Wyniki wyszukiwania - BazTech

Ograniczanie wyników

2 Archives of Foundry Engineering

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Wyszukiwano:
w słowach kluczowych: stop Al-Si-Mg

Sortuj według:

Ogranicz wyniki do:

Reducing the Negative of the Iron in the Alloy Based on Al-Si-Mg by Manganese

Podprocka R., Bolibruchova D., Chalupova M.

Archives of Foundry Engineering

2017

Vol. 17, iss. 2

212--216

In Al-Si alloy the iron is the most common impurity and with presence of other elements in alloy creates the intermetallic compounds, which decreases mechanical properties and increases of porosity. The cause of the negative effect of intermetallic particles on the mechanical properties is that it is more easily break off the tension load as the aluminium matrix or small particles of silicon. By adding suitable alloying elements, also known as iron correctors, is possible to reduce this harmful effect. In the article is evaluated influence of manganese on microstructure with performed EDX analysis selected intermetallic phases and tensile test and measurement of length of Al5FeSi phase. For realization experiments was used AlSi7Mg0.3 alloy with increased iron content. Manganese was added in the amount 0.3 wt. %, 0.6 wt. %, 0.8 wt.% and 1,2 wt. %. From performed measurements it has been concluded, that increased amount of manganese, i.e. Mn/Fe ratio, does not have significant influence on mechanical properties AlSi7Mg0.3 alloy in the melted state.

Influence of Cooling Rate on Intergranular Corrosion in Al-Si7-Mg Alloy

Bernat L.

Archives of Foundry Engineering

2015

Vol. 15, iss. 3 spec.

107--111

The use of aluminium cast alloys in automotive industry results from a tendency to considerably lower vehicle mass. Subject to working conditions, silumin casts may show occurrence of intergranular corrosion that reduces mechanical properties of the parts produced. The paper presents the influence of cooling rate – R of a plate cast of aluminium alloy EN AC-AlSi7Mg0,3 on the depth of appearance of intergranular corrosion. Samples were exposed to corrosive medium by immersion for 2,5; 12; 24 and 48 hours in an aqueous solution of NaCl+HCl+H2O. The study demonstrated that cooling rate – R and subsurface porosity significantly influence on distribution and depth of intergranular corrosion in casts of subeutectic silumin.