Wyniki wyszukiwania - Biblioteka Nauki

Nowa wersja platformy, zawierająca wyłącznie zasoby pełnotekstowe, jest już dostępna.
Przejdź na https://bibliotekanauki.pl

Ograniczanie wyników

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Wyszukiwano:
w słowach kluczowych: temperatura cięcia

Sortuj według:

Ogranicz wyniki do:

Temperature Measurement of Modern Cutting Tools During Turning

100%

Grochalski K. , Jabłoński P. , Talar R. , Twardowski P. , Wieczorowski M. , Jakubek B. , Rukat W.

Advances in Science and Technology. Research Journal

2020

tom Vol. 14, no 4

37--48

The study presents the influence of the anti-wear coatings and the type of material from which the cutting tools are made of on the cutting temperature occurring on the tool. The cutting tools made of boron nitride and tungsten carbide composite were investigated. The methodology of measuring the cutting temperature using the thermoelement and thermovision techniques was presented. The results of the temperature measurements occurring on the cutting tool in the cutting zone were compared. The paper also presents a method of determining the effective emissivity of the tested tools, necessary for the correct temperature measurement using the non-contact method. The obtained data were interpreted and the relationships described, and then the results obtained were discussed.

Investigation of the effects of machining parameters on cutting conditions during orthogonal turning of austenite stainless steel

80%

Kónya G. , Takács J. , Miskolczi I. , Kovács Z. F.

tom Vol. 30, Iss. 2

251--258

The 1.4306 austenite stainless steel has been prominently utilized as a material in the automotive and aerospace industry. Considerable interest has been garnered in the machinability of stainless steel owing to its high strength and poor thermal conductivity. The aim of this study is to ascertain the influential cutting parameters, specifically the cutting speed and feed rate, on cutting forces, cutting temperature, and chip evaluation. Thus, austenite stainless steel was subjected to free-cutting using a carbide recessing tool under dry conditions. The principle of measuring cutting temperature, a complex procedure due to varying thermal homogeneity, was elucidated. For the turning experiments in ques-tion, the standard Taguchi orthogonal array L9 (32), featuring two factors and three levels, was employed. The experimental results were analyzed using MiniTab 17 software. The findings reveal a substantial effect of feed rate on cutting force, cutting temperature, and chip evaluation. The highest cutting force and cutting temperature were observed at a feed rate of 0.15 mm/rev. Conversely, the cutting force was minimized at a cutting speed of 100 m/min, indicating potential for increasing the cutting speed. The augmentation of feed rate led to chip compression and discoloration, attributed to elevated cutting force and a larger chip cross-section that efficiently dissipates heat from the cutting zone.