Wyniki wyszukiwania - BazTech

Ograniczanie wyników

2 2017

Powiadomienia systemowe

Sesja wygasła!

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Wyszukiwano:
w słowach kluczowych: multicomponent Al-Si alloys

Sortuj według:

Ogranicz wyniki do:

Hypoeutectic Al-Si Alloy Doped with Chromium, Tungsten and Molybdenum Designated for Pressure Die Casting

Szymczak T., Gumienny G., Kurowska B., Pacyniak T.

Archives of Metallurgy and Materials

2017

Vol. 62, iss. 3

1629--1635

Structural modification of hypoeutectic Al-Si alloy EN-AC 46000 alloy influences its microstructure and mechanical properties. In a series of examinations the EN-AC 46000 alloy has been doped with Cr, W and Mo. The study involved the differential thermal analysis (DTA) and the light microscopy structural analysis of the samples cut from pressure die castings and from samples cast into the DTA cup. The DTA and microstructure analyses revealed new phases in the alloy doped with mentioned additives. The strength properties measurements of the alloys doped with Cr, W and Mo showed significant improvement in tensile strength and elongation, while preserving good hardness.

Hypoeutectic Al-Si Alloy with Cr, V and Mo to Pressure Die Casting

Szymczak T., Gumienny G., Stasiak I., Pacyniak T.

Archives of Foundry Engineering

2017

Vol. 17, iss. 1

153--156

This paper presents the results of hypoeutectic 226 grade alloy as well as prepared on its basis Al-Si alloy containing Cr, V and Mo. The additives tested were added as AlCr15, AlV10 and AlMo8 master alloys. Alloys tested were poured into DTA sampler as well as using pressure die casting. An amount of Cr, V and Mo additives in alloy poured into DTA sampler comprised within the range approximately 0.05-0.35%. Alloys to pressure die casting contained 0.05-0.20% Cr, V and Mo. The crystallization process was examined using the derivative thermal analysis (DTA). The microstructure of castings made in the DTA sampler as well as castings made with use of pressure die casting were examined. The basic mechanical properties of castings made using pressure die casting were defined too. It has been shown in the DTA curves of Al-Si alloy containing approximately 0.30 and 0.35% Cr, Mo, and V there is an additional thermal effect probably caused by a peritectic crystallization of intermetallic phases containing the aforementioned additives. These phases have a morphology similar to the walled and a relatively large size. The analogous phases also occur in pressure die casting alloys containing 0.10% or more additions of Cr, V and Mo. The appearance of these phases in pressure die casting Al-Si alloys coincides with a decrease in the value of the tensile strength Rm and the elongation A. It has been shown die castings made of Al-Si alloys containing the aforementioned additives have a higher Rm and A than 226 alloy.