Effect of applied pressure on the quality of squeeze cast parts made from AlSi9Mg alloy

• Autorzy: Reguła, T. , Sobczak, J. J. , Fajkiel, A. , Dudek, P.
• Języki publikacji: EN

Abstrakty

EN

The results of the study of an influence of pressure in the direct squeeze casting process on the physical and mechanical properties of an AlSi9Mg alloy are presented. The specimens were made by casting the tested AlSi9Mg alloy under the conditions of variable squeeze pressure, using a PHM 160c type hydraulic press. Analyzing the results of the experiment, it has been found that, the applied pressure has an important impact on the quality of castings squeezed in liquid state. The effect of squeeze pressure proves the advisability of continuing the application of various liquid-phase methods using external pressure to improve the properties of castings produced.

Słowa kluczowe

PL

prasowanie stopu; stop AlSi9Mg

EN

squeeze casting; AlSi9Mg

• Czasopismo: Archives of Foundry Engineering
• Rocznik: 2011
• Tom: Vol. 11, iss. 3
• Strony: 55-60
• Opis fizyczny: Bibliogr. 11 poz., rys., tab., wykr.

Twórcy

autor

Reguła, T.

autor

Sobczak, J. J.

autor

Fajkiel, A.

autor

Dudek, P.

• Foundry Research Institute, Zakopianska 73, 30-418 Kraków, Poland,

Bibliografia

• [1] Górny Z., Sobczak J. J., Non-ferrous Metals based Novel Materials in Foundry Practice, Cracow 2005.
• [2] Pietrowski S., Siluminy, Lodz University of Technology,. Press, Łódź, 2001.
• [3] Joseph R., Davis J. R., Davis & Associates. Aluminium and Aluminium Alloys. ASM International, Materials Park, OH, 1993.
• [4] Dobrzański L. A., Reimann Ł., Krawczyk G, Influence of the ageing on mechanical properties of the aluminium alloy AlSi9Mg. Archives of Materials Science and Engineering Volume 31, Issue 1, May 2008.
• [5] Tan J., Hou W., Heat treatment process of AlSi9Mg alloy produced by rheo-diecasting. Transactions of Materials and Heat Treatment, Issue 12, 2010.
• [6] Selivorstov V., Dotsenko Y., Borodianskiy K., Kossenko A., Zinigrad M., Al-Si alloys structure formation using gaso-dynamic modification. Seventh Russian-Israeli Bi-National Workshop 2008.
• [7] Sobczak J. J., Teoretical and Practical Backgrounds of Squeeze Casting of Non-ferrous Metals. Transactions of the Foundry Research Institute,Special Issuer 41, Cracow, 1993.
• [8] Drouzy M., Jacob S., Richard M., Interpretation of tensile results by means of quality index and probable yield strength, AFS Int. Cast Metals Journal, 5, 1980.
• [9] Ghomashchi, M. R., Vikhrov, A., Squeeze casting: an overview. J. Mater. Process. Technol. 101, 2000.
• [10] Franklin J. R., Das A. A., Squeeze casting-a review of the status. British Foundryman 77, 1984.
• [11] Allison C. R., Ph.D. Thesis. University of Cincinnati. 1969.