PL EN


Preferencje help
Widoczny [Schowaj] Abstrakt
Liczba wyników
Tytuł artykułu

Stem quality of Quercus cerris trees from Kosovo for the sawmilling industry

Treść / Zawartość
Identyfikatory
Warianty tytułu
Języki publikacji
EN
Abstrakty
EN
Quercus cerris is an important species in the forests of Kosovo with a potential high economic value, although there is little information on the stem quality for the saw-milling industry. This study brings data on wood properties, particularly on heartwood, sapwood and bark development within Q. cerris trees grown in two sites in Kosovo, where mature trees were felled, and discs taken at different stem height levels. The average radial growth rate was 1.21 and 1.76 mm yr-1 for both sites. Heartwood decreased from the tree base upwards with a proportion of 53% and 43% until 5 m of height in the two sites. The radial width of sapwood was higher at the stem base (on average 44 mm) and afterwards approximately constant at 32 mm. The taper was low at an average 3.3 mm m-1 between 3.3 and 7.3 m of height. Bark represented on average 16.4% of the total stem cross-section and contained a substantial proportion of rhytidome (51% of the total bark area proportion at stem base and 41% at 9.3 m). Q. cerris in Kosovo showed good potential as a timber species for the supply of stem wood to the saw-milling industry, allowing good yields of heartwood-only sawn wood components. The bark should also be considered for complementary valorization.
Słowa kluczowe
Rocznik
Strony
57--69
Opis fizyczny
Bibliogr. 40 poz., rys., tab.
Twórcy
  • University of Applied Sciences in Ferizaj, Universiteti, Kosovo, Kosovo
autor
  • Centro de Estudos Florestais, Instituto Superior de Agronomia, Universidade de Lisboa, Lisboa, Portugal
autor
  • Centro de Estudos Florestais, Instituto Superior de Agronomia, Universidade de Lisboa, Lisboa, Portugal
autor
  • Centro de Estudos Florestais, Instituto Superior de Agronomia, Universidade de Lisboa, Lisboa, Portugal
autor
  • Centro de Estudos Florestais, Instituto Superior de Agronomia, Universidade de Lisboa, Lisboa, Portugal
autor
  • LNEC, Portugal; cE3c – Centre for Ecology, Evolution and Environmental Changes/Azorean Biodiversity Group and University of Azores, Faculty of Agrarian and Environmental Sciences, Angra do Heroísmo, Açores, Portugal
autor
  • Centro de Estudos Florestais, Instituto Superior de Agronomia, Universidade de Lisboa, Lisboa, Portugal
Bibliografia
  • Bajraktari A., Petutschnigg A., Ymeri M., Canda Z., Korkut S., Nunes L., Pereira H. [2014]: Forest resources and sawmill structure of Kosovo: State of the art and perspectives. Drvna Industrija 65 [4]: 323-327
  • Bamber R.K. [1976]: Heartwood, its function and formation. Wood Science and Technology 10 [1]: 1-8
  • Bembenek M., Mederski P.S., Karaszewski Z., Lacka A., Grzywinski W., Wegiel A., Giefing D.F., Erler J. [2015]: Length accuracy of logs from birch and aspen harvested in thinning operations. Turkish Journal of Agriculture and Forestry 39: 845-850
  • Bembenek M., Giefing D.F., Karaszewski Z., Lacka A., Mederski P.S. [2013]: Strip road impact on selected wood defects on Norway spruce (Picea abies (L.) H. Karst). Drewno 56 [190]: 64-76. DOI: 10.12841/wood.1644-3985.055.05
  • Bouriaud L., Nichiforel L., Nunes L., Pereira H., Bajraktari A. [2014]: A property rights-based analysis of the illegal logging for fuel wood in Kosovo. Biomass and Bioenergy 67: 425-434
  • Čermák J., Cianciala E., Kucera J., Hallgren J. [1991]: Radial velocity profiles of water flow in trunks of Norway spruce and oak and the response of spruce to severing. Tree Physiology 10 [4]: 367-380
  • Climent J., Chambel M.R., Gil L., Pardos J.A. [2003]: Vertical heartwood variation patterns and prediction of heartwood volume in Pinus canariensis Sm. Forest Ecology and Management 174 [1-3]: 203-211
  • Corcuera L., Camarero J.J., Sisó S., Gil-Pelegrín E. [2006]: Radial-growth and woodanatomical changes in overaged Quercus pyrenaica coppice stands: functional responses in a new Mediterranean landscape. Trees 20 [1]: 91-98
  • Corona P., Romagnoli M., Torrini L. [1995]: Stem annual increments as ecobiological indicators in Turkey oak (Quercus cerris L.). Trees 10 [1]: 13-19
  • Danielewicz W., Kiciński P., Antosz L. [2014]: Turkey oak (Quercus cerris L.) in Polish forests. Acta Scientiarum Polonorum Silvarum Colendarum Ratio et Industria Lignaria 13 [2]: 5-22
  • de Rigo D., Enescu C.M., Durrant H., Caudullo G. [2016]: Quercus cerris in Europe: distribution, habitat, usage and threats. In: San-Miguel-Ayanz J., de Rigo D., Caudullo G., Houston Durrant T., Mauri A. (ed.), European Atlas of Forest Tree Species. Publication Office of the European Union, Luxembourg
  • Degron R., Nepveu G. [1996]: Prévision de la variabilité intra- et inter arbre de la densité du bois de chêne rouvre (Quercus petraea Liebl.) par modélisation des largeurs et des densités des bois initial et final en fonction de l’âge cambial, de la largeur de cerne et du niveau dans l’arbre (Predicting intra- and intertree variability of wood density in sessile oak (Quercus petraea Liebl.) through modelling earlywood and latewood width and density from cambial age, ring width and height in the tree). Annales des Sciences Forestières 53 [5]: 1019-1030
  • Giordano G. [1981]: Tecnologia del Legno. UTET, Torino, Italy
  • Gominho J., Pereira H. [2000]: Variability of heartwood content in plantation-grown Eucalyptus globulus Labill. Wood Fiber Science 32: 189-195
  • Gominho J., Pereira H. [2005]: The influence of tree spacing in heartwood content in Eucalyptus globulus labill. Wood Fiber Science 37 [4]: 582-590
  • Granier A., Anfodillo T., Sabatti M., Cochard H., Dreyer E., Tomasi M., Valentini R., Bréda N. [1994]: Axial water flow in the trunk of oak trees: a quantitative and qualitative analysis. Tree Physiology 14 [12]: 1383-1396
  • Harou A., Hajredini E. [2009]: Illegal logging in Kosovo: elements of a strategy and action plan. Pristina: United State Agency Int Dev, Kosovo Private Enterprise Program: 60. Contract No.: EEM-I-07-00007-00, TO #2
  • Hillis W.E. [1987]: Heartwood and tree exudates. Springer-Verlag, Berlin
  • Karastergiou S., Barboutis J., Vassiliou V. [2005]: Effect of the PVA gluing on bending strength properties of finger jointed turkey oakwood (Quercus cerris L.). Holz als Rohund Werkstoff 64 [4]: 339-340
  • Knapic S., Pinto-Seppa I., Usenius A., Pereira H. [2011]: Stem modelling and simulation of conversion of cork oak stems for quality wood products. European Journal of Forest Research 130 [5]: 745-751
  • Knapic S., Tavares F., Pereira H. [2006]: Heartwood and sapwood variation in Acacia melanoxylon R. Br. trees in Portugal. Forestry 79 [4]: 371-380
  • Lavisci P., Scalbert A., Masson D., Janin G. [1991]: Quality of Turkey oak (Quercus cerris) wood. 1. Soluble and insoluble proanthocyanidins. Holzforschung 45 [4]: 291-296
  • Leal S., Nunes E., Pereira H. [2008]: Cork oak (Quercus suber L.) wood growth and vessel characteristics in relation to climate and cork harvesting. European Journal of Forest Research 127 [1]: 33-41
  • Manetti M.C. [2002]: Tree ring growth by core sampling at the CONECOFOR permanent monitoring plots. The deciduous oak (Quercus cerris L.) type. Journal of Limnology 61 [1]: 55-61
  • Mert A., Özkan K., Şentürk Ö., Negiz M.G. [2016]: Changing the Potential distribution of Turkey oak (Quercus cerris L.) under climate change in Turkey. Polish Journal of Environmental Studies 25 [4]: 1633-1638
  • Mitchell A. [2009]: Sustainable forest management for Kosovo. Brux Proj Manag Group, Green Belt Proj Manag Int Serv Group SRL: 147. Funded by European Commission Liaison Office, EuropeAid/122672/D/SER/KOS. Contract No.: CRIS 2008/162-109
  • Monaco A.L., Todaro L., Sarlatto M., Spina R., Calienno L., Picchio R. [2011]: Effect of moisture on physical parameters of timber from Turkey oak (Quercus cerris L.) coppice in Central Italy. Forestry Studies in China 13 [4]: 276-284
  • Pereira H., Graça J., Rodrigues J.C. [2003]: Wood chemistry in relation to quality. In: Barnett J.R., Jeronimidis G. (eds.), Wood quality and its biological basis. CRC Press, Blackwell Publishing, Oxford
  • Pinto I., Pereira H., Usenius A. [2004]: Heartwood and sapwood development within maritime pine (Pinus pinaster Ait.) stems. Trees 18 [3]: 284-294
  • Preston C.D., Pearman D.A., Dines T.D. [2002]: New atlas of the British and Irish flora, Oxford
  • Sen A., Leite C., Lima L., Lopes P., Pereira H. [2016]: Industrial valorization of Quercus cerris bark: Pilot scale fractionation. Industrial Crops and Products 92: 42-29
  • Sen A., Quilho T., Pereira H. [2011]: Bark anatomy of Quercus cerris L. var. cerris from Turkey. Turkish Journal of Botany 35: 45-55
  • Sousa V., Cardoso S., Pereira H. [2013]: Ring width variation and heartwood development in Quercus faginea. Wood Fiber and Science 45 [4]: 405-414
  • Sterry P. [2007]: Collins Complete British Trees. HarperCollins Publishers
  • Todaro L. [2012]: Effect of steaming treatment on resistance to footprints in Turkey oak wood for flooring. European Journal of Wood and Wood Products 70 [1]: 209-214
  • Todaro L., Dichicco P., Moretti N., D’Auria M. [2013]: Effect of combined steam and heat treatments on extractives and lignin in sapwood and heartwood of Turkey oak (Quercus cerris L.) wood. BioResources 8 [2]: 1718-1730
  • Todaro L., Zanuttini R., Scopa A., Moretti N. [2012]: Influence of combined hydrothermal treatments on selected properties of Turkey oak (Quercus cerris L.) wood. Wood Science and Technology 46: 563-578
  • Tolvaj L., Molnár S. [2006]: Colour homogenisation of hardwood species by steaming. Acta Silvatica & Lignaria Hungarica 2: 105-112
  • Tomter S.M., Bergsaker E., Muja I., Dale T., Kolstad J. [2013]: Kosovo national Forest inventory. Pristina: Kosovo Ministry of Agriculture, Forestry and Rural Development, Nor For Group
  • Zhang S.Y., Owoundi R.E., Nepveu G., Mothe F., Dhôte J.F. [1993]: Modelling wood density in European oak (Quercus petraea and Quercus robur) and simulating the silvicultural influence. Canadian Journal of Forest Research 23 [12]: 2587-2593
Uwagi
Opracowanie rekordu w ramach umowy 509/P-DUN/2018 ze środków MNiSW przeznaczonych na działalność upowszechniającą naukę (2018).
Typ dokumentu
Bibliografia
Identyfikator YADDA
bwmeta1.element.baztech-dcd580d5-251a-4330-9e77-402846017f56
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.