Preferencje help
Widoczny [Schowaj] Abstrakt
Liczba wyników
Powiadomienia systemowe
  • Sesja wygasła!
  • Sesja wygasła!
  • Sesja wygasła!

Znaleziono wyników: 7

Liczba wyników na stronie
first rewind previous Strona / 1 next fast forward last
Wyniki wyszukiwania
Wyszukiwano:
w słowach kluczowych:  obrzęk
help Sortuj według:

help Ogranicz wyniki do:
first rewind previous Strona / 1 next fast forward last
EN
The paper presents the issue of geological-engineering evaluation of ability to volume changes in Mio-Plioceneclays from the area of Budy Mszczonowskie. It has been stated that these clays are characterized by a high content ofclay fraction with beidellite as a dominant clay mineral. For the evaluation of expansiveness, both direct andindirect test methods are used. Expansive features, i.e. swelling pressure and swelling index, are presented in relation to initial moisture content.
2
Content available remote Stresses and Strains of Equipment Inside a WWER-1000 Nuclear Reactor
EN
The article concerns the modelling of stresses and strains of the enclosure of the active zone and chamber housing inside a WWER-1000 reactor, taking into consideration welding, heat treatment and the operation of the structure in the conditions of intense radiation. The work presents the input of welding internal stresses and contact stresses into the total stress of the chamber housing inside the reactor vessel. The article-related research involved testing the relaxation of welding internal stresses in the active zone enclosure caused by radiation creep.
PL
Artykuł dotyczy modelowania stanu naprężenia i odkształcenia ogrodzenia strefy aktywnej i szybu komory wewnątrz korpusu reaktora WWER-1000, z uwzględnieniem spawania, obróbki cieplnej oraz eksploatacji konstrukcji w warunkach intensywnego napromieniowania. Określono wkład spawalniczych naprężeń własnych i stykowych w całkowity stan naprężenia szybu komory wewnątrz korpusu reaktora. Zbadano relaksację spawalniczych naprężeń własnych w ogrodzeniu strefy aktywnej wskutek pełzania radiacyjnego.
3
Content available remote Clay minerals – mineralogy and phenomenon of clay swelling in oil & sas industry
EN
Among the minerals found in the earth's crust, clay minerals are of the widest interest. Due to the specific properties such as plasticity, absorbing and catalytic properties clay minerals are used in many industries (oil & gas, chemistry, pharmacy, refractory technology, ceramics etc.). In drilling, a phenomenon of swelling clays is frequently observed. It has an important impact on the cementing quality. During the last few decades clays have been the subject of research on a scale unprecedented in the history of mineralogy. This paper presents review literature on mineralogy of clay minerals and phenomenon of swelling in oil and gas industry. Unique ion exchange properties and clay swelling mechanisms are also considered.
EN
Chemically and physically crosslinked chitosan hydrogels were obtained by treating chitosan (Ch) with glutaraldehyde (GA) and sodium tripolyphosphate or GA and sodium citrate, GA and sulfuric acid and GA and sulfosuccinic acid, respectively. The formation of covalent and ionic crosslinks between Ch, GA and low molecular ionic compounds was confirmed by FTIR spectroscopy. There was examined the equilibrium degree of swelling of membranes formed from uncrosslinked and crosslinked chitosan hydrogels in buffer solutions of different pH. It was observed that the swelling of all studied membranes was highly dependent on pH.
EN
Two- and three-component chitosan membranes (Ch) crosslinked with sodium tripolyphosphate (TPP) and/or sodium alginate (NaAlg) were prepared. Formation of ionic crosslinks between Ch and high-molecular compound - NaAlg and/or low-molecular - TPP was confirmed by FTIR spectroscopy. The effcct of crosslinking agents on membrane swelling in extracellular Hanks' buffer was estimated. The obtained results allow to state, that ionic crosslinking of chitosan results in increase of membrane stability in extracellular media. However, only TPP crosslinkcd chitosan membranes are not soluble in Hanks' buffer.
6
Content available remote Swelling Behaviour of Cellulosic Fibres. Part 1, Changes in Physical Properties
EN
The swelling and dissolving properties of textile materials are characterised in cotton and regenerated cellulosic fibres of lyocell and viscose (NMMO- and xanthogenate-type). The swelling, fractionation and dissolution mechanisms and their effect on polysaccharide substrate were studied with different solutions, while applying setting treatment. The differences in physical properties before and after treatment were followed by changes in diameter, mass loss and WRV (water regain).
PL
Przedstawiono pęcznienie i odporność na rozpuszczanie materiałów tekstylnych, takich jak włókna bawełniane, z regenerowanej celulozy (typu lyocell) i wiskozowe (oparte na NMMO i ksantogenianie). Mechanizmy pęcznienia frakcjonalizacji i rozpuszczania oraz ich wpływ na substancję polisacharydową zostały przeanalizowane uwzględniając różne rozpuszczalniki i zastosowane procedury. Różnice w właściwościach fizycznych włókien przed i po obróbce analizowano biorąc pod uwagę zmiany średnicy włókien, stratę masy i retencję wody (WRV).
EN
The effect of interfibrillar swelling on swelling degree, carboxyl content, split number, weight loss and dyeing properties by using NaOH solution up to 2.5 M concentration of lyocell fibres was investigated. The Split number and weight loss show the behaviour of fibres during alkali treatment, whereas the water retention value (WRV), carboxyl content and dyeing give information about the properties of samples after alkali treatment. By increasing alkali concentration, the swelling degree, weight loss, split number, total colour difference and K/S values of fibres increased when compared to untreated samples; on the other hand carboxyl content decreased.
PL
Badano wpływ międzyfibrylarnego pęcznienia na stopień spęcznienia, zawartość grup karboksylowych, liczbę rozszczepień, stratę masy i właściwości barwienia przy stosowaniu roztworów NaOH o stężeniu do 2.5 M do obróbki włókien typu Lyocell. Liczba rozszczepień i strata masy charakteryzują zachowanie się włókien podczas obróbki alkaliczne, podczas gdy wartość retencji wody i zawartość grup karboksyloeyvj, jak również barwienie dostarczają informacji o właściwościach próbki po obróbce alkalicznej. Przy wzroście stężenia alkalii, wzrastały również stopień spęcznienia, strata masy, liczba rozszczepień, całkowita różnica wybarwienia i wartość K/S obrabianych włókien, w stosunku do próbek nie obrabianych, natomiast ilość grup karboksylowych zmniejszała się.
first rewind previous Strona / 1 next fast forward last
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.