Wyniki wyszukiwania - BazTech

Ograniczanie wyników

1 Bulletin of the Polish Academy of Sciences. Technical Sciences

1 2020

Znaleziono wyników: 1

Liczba wyników na stronie

Wyniki wyszukiwania

Sortuj według:

Ogranicz wyniki do:

Machining of microholes in Ti-6Al-4V by hybrid micro electrical discharge machining to improve process parameters and flushing properties

Mugilan T., Aezhisai Vallavi M. S., Santhosh S., Sugumar D., Christopher Ezhil Singh S.

Bulletin of the Polish Academy of Sciences. Technical Sciences

2020

Vol. 68, nr 3

565--573

In this research work, the Ti-6Al-4V material was used for the investigation of machining parameters by means of hybrid micro electrical discharge machining to improve the machining process and reduce the negative effects of debris accumulation in the drilled hole. L9 orthogonal array was used in the Taguchi based grey relational analysis to optimize the parameters such as material removal rate and diametrical accuracy of the machining process for Ti-6Al-4V. This work encompasses the design, development, and calibration of the work piece vibration platform and experimental analysis of the process parameters by means of the hybrid micro electrical discharge machining process. The maximum material removal rate and minimum surface roughness was observed at the current value of 2.5 A, pulse on time is 2 μs and pulse off time is 14.5 μs. The maximum material removal rate was observed for the increase in pulse on time with 14.4 μs and 4 A current level. The diametrical accuracy of the microholes was increased while increasing the pulse off time and decreasing the pulse on time. The fluid flow simulation has been conducted to find out the pressure drop and to know the velocity of the flow inside the hole for the effective flushing of the debris during machining.