Wyniki wyszukiwania - BazTech

Ograniczanie wyników

Powiadomienia systemowe

Sesja wygasła!

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Wyszukiwano:
w słowach kluczowych: diamond cutting tools

Sortuj według:

Ogranicz wyniki do:

Effect of Post-Heat Treatment on Microstructure and Mechanical Properties of Cu-Fe-Co Powder Alloy Fabricated by Hot Pressing

Çelik E., Aslan A. K.

Archives of Metallurgy and Materials

2018

Vol. 63, iss. 1

371--377

In this study, the powder mixture which consists of Cu-Fe-Co was produced by using the method of hot pressing technique. In addition, effect of heat treatment process on microstructure and mechanical properties of this alloy was investigated. Following the hot pressing process applied on the samples, heat treatment was carried out at 950°C for two different dwelling times (90 and 180 minutes). Measured density values were considered as physical characteristics, while hardness and fracture strength values were considered as mechanical characteristics. It was observed that porosity rates of hot pressed samples were decreased by increasing of temperature and pressing parameters. In this study it was observed that Cu was spread in matrix and filled the micro porosities. Hardness values were determined to be decreased as a result of grain growth after heat treatment process. That 4 fold increased elongation % values which were achieved by TRS experiments were observed as well.

The comparison of the sintering methods for diamond cutting tools

Bulut B., Tazegul O., Baydogan M., Kayali E. S.

Journal of Achievements in Materials and Manufacturing Engineering

2016

Vol. 76, nr 1

30--35

Purpose: Aim of this study is to compare mechanical, physical, microstructural properties of diamond cutting tools (DCTs) made of Co-Ni-Cu-Sn matrix, produced by Spark Plasma Sintering (SPS) and Conventional Sintering (CS) methods. The main reason for this research is choosing the most convenient and economically manufacturing method for diamond cutting tools. Design/methodology/approach: Aim of this study is to compare mechanical, physical, microstructural properties of diamond cutting tools (DCTs) made of Co-Ni-Cu-Sn matrix, produced by Spark Plasma Sintering (SPS) and Conventional Sintering (CS) methods. The main reason for this research is choosing the most convenient and economically manufacturing method for diamond cutting tools. Findings: The results showed that, the density values of the samples which are produced two different sintering methods are similar. However, the mechanical and microstructure properties of the samples which are produced by SPS method are decent. The robust mechanical properties were obtained at SPS method than CS method. Practical implications: Powder metallurgy is the most common method because of forming new diamond grains due to wearing of matrix. In powder metallurgy, Conventional Sintering (CS) and Spark Plasma Sintering (SPS) are used at DCTs production prevalently. SPS is a short and effective way to produce diamond tools but costs are higher and production capacity is lower than conventional sintering method. Originality/value: This paper demonstrates that the sintering methods can effect the cutting performances of the DCTs. The samples which are produced with CS method had elevated cutting performance on-site field tests.