Wyniki wyszukiwania - BazTech

Ograniczanie wyników

2 Archives of Metallurgy and Materials

2 2017

Powiadomienia systemowe

Sesja wygasła!

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Sortuj według:

Ogranicz wyniki do:

Review on Parameters Influencing the Rice Breakage and Rubber Roll Wear in Sheller

Prabhakaran P., Ranganathan R., Muthu Kumar V., Rajasekar R., Devakumar L., Pal S. K.

Archives of Metallurgy and Materials

2017

Vol. 62, iss. 3

1875--1880

The present review deals with parameters influencing the rice breakage during rice milling operations and the effect of rubber roll Sheller in rice husk removal process. The main objective of rice milling system is to remove the husk and bran layer to produce the white rice. In this process, rubber roll sheller is used to remove husk from the grains by friction process. If the rubber material is too soft, there may not be sufficient shear force to husk the paddy. Wear will be minimum for rubber material with high hardness but indeed it pronounce the breakage of rice. Hence, for efficient husking the rubber roll material should possess the balance of physico-mechanical properties. Rice breakage depends on several other parameters like the type of harvest, drying temperature, drying methods, physical characteristics of paddy, husking characteristics, paddy moisture content, rubber roller speed, rubber roll pressure, paddy feed rate and fissures. Rubber roll wear depends on the type of rubber material attached to the roller, feed rate, roller speed, pressure etc.

Experimental Analysis of Nitrogen as an Alloying Element in WC9 Grade Steel

Vishnuh V., Sudhakar S., Tamilarasu K., Prabhakaran P., Rajasekar R.

Archives of Metallurgy and Materials

2017

Vol. 62, iss. 3

1889--1894

In the present work the effect of nitrogen on WC9 alloy at various weight percentages was analyzed and tested for their microstructural and mechanical properties. The nitrogen was added at 0.05, 0.10, 0.15, 0.20 and 0.25 wt. % in the solid form as nitrided ferrochrome to WC9 alloy. The samples were heat treated by solution annealing process at a temperature of 1100°C for 5 hours to improve the austenitic formation. Microstructures and mechanical properties such as tensile strength, yield strength, hardness, % elongation and % reduction of WC9-N alloy were examined. It was observed that increasing nitrogen wt. % increases the mechanical properties. The obtained mechanical properties were compared with base WC9 and C12A grade steel, where it was found to be replacement for C12A grade steel at its composition at lower end. The material cost analysis for WC9-N and C12A grade steel was done and both were compared.