Resistance of the Welds in CHS Joints with the Rib Plates

• Autorzy: Milewski P. , Broniewicz M.

Identyfikatory

DOI

10.7862/rb.2018.33

• Języki publikacji: EN

Abstrakty

EN

With regard to the calculation of welds’ resistance in connections between hollow sections in EN 1993-1-8, very general information is given without any indication of specific calculation procedures. These recommendations are basically as follows: the resistance of the welds must have the value of the cross-section and assessment of the welds’ resistance based on the effective lengths is allowed in cases when forces in the braces are smaller than the resistance of the joint, but the detailed method is not specified. The objective of this paper is to present the most up-to-date information for the design of welds for overlap joints with reinforcing rib plates. The article presents the FEM analysis of the welds in the intermediate joint with the rib in a truss made of circular hollow sections. The conclusions from the analysis were presented.

Słowa kluczowe

EN

trusses; hollow section; K joint with ribs; welds; FEM analysis

• Wydawca: Oficyna Wydawnicza Politechniki Rzeszowskiej
• Czasopismo: Czasopismo Inżynierii Lądowej, Środowiska i Architektury / Journal of Civil Engineering, Environment and Architecture
• Rocznik: 2018
• Tom: z. 65, nr 2
• Strony: 167--176
• Opis fizyczny: Bibliogr. 9 poz., rys.

Twórcy

autor

Milewski P.

• Bialystok University of Technology, ul. Wiejska 45A

autor

Broniewicz M.

• Bialystok University of Technology, ul. Wiejska 45A

Bibliografia

• [1] Bródka J. Design of joints with the rib plate made of hollow sections. Capacity of joints. II International Polish-Ukrainian Scientific-Technical Conference "Current Problems of Metal Structures". Book of the Conference. Gdansk, 27-28 November 2014 (in polish).
• [2] EN 1993-1-8: 2008 Eurokod 3: Design of steel structures - Part 1-8: Designing of joints.
• [3] Packer J. A., Henderson J. E.: Hollow Structural Section Connections and Trusses - A Design Guide. Second Edition. Canadian Institute of Steel Construction. Toronto 1997.
• [4] Bródka J., Broniewicz M.: Steel structures made of hollow sections. Vol. 1. PWT. Rzeszów 2017 (in polish).
• [5] Bródka J., Broniewicz M.: Calculation of welded joints of trusses made of rectangular hollow sections. - Steel Structures, 2002, No 4 (in polish).
• [6] Bródka J., Broniewicz M.: Assessment of the welded joint resistance according to EN 1993-1-8: 2009. - Steel Structure, 2007, No 1 (in polish).
• [7] Bródka J., Broniewicz M.: Calculation of welding trusses overlap joints made of rectangular hollow sections. - Archives of Civil Engineering, 2013, No 4.
• [8] ENV 1993-1-1. Eurocode 3: Design of steel structures. Part 1-1. General rules and rules for buildings. Annex K. Hollow section lattice girder connections. CEN. Brussels. 1994.
• [9] Bródka J., Broniewicz M.: Hollow section overlap joints with reinforcing rib plate in structural applications. Lambert Academic Publishing. 2016.

Uwagi

Opracowanie rekordu w ramach umowy 509/P-DUN/2018 ze środków MNiSW przeznaczonych na działalność upowszechniającą naukę (2019).