Process parameter optimization of Laser Micrometallurgy of AZ31 alloy

• Autorzy: Pawlak A. , Chlebus E.
• Języki publikacji: EN

Abstrakty

EN

This paper presents process optimization results of laser powder micrometallurgy of AZ31 alloy, for eliminating porosity in melted material. Full factorial design of three factors at three levels was conducted, and the influence of laser beam power, point distance and exposure time was examined.

Słowa kluczowe

EN

SLM; magnesium alloy; design of experiments; porosity

PL

SLM; stop magnezu; projektowanie eksperymentu; porowatość

• Wydawca: Oficyna Wydawnicza Politechniki Wrocławskiej
• Czasopismo: Interdisciplinary Journal of Engineering Sciences
• Rocznik: 2015
• Tom: Vol. 3, no. 1
• Strony: 10--15
• Opis fizyczny: Bibliogr. 8 poz., rys., wykr.

Twórcy

autor

Pawlak A.

• Centre for Advanced Manufacturing Technologies, Wroclaw University of Technology

autor

Chlebus E.

• Centre for Advanced Manufacturing Technologies, Wroclaw University of Technology

Bibliografia

• [1] T. Wohlers. Wohlers Report. Wohlers Associates, Inc. Fort Collins. 2014.
• [2] K. Oczoś, A. Kawalec, Kształtowanie metali lekkich, Wydawnictwo Naukowe PWN. Warszawa 2012. s. 49-122.
• [3] C.C. Ng, M.M. Savalani, H.C. Man. Fabrication of magnesium using selective laser melting technique. Rapid Prototyping Journal 17/6: 479- 490.
• [4] C.C. Ng, M.M. Savalani, M.L. Lau, H.C. Man,. Microstructure and mechanical properties of selective laser melted magnesium. Applied Surface Science2011. 257: 7447-7454.
• [5] B. Zhang, H. Liao, Ch. Codett. Effects of processing parameters on properties of selective laser melting Mg-9%Al powder mixture. Materials and Design2012. 34: 753-758.
• [6] M.M. Savalani, C.C. Ng, H.C. Man. Selective laser melting of Magnesium for Future Applications in the Medicine. 2010 International Conference on Manufacturing Automation. 2010. s.50-54.
• [6] A. Pawlak . Wpływ gęstości oddziaływania wiązki laserowej na porowatość wyrobów wytwarzanych za pomocą SLM (Selective Laser Melting), Interdyscyplinarność badań naukowych 2012, Wrocław, Oficyna Wydawnicza Politechniki Wrocławskiej, 2012. s. 335-340.
• [7] K. Kempen, L. Thijs, E. Yasa, M. Badrossamay, W. Verheecke, J.P. Kruth. Process optimization and microstructural analysis for Selective Laser Melting of AlSi10Mg, 2011, Available at: http://utwired.engr.utexas.edu/lff/symposium/pr oceedingsArchive/pubs/Manuscripts/2011/2011- 37-Kempen.pdf.
• [8] M. Krishnan, E. Atzeni, R. Canali, F. Calignano, D. Manfredi E.P. Ambrosio, L. Iuliano. On the effect of process parameters on properties of AlSi10Mg parts produced by DMLS. Rapid Prototyping Journal. 2014. 20(6):449-458.