Wyniki wyszukiwania - BazTech

Ograniczanie wyników

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Wyszukiwano:
w słowach kluczowych: ignition lag

Sortuj według:

Ogranicz wyniki do:

Zwłoka samozapłonu paliwa w nieustalonych warunkach pracy silnika o zapłonie samoczynnym

Longwic R., Lotko W., Sander P.

TTS Technika Transportu Szynowego

2013

R. 20, nr 10

3541--3552

W artykule przedstawiono wyniki badań silnika o zapłonie samoczynnym w warunkach swobodnego rozpędzania. Przeanalizowano w szczególności powody wzrostu kąta zwłoki samozapłonu paliwa w warunkach swobodnego rozpędzania w stosunku do porównywalnych warunków statycznych. Na podstawie uzyskanych wyników badań zbudowano modele regresyjne.

In the paper gives the results of research of Diesel engine in the transient operations conditions. Examined in particular the reasons for the increase in the angle of ignition lag in transient operating conditions to comparable conditions. On the basis of the obtained results of regression models were built.

Analysis of combustion processes in ci engine fuelled either with diesel fuel or rape oil methyl ester and additionally with ethanol

Kowalewicz A.

Journal of KONES

2006

Vol. 13, No. 2

225-240

At the conference KONES’2005 combustion characteristics of CI engine fuelled with rape oil methyl ester (RME) and ethanol injected into inlet port have been presented. In this paper combustion processes in the engine fuelled with two base fuels: diesel oil (DF) or rapeseed oil methyl ester and additionally with ethanol have been analyzed and combustion parameters have been compared. Ethanol fraction has a serious influence on combustion. Addition of ethanol delays combustion in the initial stage but despite of that, combustion is completed earlier if the ethanol fraction is higher. This phenomenon takes place for both base fuels: RME and DF. However, for high speed (2200 rpm) and torque = 20 Nm (pe= 0,256 MPa) ignition delay of DF was so long, that ignition took place 15 CA deg ATDC. Nevertheless of that, combustion was completed only about 5 CA deg later than for neat DF. Combustion processes for both fuels are similar, but there are some differences in ignition delay. At low load and high speed for fuelling with DF combustion extends for exhaust stoke. On account on diesel – knock the engine can not be loaded by higher torque at high speed. Besides ethanol fraction, there is a strong influence of load and speed on combustion parameters. Generally increase of speed decreases maximum pressure and increase of load increases it, as well for RME as for DF. The highest pressure has been measured for DF and ethanol injection.