Selected aspects of virtual prototyping the blowing preform process in the ansys-polyflow software

• Autorzy: Pepliński, K.
• Języki publikacji: EN

Abstrakty

EN

Technological processes of blowing the polymer preform occupy a prominent position among the widely understood blowing technology side extrusion blow molding or direct injection blow molding. Efficient design of a structural preform for a specific final polymer product needs to give its geometric form suitable thickness distribution in the different peripheral sites under consideration of the preform and the appropriate temperature field adapted to the blow ratio and the final geometry of the product or user requirements. Often it is a time consuming task in the absence of adequate knowledge about the blowing process phenomenality in general-purpose software Ansys–Polyflow. This may result in the occurrence of different errors in the numerical calculations. In a virtual design of Polyflow environment is possible to check whether a particular geometry application specific blowing preform parameters and their impact on the final form of a product.

Słowa kluczowe

EN

blowing preform; virtual prototyping; Ansys Polyflow simulation; blowing abnormalities

• Czasopismo: Journal of Polish CIMAC
• Rocznik: 2013
• Tom: Vol. 8, no 3
• Strony: 69--73
• Opis fizyczny: Bibliogr. 9 poz., rys., wykr.

Twórcy

autor

Pepliński, K.

• Bydgoszcz University of Technology and Agriculture ul. Aleja Prof. S. Kaliskiego 7, 85-789 Bydgoszcz, Poland tel.: [phone], fax: [phone],

Bibliografia

• [1] Kutz M., Applied plastics engineering handbook, 1st ed., pp. 280 – 284, Elsevier 2011
• [2] Belcher S.L., Practical guide to injection blow molding, Taylor & Francis Group, 2007.
• [3] Pepliński K., Mozer A., Ansys Polyflow software use to optimize the sheet thickness distribution in thermoforming process, Journal of Polish CIMAC, 6, Gdańsk 2011.
• [4] Pepliński K., Mozer A., Design of extrusion die for plastic profile using Ansys Polyflow software, Journal of Polish CIMAC, 6, Gdańsk 2011.
• [5] Pepliński, K., Bieliński, M., Polyflow software use to optimize the parison thickness in blowing extrusion, Journal of Polish CIMAC, 4, Gdańsk 2009.
• [6] Pepliński K., Mozer A., Ansys-Polyflow software use to select the parison diameter and its thickness distribution in blowing extrusion, Journal of Polish CIMAC, 5, Gdańsk 2010.
• [7] Pepliński, K., Bieliński, M., Processing and functional properties of the containers prepared by blowing extrusion in variable processing conditions, and evaluation of yield and quality of the process, Polimery, 54, nr 6, pp. 448–456, 2009.
• [8] Pepliński, K., Select technical aspect of energy using and management in injection molding process, Journal of Polish CIMAC, 6, Gdańsk 2011.
• [9] Metwall H., Virtual prototyping for the blow molding industry, Ansys U.S.A. 2012.