Control system and measurements of coil actuators parameters for magnetomotive micropump concept

• Autorzy: Kolimas Ł. , Bieńkowski K. , Łapczyński S. , Szulborski M. , Kozarek Ł. , Birek K.

Identyfikatory

DOI

10.24425/bpasts.2020.134171

• Języki publikacji: EN

Abstrakty

EN

This paper presents an approach to the construction and measurements of electrodynamic and reluctance actuators. Executive elements were used as drives in a novel concept of a magnetomotive micropump. The paper discusses various aspects concerning the designation of parameters, control system, the explanation of physical phenomena, and the optimization of the basic elements for coil units. The conducted work describes the measurement system and the analysis of the derived values. The actuators were compared and the pros/cons of building the conceptual device were highlighted. The best solution to be used in the upcoming work concerning the construction of a magnetomotive micropump was chosen based on measurements, engineering aspects, layout control, and key parameters such as the piston velocity, energy stored in capacitors, and efficiencies.

Słowa kluczowe

EN

control system; micropump; electrodynamic induction; magnetic acceleration

• Wydawca: Polska Akademia Nauk, Wydział IV Nauk Technicznych
• Czasopismo: Bulletin of the Polish Academy of Sciences. Technical Sciences
• Rocznik: 2020
• Tom: Vol. 68, nr 4
• Strony: 893--901
• Opis fizyczny: Bibliogr. 22 poz., rys., tab.

Twórcy

autor

Kolimas Ł.

• Institute of Electrical Power Engineering, Warsaw University of Technology, 75 Koszykowa Street, 00-662 Warsaw, Poland

autor

Bieńkowski K.

• Astronika Sp. z o.o., 18 Bartycka Street, 00-716 Warsaw, Poland

autor

Łapczyński S.

• Institute of Electrical Power Engineering, Warsaw University of Technology, 75 Koszykowa Street, 00-662 Warsaw, Poland

autor

Szulborski M.

• Institute of Electrical Power Engineering, Warsaw University of Technology, 75 Koszykowa Street, 00-662 Warsaw, Poland

autor

Kozarek Ł.

• ILF Consulting Engineers sp. z o.o., 12 Osmańska Street, 02-823 Warsaw, Poland

autor

Birek K.

• ILF Consulting Engineers sp. z o.o., 12 Osmańska Street, 02-823 Warsaw, Poland

Bibliografia

• [1] W.F. Gauster, “Somerbasic concepts for magnet coil design”, Conference paper, Illionois, pp. 1–17, 1959.
• [2] J. Liu and T. Koseki, “3 degrees of freedom control of semi-zero-power magnetic levitation suitable for two-dimensional linear motor”, Proceedings of the Fifth International Conference on Electrical Machines and Systems, Shenyang, China, pp. 976 –981, 2001.
• [3] Y. An, G. Liu, P. Wang, H. Wen, and Z. Meng, “Magnetic force analysis and experiment of novel permanent magnet axial thrust balance structure in canned motor pump”, IEEE 2nd International Conference on Advanced Computer Control, Shenyang, China, vol. 1, pp. 1–8, 2010.
• [4] J. Cai and Y. Deng, “Initial Rotor Position Estimation and Sensorless Control of SRM Based on Coordinate Transformation”, IEEE Trans. Instrum. Meas. 64 (4), 1004–1018 (2015).
• [5] A. Masi, A. Danisi, R. Losito, and R. Perriard, “Characterization of magnetic immunity of an ironless inductive position sensor”, IEEE Sens. J. 13 (3), 941–948 (2013).
• [6] K. Yongdae, H.Y. Choi, and Y.CH. Lee, “Design and preliminary evaluation of high-temperature position sensors for aerospace applications”, IEEE Sens. J. 14 (11), 4018–4025 (2014).
• [7] F. Khoshnoud, and C.W. Silva, “Recent advances in MEMS sensor technology-mechanical applications”, IEEE Trans. Instrum. Meas. 15 (2), 14–24 (2012).
• [8] G. Loussert, “An Efficient and Optimal Moving Magnet Actuator for Active Vibration Control”, 15 th International Conference on New Actuators, Bremen, Germany, pp. 1390–1420, 2016.
• [9] C. Paulitsch, P. Gardonio, S.J. Elliott, P. Sas, and R. Boonen, “Design of a Lightweight, Electrodynamic, Inertial Actuator with Integrated Velocity Sensor for Active Vibration Control of a Thin Lightly-Damped Panel”, Proceedings of ISMA, pp. 239–251, 2004.
• [10] C. Paulitsch, P. Gardonio, and S.J. Elliott, “Active vibration damping using an interial, electrodynamic actuator”, J. Vib. Acoust. 129, 39-47 (2007).
• [11] X. Li, K. Tian, and Y. Zhou, “Linear Electromagnetic Oil Pumping Unit Based on the Principle of Coil Gun”, IEEE Conference, China, 2008.
• [12] P. Fang, F. Ding, and Q. Li, “Novel High-Response Electromagnetic Actuator for Electronic Engraving System”, IEEE Trans. Magn. 42 (3), 460–464 (2006).
• [13] Y. Nakanishi, T. Honda, K. Kasamura, Y. Nakashima, K. Nakano, K. Kondo, and H. Higaki, “Bio-inspired shaft seal in coolant pump for electric vehicles”, IEEE International Conference on Renewable Energy Research and Applications (ICRERA), 2016.
• [14] R.E. Clark, G.W. Jewell, S.J. Forrest, J. Rens, and J. Maerky, “Design Features for Enhancing the Performance of Electromagnetic Valve Actuation Systems”, IEEE Trans. Magn. 41 (3), 692–696 (2005).
• [15] H. Hoshi, T. Shinshi, and S. Takatani, “Third-generation blood pumps with mechanical noncontact magnetic bearings”, Artif. Organs 30 (5), 324–338 (2006).
• [16] J.F. Antaki, B. Paden, G. Burgreen, and N.J. Groom, “Blood pump having a magnetically suspended rotor”, US Patent, No: 6447266 B2, 2002.
• [17] J. Albert, R. Banucu, W. Hafla, and W.M. Rucker, “Simulation based development of a valve actuator for alternative drives using BEM-FEM code”, IEEE Trans. Magn. 45 (3), 1744–1747 (2009).
• [18] M.P. Goldowsky, “Magnetic suspension blood pump”, US Patent, No: 6527699 B1, 2003.
• [19] D. Elata, “On the static and dynamic response of electrostatic actuators”, Bull. Pol. Ac.: Tech. 53 (4), 373–384 (2005).
• [20] S.M. Yang and M.S. Huang, “Design and Implementation of a Magnetically Levitated Single- Axis Controlled Axial Blood Pump”, IEEE Trans. Ind. Electron. 56 (6), 2213–2219 (2009).
• [21] M.B. Khamesee and E. Shameli, “Pole piece effect on improvement of magnetic controllability for noncontact micromanipulation”, IEEE Trans. Magn. 43 (2), 533–542 (2007).
• [22] B. Ozdalyan and O. Dogan, “Effect of a semi electro-mechanical engine valve on performance and emissions in a single cylinder spark ignited engine”, J. Zhejiang Univ., Sci. A. 11 (2), 106–114 (2010).

Uwagi

PL

Opracowanie rekordu ze środków MNiSW, umowa Nr 461252 w ramach programu "Społeczna odpowiedzialność nauki" - moduł: Popularyzacja nauki i promocja sportu (2020).