is confirmed by the Foraminiferal Abnormality Index of <2%. Likewise, no hydrocarbon contamination was detected in the water or sediment samples. We conclude that the site in Bahrain is not yet adversely affected by human development, and therefore can provide baseline information for future comparison and assessment of foraminiferal assemblages in contaminated zones of the Arabian Gulf.