Wyniki wyszukiwania - BazTech

Ograniczanie wyników

2 2022

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Sortuj według:

Ogranicz wyniki do:

Design of a manipulator of a conveyor for bulk materials – calculation of the center of gravity of the conveyor

Blatnický Miroslav, Dižo Ján, Molnár Denis, Droździel Paweł

Zeszyty Naukowe. Transport / Politechnika Śląska

2022

z. 117

43--56

The predominant goal of the research presented in this paper is the design of a manipulator for a conveyor of bulk materials based on the given requirements. This issue is an emerging topical one mainly for the reasons of increasing efficiency and speed, as well as the safety of maintenance of machines and equipment. Especially, another essential aspect is the reduction of the physical strain on operators during service operations on the conveyor of bulk materials. The introductory part of this paper attends to the materials used for the production of steel structures, their technological processing, as well as different types of joining of their components. The practical part was set out to ascertain the mass and position of the center of gravity of the load itself – the conveyor. From the perspective of acting, it loads the entire proposed structure, although in different operating modes.

Structural design of a boom mounting of a mast type jib crane for handling sludge pumps

Molnár Denis, Blatnický Miroslav, Dižo Ján, Ishchuk Vadym

Journal of Mechanical and Energy Engineering

2022

Vol. 6, No 2

1--6

The paper is a continuation of the issue of the technical solution of a mast type jib crane for handling sludge pumps. It serves for the use in Building no. 900, Block V2, of the nuclear power plant Jaslovské Bohunice. It is an optimization of the original, in-service damaged handling device with manual control of lift and rotation. The overloading of the device has an insignificant effect on the lifting force on a crank handle. It was found that the lifting force permanently falls within the recommended range of 120 to 160 N for convenient operation by a single worker. Inasmuch as there is a complete absence of bearings in the slewing gear in the original design, it is the solution to this issue that is the subject of the paper. The problem of pulling out the sludge pumps, which was established in the course of using the jib crane, ingeniously provided the opportunities to further design changes on the original design. The solution offered was to scrap the original design of the carrier inserted into the support and replace it with a fixed mast on which the boom would rotate. Accordingly, it would potentially be feasible to increase the load capacity of the jib crane, and thus the issue of the sludge pumps attached to the tank bottom would be solved. Moreover, it is attainable to extend the scope of this crane in this way.