The issue of determining the geometric position deviation of the threaded holes

• Autorzy: Martikáň P. , Drbúl M. , Holubják J. , Mrázik J. , Joch R.

Identyfikatory

DOI

10.12913/22998624/65107

• Języki publikacji: EN

Abstrakty

EN

The present article analyzes the specific measurement strategies (techniques) of contact measurement that are used to determine the position deviation of the threaded holes using 3D coordinate measuring system. Furthermore, there are analyzed direct and indirect (location gages) measurement techniques to determine position of the threaded holes and results of the measurements.

Słowa kluczowe

EN

coordinate measuring systems; location gages; position deviation; threaded holes

• Wydawca: Lublin University of Technology ; Polish Society of Ecological Engineering (PTIE), Branch of PTIE in Lublin
• Czasopismo: Advances in Science and Technology. Research Journal
• Rocznik: 2016
• Tom: Vol. 10, nr 32
• Strony: 47--52
• Opis fizyczny: Bibliogr. 8 poz., fig.

Twórcy

autor

Martikáň P.

• Faculty of Mechanical Engineering, University of Žilina, Univerzitna 1, 010 26, Žilina, Slovakia

autor

Drbúl M.

• Faculty of Mechanical Engineering, University of Žilina, Univerzitna 1, 010 26, Žilina, Slovakia

autor

Holubják J.

• Faculty of Mechanical Engineering, University of Žilina, Univerzitna 1, 010 26, Žilina, Slovakia

autor

Mrázik J.

• Faculty of Mechanical Engineering, University of Žilina, Univerzitna 1, 010 26, Žilina, Slovakia

autor

Joch R.

• Faculty of Mechanical Engineering, University of Žilina, Univerzitna 1, 010 26, Žilina, Slovakia

Bibliografia

• 1. www.ring-plug-thread-gages.com
• 2. Bryce, E. Measurement of true position of threaded holes. American Society of Precision Engineering [online]. 2009 .
• 3. Petru J., Schiffner J., Zlamal T., Cep R., Kratochvil J. and Stancekova D. Wear progress of exchangeable cutting inserts during Ti(6)Al(4)V alloy machining. 24th International Conference on Metallurgy and Materials, 2015, 1147–1155.
• 4. Pilc J., Šajgalík M., Holubják J., Piešová M., Zaušková L., Babík O., Kuždák V. and Rákoci J. Austempered ductile iron machining. Technological Engineering, 12(1), 2015, 9–12.
• 5. Meadows J. Measurement of geometric tolerances in manufacturing. CRC Press, New York, 1998, 455.
• 6. Litvaj I., Poniščiaková O., Stančeková D., Drbúl M. Knowledge processes and their implementation in small transport companies. Transport Means – Proc. of the International Conference, 2013, 153–156.
• 7. Czán A., Sajgalík M., Holubjak J., Kouril K. Studying of cutting zone when finishing titanium alloy by application of multifunction measuring system. Manufacturing Technology, 13(4), 2013, 428–431.
• 8. www.zeiss.de

Uwagi

Opracowanie ze środków MNiSW w ramach umowy 812/P-DUN/2016 na działalność upowszechniającą naukę.