Experimental investigations of dynamic sorption of diesel from contaminated water

• Autorzy: Paliulis Dainius

Identyfikatory

DOI

10.24425/aep.2021.139500

• Języki publikacji: EN

Abstrakty

EN

Surface wastewater pollution due to accidental runoff or release of oil or its products is a longstanding and common environmental problem. The aim of the study was to investigate the impact of concentrations of oil products (diesel) and suspended solids, the sorbent type, the water flow rate and the interfering factors (chlorides) on the dynamic sorption of diesel and to test regeneration of polypropylene after its use for sorption. The sorbents used for study included common wheat straw (Triticum aestivum), polypropylene and sorbents modified with hydrogen peroxide solution. Standard methods were used for the determination of the investigated parameters and an in-house procedure employing a gas chromatograph was used for the determination of diesel concentration. The following factors that impact the sorption of diesel were investigated during the study: diesel concentration, concentration of suspended solids; type of sorbent (common wheat straw (Triticum aestivum), wheat straw modified with hydrogen peroxide, and polypropylene), water flow rate; and influence of the interfering factors (chlorides). Filtration speed in the range of investigated speeds does not affect the efficiency of diesel removal. Removal efficiency does not depend on the concentration of diesel before the sorbent reaches its maximum sorption capacity. Filling containing 50% of polypropylene and 50% of wheat straw was used for the study. It was found that polypropylene and wheat straw do not remove chlorides and suspended solids from solution. The study found that the solution of hydrogen peroxide boosts the hydrophobic properties of common wheat straw, but does not affect the sorption of diesel. The recommended number of regenerations of polypropylene should be limited to two.

Słowa kluczowe

EN

wheat; modification; sorption; polypropylene; diesel; surface wastewater

• Wydawca: Institute of Environmental Engineering, Polish Academy of Sciences
• Czasopismo: Archives of Environmental Protection
• Rocznik: 2021
• Tom: Vol. 47, no. 4
• Strony: 30--39
• Opis fizyczny: Bibliogr. 37 poz., rys., tab., wykr.

Twórcy

autor

Paliulis Dainius

• Vilnius Gediminas Technical University, Lithuania

Bibliografia

• 1. Adebajo, M.O., Frost, R.I., Kloprogge, J.T., Carmody, O. & Kokot, S. (2003). Porous materials for oil spill cleanup: A review of synthesis and absorbing properties, Journal of Porous Material, 3, pp. 159-170. DOI: 10.1023/A:1027484117065
• 2. Akpomie, K.G. & Conradie, J. (2021). Ultrasonic aided sorption of oil from oil-in-water emulsion onto oleophilic natural organic-silver nanocomposite, Chemical Engineering Research and Design, 165, pp. 12-24. DOI: 10.1016/j.cherd.2020.10.019
• 3. American Chemistry Council. (2018). (https://plastics.americanchemistry.com/Reports-and-Publications/National-Post-Consumer-Plastics-Bottle-Recycling-Report.pdf).
• 4. Baig, N. & Saleh, T.A. (2019). Novel hydrophobic microporous polypropylene monoliths for efficient separation of hydrocarbons, Composites Part B: Engineering, 173, pp. 106805. DOI: 10.1016/j.compositesb.2019.05.016
• 5. Baiseitov, D.A., Tulepov, M.I., Sassykova, L.R., Gabdrashova, S.E., Essen, G.A., Kudaibergenov, K.K. & Mansurov, Z.A. (2016). Sorption capacity of oil sorbent for the removal of thin films of oil, Bulgarian Chemical Communications, 3, pp. 446-450.
• 6. Bayat, A., Aghamiri, S. F., Moheb, A. & Vakili-Nezhaad, G. (2005). Oil spill cleanup from sea water by sorbent materials, Journal of Chemical Engineering Technology, 12, pp. 1525-1528. DOI: 10.1002/ceat.200407083
• 7. Chandra, S., Sharma, R., Singh, K. & Sharma, A. (2013). Application of bioremediation technology in the environment contaminated with oil hydrocarbon, Annals of Microbiology, 63, pp. 417-431. DOI: 10.1007/s13213-012-0543-3
• 8. Chaouki, Z., Zaitan, H., Nawdali M., Vasarevičius S. & Mažeikienė, A. (2020). Oil removal from refinery wastewater through adsorption on low cost natural biosorbents, Environmental engineering and management journal, 1, pp. 105-112. DOI: 10.30638/eemj.2020.011
• 9. Deschamps, G., Caruel, H., Borredon, M.E., Albasi, C., Riba, J.P., Bonnin, C. & Vignoles, C. (2003). Oil removal from water by sorption on hydrophobic cotton fibers. 2. Study of sorption properties in dynamic mode, Environmental science & technology, 21, pp. 5034-5039. DOI: 10.1021/es020249b
• 10. Gushchin, A.A., Grinevich, V.I., Gusev, G.I., Kvitkova, E.Y. & Rybkin, V.V. (2018). Removal of oil products from water using a combined process of sorption and plasma exposure to DBD, Plasma Chemistry and Plasma Processing, 5, pp. 1021-1033. DOI: 10.1007/s11090-018-9912-4
• 11. Hybská, H., Mitterpach, J., Samešová, D., Schwarz, M., Fialová, J. & Veverková, D. (2018). Assessment of ecotoxicological properties of oils in water, Archives of Environmental Protection, 4, pp. 31-37. DOI: 10.24425/aep.2018.122300
• 12. Kamble, S.P., Mangrulkar, P.A., Bansiwal, A.K. & Rayalu, S.S. (2007). Adsorption of phenol and o-chlorophenol on surface altered fly ash based molecular sieves, Chemical Engineering Journal, 138, pp. 73-83. DOI: 10.1016/j.cej.2007.05.030
• 13. Karyab, H., Mirhosseini, M. Moradi, S. & Karimi, F.F. (2016). Removal of light petroleum hydrocarbons from water sources using polypropylene and titanium dioxide nano-composite, Journal of Inflammatory Disease, 3, pp. 32-26.
• 14. Król, M. & Rożek, P. (2020). Sorption of oil products on the synthetic zeolite granules, Mineralogia, 51, pp. 1-7. DOI: 10.2478/mipo-2020-0001
• 15. Kwaśny, J. A., Kryłów, M. & Balcerzak, W. (2018). Oily wastewater treatment using a zirconia ceramic membrane-a literature review, Archives of Environmental Protection, 3, pp. 3-10. DOI: 10.24425/aep.2018.122293
• 16. Li, G., Guo, S. & Hu, J. (2016). The influence of clay minerals and surfactants on hydrocarbon removal during the washing of petroleum-contaminated soil, Chemical Engineering Journal, 286, pp. 191-197. DOI: 10.1016/j.cej.2015.10.006
• 17. Li, S., Wu, X., Cui, L., Zhang, Y., Luo, X., Zhang, Y. & Dai, Z. (2015). Utilization of modification polyester non-woven as an affordable sorbent for oil removal, Desalination and Water Treatment, 11, pp. 3054-3061. DOI: 10.1080/19443994.2014.913264
• 18. Lurchenko, V., Melnikova, O., Mikhalevich, N. & Borzenko, O. (2019). Surface wastewater treatment from various fractions of petroleum products from the territory of highway infrastructure facilities, Environmental problems, 2, pp. 74-81. DOI: 10.23939/ep2019.02.074
• 19. Maceiras, R., Alfonsin, V., Martinez, J. & de Rey, C.M.V. (2018). Remediation of diesel-contaminated soil by ultrasonic solvent extraction, International Journal of Environmental Research, 5, pp. 651-659. DOI: 10.1007/s41742-018-0121-z
• 20. Mandal, S. & Mayadevi, S. (2009). Defluoridation of water using as-synthesized Zn/Al/Cl anionic clay adsorbent: euilibrium and regeneration studies, Journal of Hazardous Materials, 167, pp. 873-978. DOI: 10.1016/j.jhazmat.2009.01.069
• 21. Mauricio-Gutiérrez, A., Machorro-Velázquez, R., Jiménez-Salgado, T., Vázquez-Crúz, C., Sánchez-Alonso, M.P. & Tapia-Hernández, A. (2020). Bacillus pumilus and Paenibacillus lautus effectivity in the process of biodegradation of diesel isolated from hydrocarbons contaminated agricultural soils, Archives of Environmental Protection, 4, pp. 56-69. DOI: 10.24425/aep.2020.135765
• 22. Mažeikiene, A. & Švediene, S. (2015). The suitability of natural and synthetic filter material for the removal of oil products from the aqueous media, Desalination and Water Treatment, 27, pp. 12487-12495. DOI: 10.1080/19443994.2015.1053993
• 23. Mažeikienė, A., Rimeika, M. & Švedienė, S. (2014). Oil removal from water by filtration, Journal of Environmental Engineering and Landscape Management, 1, pp. 64-70. DOI: 10.3846/16486897.2014.885906
• 24. Mohammadi, L., Rahdar, A., Bazrafshan, E., Dahmardeh, H., Susan, M., Hasan, A.B. & Kyzas, G.Z. (2020). Petroleum Hydrocarbon Removal from Wastewaters: A Review, Processes, 4, pp. 447. DOI: 10. 3390/pr8040447
• 25. Moshe, S.B. & Rytwo, G. (2018). Thiamine-based organoclay for phenol removal from water, Applied Clay Science, 155, pp. 50-56. DOI: 10.1016/j.clay.2018.01.003
• 26. Paulauskiene, T. (2018). Ecologically friendly ways to clean up oil spills in harbor water areas: crude oil and diesel sorption behavior of natural sorbents, Environmental Science and Pollution Research, 10, pp. 9981-9991. DOI: 10.1007/s11356-018-1316-8
• 27. Quím, R.C. (2020). Highly porous polymeric composite with γ-Fe2O3 nanoparticles for oil products sorption, Revista Cubana de Química, 1, pp. 104-116.
• 28. Rudkovsky, A.V., Fetisova, O.Y. & Chesnokov, N.V. (2016). Sorption of oil products by carbon sorbents from Siberian larch bark, Chemistry, 1, pp. 109. DOI: 10.17516/1998-2836-2016-9-1-109-118
• 29. Sari, G. L., Trihadiningrum, Y. & Ni’matuzahroh, N. (2018). Petroleum hydrocarbon pollution in soil and surface water by public oil fields in Wonocolo sub-district, Indonesia, Journal of Ecological Engineering, 2, pp. 184-193. DOI: 10.12911/22998993/82800
• 30. The surface waste water management regulation (2019). (https://e-seimas.lrs.lt/portal/legalAct/lt/TAD/TAIS.295779/asr) (in Lithuanian)
• 31. Thilagavathi, G. & Das, D. (2018). Oil sorption and retention capacities of thermally-bonded hybrid nonwovens prepared from cotton, kapok, milkweed and polypropylene fibers, Journal of environmental management, 219, pp. 340-349. DOI: 10.1016/j.jenvman.2018.04.107
• 32. Varjani, S.J. Rana, D.P. Jain, A.K. Bateja, S. & Upasani, V.N. (2015). Synergistic ex-situ biodegradation of crude oil by halotolerant bacterial consortium of indigenous strains isolated from on shore sites of Gujarat, India, International Biodeterioration & Biodegradation, 103, pp. 116-124. DOI: 10.12911/22998993/82800
• 33. Vilūnas, A., Švedienė, S. & Mažeikienė, A. (2014). The research of sorbent usage for oil products removal from storm water runoff. (https://iicbe.org/upload/1891C0214017.pdf).
• 34. Voronov, A.A, Malyshkina, E.S., Vialkova, E.I. & Maksimova, S.V. (2018). Development of the rational urban engineering systems for the surface wastewater treatment, Urban сonstruction and architecture, 3, pp. 43-50. DOI: 0.17673/Vestnik.2018.03.10
• 35. Vuruna, M., Veličković, Z., Perić, S., Bogdanov, J., Ivanković, N. & Bučko, M. (2017). The influence of atmospheric conditions on the migration of diesel fuel spilled in soil, Archives of Environmental Protection, 1, pp. 73-79. DOI: 10.1515/aep-2017-0004
• 36. Xiao Jun, Z., Zhengang, L. & Min Dong, C. (2016). Effect of H2O2 concentrations on copper removal using the modified hydrothermal biochar, Journal of Bioresourse Technology, 1, pp. 262-267. DOI: 10.1016/j.biortech.2016.02.032
• 37. Yalcinkaya, F., Boyraz, E., Maryska, J. & Kucerova, K. (2020). A review on membrane technology and chemical surface modification for the oily wastewater treatment, Materials, 13, pp. 1-14. DOI: 10.3390/ma13020493