An experimental study of emission and combustion characteristics of marine diesel engine in case of cylinder Valves leakage

• Autorzy: Kowalski J.
• Języki publikacji: EN

Abstrakty

EN

Presented paper shows the results of the laboratory tests on the relationship between throttling of both air intake duct and exhaust gas duct and a gaseous emission from the marine engine. The object of research is a laboratory, four-stroke, DI diesel engine, operated at loads from 50 kW to 250 kW at a constant speed equal to 750 rpm. During the laboratory tests over 50 parameters of the engine were measured with its technical condition recognized as a „working properly” and with simulated leakage of both air intake valve and exhaust gas valve on the second cylinder. The results of this laboratory research confirm that the leakage of cylinder valves causes no significant changes of the thermodynamic parameters of the engine. Simulated leakages through the inlet and exhaust valve caused a significant increase in fuel consumption of the engine. Valve leakages cause an increase of the exhaust gas temperature behind the cylinder with leakage and behind other cylinders. The exhaust gas temperature increase is relatively small and clearly visible only at low loads of the engine. The increase of the temperature and pressure of the charging air behind the intercooler were observed too. Charging air temperature is significantly higher during the engine operation with inlet valve leakage. The study results show significant increases of the CO, NOx and CO2 emission for all the mentioned malfunctions. The conclusion is that the results of measurements of the composition of the exhaust gas may contain valuable diagnostic information about the technical condition of the air intake duct and the exhaust gas duct of the marine engine.

Słowa kluczowe

EN

marine diesel engine; exhaust gas composition; emission; exhaust gas valve leakage; inlet valve leakage

• Wydawca: Gdańsk University of Technology, Faculty of Ocean Engineering & Ship Technology
• Czasopismo: Polish Maritime Research
• Rocznik: 2015
• Tom: nr 3
• Strony: 90--98
• Opis fizyczny: Bibliogr. 31 poz., rys., tab.

Twórcy

autor

Kowalski J.

• Department of Engineering Sciences Gdynia Maritime University, Morska 81-87 Str., 81-225 Gdynia, Poland, tel.: [phone], fax: [phone]

Bibliografia

• 1. J. Carlton: Marine Propellers and Propulsion. Third Ed., Elsevier Ltd., 2012.
• 2. International Safety Guide for Oil Tankers and Terminals. ICS, OCIMF, IAPH, 2006.
• 3. R. Pawletko, S. Polanowski: Research of the influence of marine diesel engine Sulzer AL 25/30 load on the TDC position on the indication graph, Journal of KONES , Powertrain and Transport 17 ,2010, pp. 361 – 368.
• 4. R. Pawletko, S. Polanowski : Influence of gas channels of medium speed marine engines on the accuracy of determination of diagnostic parameters based on the indicator diagrams. Journal of Polish CIMAC 7,2012, pp. 139 – 146.
• 5. Marine Engine IMO Tier II Programme 2013
• 6. A. Sarvi, C. J. Fogelholm, R. Zevenhoven : Emissions from large-scale medium-speed diesel engines: 1. Influence of engine operation mode and turbocharger.Fuel processing technology 89 , 2008, pp. 510 – 519.
• 7. A. Sarvi, C. J. Fogelholm, R. Zevenhoven: Emissions from large-scale medium-speed diesel engines: 2. Influence of fuel type and operating mode. Fuel processing technology 89, 2008, pp. 520 – 527.
• 8. A. Sarvi, R. Zevenhoven : Large-scale diesel engine emission control parameters. Energy 35 , 2010, pp. 1139–1145.
• 9. J.M. Desantes, J. Benajes, S. Molina, C.A. Gonzalez : The modification of the fuel injection rate in heavy-duty diesel engines. Part 1: Effects on engine performance and emissions. Applied Thermal Engineering 24 , 2004, pp. 2701–2714.
• 10. J.M. Desantes, J. Benajes, S. Molina, C.A. Gonzalez: The modification of the fuel injection rate in heavy-duty diesel engines. Part 2: Effects on combustion. Applied Thermal Engineering 24 ,2004, pp. 2715–2726.
• 11. G.A. Weiser: Modeling of Combustion and Nitric Oxide Formation for Medium-Speed DI Diesel Engines: A Comparative Evaluation of Zero- and Three-Dimensional Approaches. Doctor’s Thesis, Swiss Federal Institute of Technology , Zurich, 2001.
• 12. J. Huang, L. Lin, Y. Wang, J. Qin, A. P. Roskilly, L. Li, T. Ouyang, Y. Yu : Experimental study of the performance and emission characteristics of diesel engine using direct and indirect injection systems and different fuels. Fuel Processing Technology 92 , 2011, pp. 1380–1386.
• 13. K. Verbiezen, A.J. Donkerbroek, R.J.H. Klein-Douwel, A.P. van Vliet, P.J.M. Frijters, X.L.J. Seykens, R.S.G. Baert, W.L. Meerts, N.J. Dam, J.J. ter Meulen: Diesel combustion: In-cylinder NO concentrations in relation to injection timing. Combustion and Flame 151 , 2007, pp. 333–346.
• 14. E. Buyukkaya, M. Cerit: Experimental study of NOx emissions and injection timing of a low heat rejection diesel engine. International Journal of Thermal Sciences 47 , 2008, pp.1096–1106.
• 15. T. Thurnheer, D. Edenhauser, P. Soltic, D. Schreiber, P. Kirchen, A. Sankowski : Experimental investigation on different injection strategies in a heavy-duty diesel engine: Emissions and loss analysis. Energy Conversion and Management 52 , 2011, pp. 457–467.
• 16. A. Parlak, H. Yasar, C. Hasimoglu, A. Kolip: The effects of injection timing on NOx emissions of a low heat rejection indirect diesel injection engine. Applied Thermal Engineering 25 , 2005, pp. 3042–3052.
• 17. R. Payri, F.J. Salvador, J. Gimeno, L.D. Zapata: Diesel nozzle geometry influence on spray liquid-phase fuel penetration in evaporative conditions. Fuel 87 , 2008, pp. 1165–1176.
• 18. M. Ebna Alam Fahd, Yang Wenming, P.S. Lee, S.K. Chou, Christopher R. Yap: Experimental investigation of the performance and emission characteristics of direct injection diesel engine by water emulsion diesel under varying engine load condition. Applied Energy 102 , 2013, pp. 1042–1049.
• 19. W.M. Yang, H. An, S.K. Chou, S. Vedharaji, R. Vallinagam, M. Balaji, F.E.A. Mohammad, K.J.E. Chua: Emulsion fuel with novel nano-organic additives for diesel engine application. Fuel 104 ,2013, pp. 726–731.
• 20. A. Kumar Agarwal, A. Dhar: Experimental investigations of performance, emission and combustion characteristics of Karanja oil blends fuelled DICI engine. Renewable Energy 52 , 2013, pp. 283 – 291.
• 21. A.K. Hossain, M. Ouadi, S.U. Siddiqui, Y. Yang, J. Brammer, A. Hornung, M. Kay, P.A. Davies: Experimental investigation of performance, emission and combustion characteristics of an indirect injection multi-cylinder CI engine fuelled by blends of de-inking sludge pyrolysis oil with biodiesel. Fuel 105, 2013, pp. 135–142.
• 22. D.C. Rakopoulos : Combustion and emissions of cottonseed oil and its bio-diesel in blends with either n-butanol or diethyl ether in HSDI diesel engine. Fuel 105, 2013, pp. 603–613.
• 23. S. Saravanan, G. Nagarajan, S. Sampath : Combined effect of injection timing, EGR and injection pressure in NOx control of a stationary diesel engine fuelled with crude rice bran oil methyl ester. Fuel 104 , 2013, pp. 409–416.
• 24. P. Behera, S. Murugan: Combustion, performance and emission parameters of used transformer oil and its diesel blends in a DI diesel engine. Fuel 104 , 2013, pp. 147–154.
• 25. B. İşcan, H. Aydın : Improving the usability of vegetable oils as a fuel in a low heat rejection diesel engine. Fuel Processing Technology 98 , 2012, pp. 59–64.
• 26. S. Altun, H. Bulut, C. Oner: The comparison of engine performance and exhaust emission characteristics of sesame oil–diesel fuel mixture with diesel fuel in a direct injection diesel engine. Renewable Energy 33 , 2008, pp. 1791–1795.
• 27. Ch. Yao, C.S. Cheung, Ch. Cheng, Y. Wang, T.L. Chan, S.C. Lee: Effect of Diesel/methanol compound combustion on Diesel engine combustion and emissions. Energy Conversion and Management 49, 2008, pp. 1696–1704.
• 28. H. Aydin, C. Ilkılıc : Effect of ethanol blending with biodiesel on engine performance and exhaust emissions in a CI engine. Applied Thermal Engineering 30 , 2010, pp. 1199–1204.
• 29. J. Huang, Y. Wang, J. Qin, A. P. Roskilly: Comparative study of performance and emissions of a diesel engine using Chinese pistache and jatropha biodiesel. Fuel Processing Technology 91 ,2010, pp. 1761–1767.
• 30. Y.D. Wang, T. Al-Shemmeri, P. Eames, J. McMullan, N. Hewitt, Y. Huang, S. Rezvani: An experimental investigation of the performance and gaseous exhaust emissions of a diesel engine using blends of a vegetable oil. Applied Thermal Engineering 26, 2006, pp. 1684–1691.
• 31. International Organization of Standardization : ISO 8178 regulation.