Preferencje help
Widoczny [Schowaj] Abstrakt
Liczba wyników

Znaleziono wyników: 2

Liczba wyników na stronie
first rewind previous Strona / 1 next fast forward last
Wyniki wyszukiwania
Wyszukiwano:
w słowach kluczowych:  stimulated Raman scattering
help Sortuj według:

help Ogranicz wyniki do:
first rewind previous Strona / 1 next fast forward last
EN
This article presents an experimental investigation of polarization pulling based on stimulated Raman scattering induced by a continuous, fully polarized pump wave in an optical fibre. By means of probe wave states of polarization aggregation, degree of polarization and gain analysis, an assessment of all-optical polarization control, repolarization and amplification in a standard single mode fibre in depleted pump regime is presented. Polarization pulling is proved to be dependent on fibre length, pump power, and pump state of polarization, with respect to pump depletion effect, acting oppositely to the polarization pulling effect. Authors evaluate results aiming to obtain a configuration of stimulated Raman scattering parameters, which allows for the most effective polarization pulling, with respect to statistical stability of the process measured by standard deviation of polarization degree and polarization-dependent gain of the probe wave. The highest polarization attraction efficiency was obtained for 15 km, 0.97 W and the horizontal polarization state of the pump wave.
EN
A 100 km long dense wavelength division multiplexed optical network design with a capacity of 1.28 Tbps is proposed in this paper. The novelty of this work is the use of a dispersion compensating fibre as a Raman amplifier in the S-band for a high-capacity dense wavelength division multiplexing network. The transmission is accomplished auspiciously in the wavelength range from 196 THz to 202. 35THz. The coupling of a Raman amplifier made the realisation of the S-band possible in the network, as the erbium-doped fibre amplifier is competent for amplification in C- and L-bands only. Further, a pump coupler is used for multiple pumping to enlarge the gain spectrum for a high-capacity optical network. The performance analysis of the network is carried out systematically in terms of bit error rate (BER), eye diagram, Q-factor, and optical signal to noise ratio (OSNR). The results demonstrate that the proposed set-up shows adequately low BER, sufficient Q-factor values, wide eye-opening, and commendable OSNR for all receiving channels.
first rewind previous Strona / 1 next fast forward last
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.