Wyniki wyszukiwania - BazTech

Ograniczanie wyników

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Wyszukiwano:
w słowach kluczowych: injector operating parameters

Sortuj według:

Ogranicz wyniki do:

The impact of alcohol admixture with gasoline on carbon build-up and fuel injectors performance

Stępień Zbigniew, Pielecha Ireneusz, Cieslik Wojciech, Szwajca Filip

Eksploatacja i Niezawodność

2022

Vol. 24, no. 2

226--236

The operating conditions of injectors in spark ignition engines with direct fuel injection make them susceptible to coking, which leads to a reduced quality of fuel atomization. This can be observed by a drop in performance and an increase in exhaust emissions, especially particulate matter. One effective method of reducing injector coking is by using detergentdispersing gasoline additives. The article describes the effect of using an admixture with a varied alcohol content on the quantitative and qualitative fuel atomization indicators. The research consisted of a 48-hour engine test, done in accordance with the CEC F-113-KC procedure (CEC-F-113 test). After each test cycle, the injectors underwent optical tests with the use of an isochoric chamber. The spray penetration and surface area were analyzed at a set of different fuel injection parameter values. The research performed resulted in determining the influence of each tested admixture on the change of injection time and on the geometric indicators of the fuel spray. The obtained characteristics of the engine in operation and conducted stationary tests enabled the operational evaluation of the impact an alcohol admixture with gasoline fuels had on key engine parameters.

Analysis of research possibilities of fuel unit injectors

Osipowicz T., Gołębiewski W.

Journal of KONES

2016

Vol. 23, No. 3

381--388

Article discusses issues concerning diagnosing and researching fuel unit injectors (UI). This fuel system has been taken off in automobiles but the problems with diagnosing and research is still actually. Motorized vehicles with fuel unit injector system were manufactured until 2010 but lorries are still producing. Only one automotive concern VW put in this system to motorized vehicles in Europe. The 1.9 TDI engines have PDE 1 (UI) and 1.4 TDI, 2.0 TDI engines have PDE 2 (UI). Unit injector is device which main tasks are spray and distribute fuel in combustion chamber of Diesel engine. Unit fuel injector is built with three sections: fuel injection nozzle complex, electromagnet unit and pump part. Injection nozzle complex is common mechanical one spring injector. That research is on check and eventually adjusts open pressure. Electromagnet units are non-dismantle and non-repair, but there is possibility dismantle and clean it. Electromagnet unit affects injection dosages and module BIP (being of injection period) unit fuel injection. The task of pump part is fuel damming until demanding values. The pump part makes up piston with and main body, spring and protect flat piece of metal. Theoretically, also this element is non-repair. Main unit fuel injector work parameters are injection dosages values and signal BIP. During fuel unit injectors research checks injection dosages with varies settings (rotation speed, injection time). These parameters are similar to engine work on idle speed (idle speed dosage), pilot dosage, middle and full load dosage.