Wyniki wyszukiwania - BazTech

Ograniczanie wyników

1 Archives of Materials Science and Engineering

1 2008

Znaleziono wyników: 1

Liczba wyników na stronie

Wyniki wyszukiwania

Sortuj według:

Ogranicz wyniki do:

Grooved roll for a high speed twin roll caster

Haga T., Hirooka K., Watari H., Kumai S.

Archives of Materials Science and Engineering

2008

Vol. 30, nr 2

117-120

Purpose: Purpose of this paper is investigation of the effect of roll-surface on the strip-surface. Improvement of small cracks on the strip-surface was tried and effect of groove at the roll surface on the strip surface was shown. Design/methodology/approach: Method used in the present study was high speed twin roll caster with grooved roll. Two kinds of grooves were used: one was parallel groove and the other was cross groove machined by knurling and bite attached to a lathe. Findings: Findings of this research are that grooved roll was effective to eliminate the small cracks on the strip surface. The contact condition between the roll and the melt became uniform by the small groove on the roll surface. Contact area became small, and heat transfer between the melt and roll became small, too. As the result, chill structure did not become columnar, and crack did not occur. Groove pattern on the strip surface could be erased by the cold rolling. Research limitations/implications: Research limitation is that groove life could not be investigated. Practical implications: Practical implications are as below. The roll load was small and strip was not hot-rolled in a high speed twin roll caster. The grooved roll made strip-surface sound. Grooved 600mm width roll was tested, and usefulness of the grooved roll was shown. Originality/value: In the present study effect of the grooved roll on a high speed twin roll caster was investigated.