Investigation of Open End Yarn Tension Using an Elastic Yarn-Guide

• Autorzy: Shukhratov Sharof , Milašius Rimvydas , Gafurov Jakhongir , Mardonov Batir , Gafurov Kabuljon , Repon Md. Reazuddin

Identyfikatory

DOI

10.5604/01.3001.0014.8230

Warianty tytułu

PL

Badanie naprężenia przędzy przy użyciu elastycznego prowadnika podczas przędzenia bezwrzecionowego

• Języki publikacji: EN

Abstrakty

EN

This paper presents the results of Open End (OE) yarn tension investigation using a yarn-guide funnel with an elastic element. Obtained were the dependencies of tension change on such factors as body mass, elastic element rigidity, yarn coordinates on the funnel surface, and the speed of yarn moving. The values of these factors cause fluctuations in yarn tension and, consequently, in yarn structure and characteristics. On the basis of experiments, it was shown that due to using of a yarn-guide funnel with an elastic element, a decrease in yarn unevenness is achieved. It is easily regulated by the funnel mass, the rigidity rate of the elastic element, and the spinning speed.

PL

W artykule przedstawiono wyniki badań naprężenia przędzy podczas przędzenia bezwrzecionowego za pomocą lejka prowadzącego przędzę z elementem sprężystym. Przeanalizowano zależności zmiany naprężenia od czynników takich jak: masa ciała, sztywność elementu sprężystego, współrzędne przędzy na powierzchni lejka oraz prędkość poruszania się przędzy. Wartości czynników spowodowały wahania naprężenia przędzy, a co za tym idzie, jej struktury i właściwości. Na podstawie eksperymentów wykazano, że dzięki zastosowaniu lejka prowadzącego przędzę z elementem sprężystym zmniejszono nierówności przędzy.

Słowa kluczowe

EN

OE; Open End; tension; elastic element; yarn-guide funnel; yarn unevenness; rigidity rate

PL

OE; naprężenie; element sprężysty; lejek prowadzący przędzę; nierównomierność przędzy; współczynnik sztywności

• Wydawca: Sieć Badawcza Łukasiewicz - Łódzki Instytut Technologiczny
• Czasopismo: Fibres & Textiles in Eastern Europe
• Rocznik: 2021
• Tom: Vol. 29, no. 4 (148)
• Strony: 43--47
• Opis fizyczny: Bibliogr. 27 poz., rys., tab.

Twórcy

autor

Shukhratov Sharof

• Kaunas University of Technology, Faculty of Mechanical Engineering and Design, Department of Production Engineering, Studentu 56, LT-51424, Kaunas, Lithuania
• Fergana State University, Department of Life Safety, Fergana, Uzbekistan

• https://orcid.org/0000-0002-9626-7193

autor

Milašius Rimvydas

• Kaunas University of Technology, Faculty of Mechanical Engineering and Design, Department of Production Engineering, Studentu 56, LT-51424, Kaunas, Lithuania

autor

Gafurov Jakhongir

• Jizzakh Polytechnic Institute, Department of Processing of Textile Materials, Jizzakh, Uzbekistan

• https://orcid.org/0000-0002-2253-7306

autor

Mardonov Batir

• Tashkent Institute of Textile and Light Industry, Department of Textile Industry Technology, Tashkent, Uzbekistan

• https://orcid.org/0000-0002-5192-2107

autor

Gafurov Kabuljon

• Tashkent Institute of Textile and Light Industry, Department of Textile Industry Technology, Tashkent, Uzbekistan

• https://orcid.org/0000-0002-0125-5414

autor

Repon Md. Reazuddin

• Kaunas University of Technology, Faculty of Mechanical Engineering and Design, Department of Production Engineering, Studentu 56, LT-51424, Kaunas, Lithuania
• ZR Research Institute for Advanced Materials, Sherpur-2100, Bangladesh
• Khwaja Yunus Ali University, Department of Textile Engineering, Sirajgang-6751, Bangladesh

• https://orcid.org/0000-0002-9984-7732

Bibliografia

• 1. Gofurov JK, Jumaniyazov KJ, Turakulov B, Gofurov K. Effect of Rewind Chamber Speed on Properties of Yarn. Textile problems 2007; 2: 32-36.
• 2. Simpson J, Patureau MA. Effect of Rotor Speed on Open-End Spinning and Yarn Properties. Textile Research Journal 1979; 49(8): 468-73.
• 3. Manohar JS, Rakshit AK, Balasubramanian N. Influence of Rotor Speed, Rotor Diameter, and Carding Conditions on Yarn Quality in Open-End Spinning. Textile Research Journal 1983; 53(8): 497-503.
• 4. Gafurov J, Kyosev Y. FEM Frequency Analysis of Rotors for Open End Spinning. Proceedings of Aachen-Dresden International Textile Conference 2013 Nov (Vol. 28, p. 29).
• 5. Lord PR. The Structure Of Open-End Spun Yarn. Textile Research Journal 1971; 41(9): 778-84.
• 6. Basu A. Yarn Structure-Properties Relationship. Indian Journal of Fibre and Textile Research 2009; 34(3): 287-94.
• 7. Hearle JW, Grosberg P, Backer S. Structural Mechanics of Fibers, Yarns, and Fabrics. 1969; p. 469.
• 8. Van Langenhove L. Simulating the Mechanical Properties of a Yarn Based on the Properties and Arrangement of its Fibers Part II: Results of Simulations. Textile Research Journal 1997; 67(5): 342-7.
• 9. Van Langenhove L. Simulating the Mechanical Properties of a Yarn Based on the Properties and Arrangement of its Fibers: Part III: Practical Measurements. Textile Research Journal 1997; 67(6): 406-12.
• 10. Sherbakov VP. Calculation of Yarn Strength Using Theory of Anisotropic Body Elasticity. Universities news 1996; 6: 10-13.
• 11. Al Mamun R, Repon MR, Islam MT, Motaleb KZ. Promising Effect of Processing Parameters on Yarn Properties in Rotor Spinning. Manufacturing Science and Technology 2017; 4(1): 11-5.
• 12. Zhang H, Chen D, Wan Y. Fiber Migration and Twist Radial Distribution in Rotor Spun Yarns. Textile Research Journal 2003; 73(11): 945-8.
• 13. Jiang XY, Hu JL, Cheng KP, Postle R. Determining the Cross-Sectional Packing Density of Rotor Spun Yarns. Textile Research Journal 2005; 75(3): 233-9.
• 14. Pillay KP, Viswanathan N, Parthasarathy MS. The Structure and Properties of Open-End Yarns: Part I: A Study of Fiber Configurations and Migration. Textile Research Journal 1975; 45(5): 366-72.
• 15. Soe AK, Takahashi M, Nakajima M, Matsuo T, Matsumoto T. Structure and Properties of MVS Yarns in Comparison with Ring Yarns and Open-End Rotor Spun Yarns. Textile Research Journal 2004; 74(9): 819-26.
• 16. Gafurov JK, Mardonov BM, Peerzada MH, Gafurov K. Investigating the Strain State of Fibres Located on the Helical Line in Extended Yarn. FIBRES & TEXTILES in Eastern Europe 2015; 23, 2(110): 19-24.
• 17. Gafurov JK, Sobirov A, Bobojanov KhT, Gafurov K. Assessment of Yarn Structure Basing on its Deformation. Textile problems 2013; 4. 46-51.
• 18. Jumaniyazov K, Gafurov JK, Peerzada MH. Theoretical Modeling of Tight Structure of Open-end Yarn. Science International 2012; 24(1): 37-40.
• 19. Gafurov J, Jumaniyazov K, Alishev Sh. The Analysis of Fibers Transportation on the OE Rotor’s Inner Surface. The Problems of Textiles Journal 2007: 33-37.
• 20. Manohar JS, Rakshit AK, Balasubramanian N. Influence of Rotor Speed, Rotor Diameter, and Carding Conditions on Yarn Quality in Open-End Spinning. Textile Research Journal 1983; 53(8): 497-503.
• 21. Simpson J, Patureau MA. Effect of Rotor Speed on Open-End Spinning and Yarn Properties. Textile Research Journal 1979; 49(8): 468-73.
• 22. Patent SU 1306179 А1.
• 23. Patent SU 1309627 А1.
• 24. Madrakhimov O Kh, Gafurov K, Mardonov B, Gafurov JK. Yarn-Guide Device Ofpneumatic Spinning Machine. FAP 01059, 2016;1: 87-88, Tashkent.
• 25. Madrakhimov O Kh, Gafurov J K, Bobojanov Kh T. Using Of Elastic Funnelfor Pneumatic Spinning Machines. Textile problems 2014; 2: 56-59.
• 26. Idzik M. Analysis of Changes in Fiber Density Distribution in a Cotton Combed Spinning System Using Modified Regulation of the Sliver Draft. Autex Research Journal 2019;19(1): 54-9.
• 27. Lu Y, Wang Y, Gao W. Wicking Behaviors of Ring and Compact-Siro Ring Spun Yarns with Different Twists. Autex Research Journal 2019; 19(1): 68-73.

Uwagi

Opracowanie rekordu ze środków MNiSW, umowa Nr 461252 w ramach programu "Społeczna odpowiedzialność nauki" - moduł: Popularyzacja nauki i promocja sportu (2021).