Článek se zabývá měřením aktivity kyslíku litiny s kuličkovitým grafitem. Pro měření aktivity kyslíku byly použity kombinované termosondy (TERMOSONDY Kladno TSO-FS), které byly vyvinuty pro měření nízkého obsahu aktivity kyslíku. V rámci experimentů byla sledována aktivita kyslíku před a po modifikaci taveniny litiny. K výpočtu aktivity kyslíku byla použita rovnice ČSAV Ostrava a rovnice uváděná firmou ELECTRO-NITE.
EN
The article deals with measurements of oxygen activity ductile iron. The methodology of the oxygen activity measurement using TERMOSONDY Kladno TSO-FS (combined) sensors was developed at the Department of Engineering Technology of the Technical University of Liberec. The sensors were originally assigned for very low oxygen activity measured in molted steel. The EMF and the temperature are sensor’s output parameters used for oxygen activity calculation. Measured data are processed by the computer and results are displayed on the screen. All the results are saved in computer’s memory together with the time of measurement. Oxygen activity is calculated using two formulas (ČSAV Ostrava and Electro Nite c.o.) at the time. The oxygen activity measurement proved, that oxygen activity in molted iron depends on technology of melting, chemical composition and temperature of the melt.
2
Dostęp do pełnego tekstu na zewnętrznej witrynie WWW
The article deals with measurements of linear changes of castings from foliated graphite cast iron and Al-alloys during their solidification. For this purpose the measuring apparatus, which applies a dilatometer of Polish provenience, was built up. Dilatation curves of graphite cast iron and Al-alloys were acquired during the casting process. In the case of Al-alloys the influence of chemical composition and metallurgical treatment (use of refining salts) on linear changes during solidification and on the dimension of shrinkage originating was observed.
PL
Artykuł dotyczy pomiarów zmian liniowych wymiarów odlewów z żeliwa szarego i stopów aluminium podczas krzepnięcia. Do tego celu zbudowano aparaturę pomiarową zawierającą dylatometr skonstruowany w Polsce. Krzywe dylatacyjne żeliwa szarego i stopów aluminium wyznaczane były w trakcie procesu odlewania. W przypadku stopów aluminium zaobserwowano wpływ składu chemicznego i obróbki metalurgicznej (użycie soli rafinujących) na liniowe zmiany podczas krzepnięcia i na rozmiar skurczu.
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.