Wyniki wyszukiwania - BazTech

1

Investigation of nickel adsorption onto low Jordanian zeolite dose: efficiency and Langmuir – Freundlich behaviour

Al-Ghazawi Ziad, Qasaimeh Ahmad, Al-Bataina Bilal

Journal of Water and Land Development

|

2021

|

no. 50

150--157

EN

In this work, nickel adsorption onto low Jordanian zeolite dose is being investigated. Natural zeolite doses were stirred continuously with nickel solutions in batch reactors at 180 RPM for 24 hours, where the temperature was set to 20°C. The pH was initially 4.5 and reached 5.2 at equilibrium. The removal efficiency of nickel reaches maximum value when the initial nickel concentration is around 1 ppm and then tends to decrease when the initial nickel concentration increases above 1 ppm. The optimal nickel removal reaches 65% when the initial nickel concentration is 1 ppm and the zeolite dose is 26 mg∙dm–3. This study investigates the behaviour of nickel removal and modelling isotherms below and above this critical peak point. At this level of zeolite dose, the adsorption does not follow either Freundlich or Langmuir isotherms, but rather, it follows Freundlich for the data plot just below the peak point with the highest coefficient of determination (R2) equals (0.98) when the zeolite dose is (26 mg∙dm–3), whereas it follows Langmuir for the data plot just above the peak point with the highest coefficient of determination (R2) equals (0.99) when the zeolite dose is (10 mg∙dm–3). These findings clarify the theory behind each isotherm and can be used to find new information for efficient treatment techniques.

2

Langmuir isotherm models applied to the sorption of acid dyes from effluent onto polyamide nanofibers

Wang Y., Wiener J., Zhu G.

Autex Research Journal

|

2013

|

Vol. 13, no. 3

95--98

EN

The ability of polyamide 6 nanofibers membrane (P6NM) to remove acid dyes from effluent solution by adsorption has been studied. Equilibrium isotherms for the adsorption of three acid dyes, Acid blue 41 (AB41), Acid blue 78 (AB78), and Acid yellow 42 (AY42), on P6NM were measured experimentally. Simulated wastewater of acid dyes with the concentration of 10 mg/L for sorption process electrospun polyamide 6 with mass per unit area 12 g/m2 was used as the sorbent material. Ten sets of P6NM were dipped in separate simulated effluent. The weight of the original P6NM and the concentration of left solution were detected. Results were analyzed by the Langmuir equation using a linearized correlation coefficient. And it showed that all the dyes tested could follow the Langmuir adsorption isotherm, which gave excellent correlation for all the dyes.

3

Comparative studies on the removal of copper (II) by Ulva fasciata activated carbon and commercially activated carbon

Suresh Jeyakumar R.P., Chandrasekaran V.

Polish Journal of Chemical Technology

|

2012

|

Vol. 14, nr 4

88-94

EN

In this work, the efficiency of Ulva fasciata sp. activated carbons (CCUC, SCUC and SSUC) and commercially activated carbon (CAC) were studied for the removal of Cu (II) ions from synthetic wastewater. Batch adsorption experiments were carried out as a function of pH, contact time, initial copper concentration and adsorbent dose. The percentage adsorption of copper by CCUC, SSUC, SCUC and CAC are 88.47%, 97.53%, 95.78% and 77.42% respectively. Adsorption data were fitted with the Langmuir, Freundlich and Temkin models. Two kinetic models pseudo first order and the pseudo second order were selected to interpret the adsorption data.