Wyniki wyszukiwania - Biblioteka Nauki

1

Drought and UV-B radiation effect on photosynthesis and antioxidant parameters in soybean and maize

100%

Shen X. , Dong Z. , Chen Y.

|

nr 02

EN

Drought and ultraviolet-B (UV-B) radiation are the most adverse factors for plant growth and productivity. The aim of this study was to compare the effects and interaction of drought and UV-B radiation in the seedlings of maize and soybean. The relative leaf water content was the main factor resulting in reduced growth in response to drought. The anthocyanin and phenol levels were increased under UV-B radiation. Drought and UV-B radiation caused great membrane damage, as assessed by lipid peroxidation and osmolyte leakage. Catalase, peroxidase, superoxide dismutase and hydrogen peroxide were observed under both stress conditions. Proline increased primarily in drought-stressed seedlings and may be the drought-induced factor with a protective role in response to UV-B. The total dry matter of both plant species was decreased due to the chlorophyll content and photosynthetic rate decreased under single and combined stress conditions. UV-B radiation had more adverse effects on growth of maize and soybean seedlings than drought by the physiological and biochemical parameters measured.

2

Estimating the number of components in an OSL decay curve using the Bayesian Information Criterion

88%

Peng J. , Dong Z. , Han F. , Han Y. , Dai X.

|

tom Vol. 41, no. 4

334--341

EN

The optically stimulated luminescence (OSL) decay curve is assumed to consist of a number of first-order exponential components. Improper estimation of the number of components leads to under-or over-fitting of the curve under consideration. Hence, correct estimation of the number of components is important to accurately analyze an OSL decay curve. In this study, we investigated the possibility of using the Bayesian Information Criterion to estimate the optimal number of components in an OSL decay curve. We tested the reliability of this method using several hundred measured decay curves and three simulation scenarios. Our results demonstrate that the quality of the identification can be influenced by several factors: the measurement time and the number of channels; the variability of the decay constants; and the signal-to-noise ratios of a decaying component. The results also suggest that the Bayesian Information Criterion has great potential to estimate the number of components in an OSL decay curve with a moderate to high signal-to-noise ratio.

3

Error mitigation algorithm based on bidirectional fitting method for collision avoidance of unmanned surface vehicle

88%

Song L. , Chen Z. , Mao Y. , Dong Z. , Xiang Z.

|

tom 25

|

nr 4

EN

Radars and sensors are essential devices for an Unmanned Surface Vehicle (USV) to detect obstacles. Their precision has improved significantly in recent years with relatively accurate capability to locate obstacles. However, small detection errors in the estimation and prediction of trajectories of obstacles may cause serious problems in accuracy, thereby damaging the judgment of USV and affecting the effectiveness of collision avoidance. In this study, the effect of radar errors on the prediction accuracy of obstacle position is studied on the basis of the autoregressive prediction model. The cause of radar error is also analyzed. Subsequently, a bidirectional adaptive filtering algorithm based on polynomial fitting and particle swarm optimization is proposed to eliminate the observed errors in vertical and abscissa coordinates. Then, simulations of obstacle tracking and prediction are carried out, and the results show the validity of the algorithm. Finally, the method is used to simulate the collision avoidance of USV, and the results show the validity and reliability of the algorithm

4

Analysis Of Factors Affecting Gravity-Induced Deflection For Large And Thin Wafers In Flatness Measurement Using Three-Point-Support Method

88%

Liu H. , Dong Z. , Kang R. , Zhou P. , Gao S.

|

2015

|

tom Vol. 22, nr 4

531--546

EN

Accurate flatness measurement of silicon wafers is affected greatly by the gravity-induced deflection (GID) of the wafers, especially for large and thin wafers. The three-point-support method is a preferred method for the measurement, in which the GID uniquely determined by the positions of the supports could be calculated and subtracted. The accurate calculation of GID is affected by the initial stress of the wafer and the positioning errors of the supports. In this paper, a finite element model (FEM) including the effect of initial stress was developed to calculate GID. The influence of the initial stress of the wafer on GID calculation was investigated and verified by experiment. A systematic study of the effects of positioning errors of the support ball and the wafer on GID calculation was conducted. The results showed that the effect of the initial stress could not be neglected for ground wafers. The wafer positioning error and the circumferential error of the support were the most influential factors while the effect of the vertical positioning error was negligible in GID calculation.

5

A new basal eusauropod from the Middle Jurassic of Yunnan, China, and faunal compositions and transitions of Asian sauropodomorph dinosaurs

75%

Xing L. , Miyashita T. , Currie P. J. , You H. , Zhang J. , Dong Z.

|

nr 1

EN

Many sauropod ghost lineages cross the Middle Jurassic, indicating a time interval that requires increased sampling. A wide taxonomic spectrum of sauropodomorphs is known from the Middle Jurassic of China, but the braincase of a new sauropod, named here Nebulasaurus taito gen. et sp. nov., is distinct. Nebulasaurus is sister taxon to Spinophorosaurus from the Middle Jurassic of Africa and represents a clade of basal eusauropods previously unknown from Asia. The revised faunal list indicates dramatic transitions in sauropodomorph faunas from the Jurassic to Cretaceous of Asia; these are consistent with geographic isolation of Asia through the Late Jurassic. Non-sauropod sauropodomorphs, non-mamenchisaurid eusauropods (including basal macronarians), and mamenchisaurids successively replaced previous grades through the Jurassic, and titanosauriforms excluded all other sauropod lineages across the Jurassic–Cretaceous boundary.