Wyniki wyszukiwania - BazTech

Ograniczanie wyników

2 2024

Znaleziono wyników: 2

Liczba wyników na stronie

Wyniki wyszukiwania

Sortuj według:

Ogranicz wyniki do:

Stabilization of Slopes Vulnerable to Landslides Trough Tubular Anchors

Mataradze Edgar, Chikhradze Nikoloz, Akhvlediani Tamaz

Inżynieria Mineralna

2024

Vol. 1, no. 1

379--384

This paper presents an anchor of a new design, whose properties have been selected to retain the advantages of a tubular anchor over the other anchor types and at the same time, ensure its adaptation to specific conditions associated with slope stabilization. The proposed anchor consists of a steel tube filled with expanding cement mortar. The outer diameter of the tube is 2-3 mm less than the diameter of the borehole, a groove is cut on the outer surface of the tube. A metal rod is placed in the center of the tube at the outer end of which a support plate is installed, and a tie wrench is fixed. The length of the metal rod is equal to the depth of the bore hole, while the length of the steel tube is at least half the length of the borehole. In the process of solidification and expansion of the solution, pressure is created on the walls of the bore hole. Under the influence of pressure, the pipe is opened around the groove and close contact is achieved between the pipe and the borehole surfaces. As soon as the solution hardens, the steel tube is firmly embedded in the concrete, after which the anchor reaches operational capacity. Preliminary tests of the proposed anchor showed that it has a high clamping force (for hard rock conditions - 46-75 kN/m and for soft rock conditions 32-36 kN/m). He has other advantages, namely it does not require special equipment for installation, the inside of a tube is filled with hard concrete-like mass, which hampers the process of corrosion and increases shear strength.

Fabrication of Protective Composite Structures by Infusion Technology to Resist the Blast Wave

Chikhradze Nikoloz, Abashidze Guram, Tsverava Davit, Kvinikadze Sophiko

Inżynieria Mineralna

2024

Vol. 1, no. 1

287--292

The paper presents the results of experiments on the use of infusion of polymer binders into a pre-constructed skeleton of reinforcing structures. Currently, three-layer structures with an average layer of aluminum honeycombs are considered to be one of the effective structural elements that ensure the damping of the blast wave. As an alternative middle layer, it is possible to offer elements of various shapes (cylinders, cubes, etc.) and geometries made of modern composites that are well-proven under the impact of a shock wave. These are, as is known, metal-polymer composites, i.e. materials containing, in addition to polymer binder and fabric filler, thin layers of metal. In order to form a solid structure that perceives an explosive load, an attempt was made to use RFI technology to obtain individual elements with which two steel sheets are connected. Aramid, glass fabrics and aluminum thin (0.5, 0.15, 0.05 mm) plates were used in the experiments. For the implementation of the infusion process, an epoxy resin was used, suitable in its technological parameters for this process. The use of this resin leads to the minimization of non-nourished areas and pores. In this case, the uniformity of the product obtained from the composite material is achieved. It should be added that RFI technology differs from other polymer processing technologies in the following significant advantages: the possibility of abandoning expensive equipment, reducing energy costs for equipment and its maintenance, and complete rejection of the use of prepregs. However, there are a number of difficulties that are associated with the technological process of infusion, these primarily include the rheological requirements of the binder: at room temperature, the resin should have a low viscosity, and in the practice of fillers, the viscosity should have rather low values. Below are some preliminary plans for the development of this technology in order to obtain a product that provides attenuation of the blast wave.