Assessment of exhaust emissions by Andoria 4CTi90 compression ignition engine

• Autorzy: Lisowski M. , Gołębiewski W.

Identyfikatory

DOI

10.5604/01.3001.0010.2820

• Języki publikacji: EN

Abstrakty

EN

Compression ignition engines are a major source of air pollution in big cities and the cause of smog. Therefore, it seems appropriate to quantify emissions of toxic components of combustion gases by compression ignition engines. In the paper, it was presented emission measurement results of selected components of exhaust gases such as CO, CO2, HC, O2, NOx, by indirect injection compression ignition engine. The object of the study was Andoria 4CTi90 engine. The research was carried out at the AVL engine test bench. Measurement results were shown in the form of external and load characteristics. It was interesting to compare the emissions of individual exhaust components of the 4CTi90 engine with the contemporary direct injection engine. The measurements carried out at the Department of Automotive Engineering at the West Pomeranian University of Technology in Szczecin on the Fiat 1.3 JTD Multijet engine showed that the emissions of the considered exhaust gas components in conditions of external characteristics, for the rotational speed of 4000 1/min, were much higher than the Andoria engine. The study assumed the measurement of hydrocarbon emissions, however, within almost the entire range it was zero. Only for the speed of 4000 min-1, the meter showed values slightly higher than zero. The authors believe that it would be interesting to compare the exhaust emissions of the 4CTi90-1BE engine and the ADCR engine.

Słowa kluczowe

EN

exhaust emission; external characteristics; compression ignition engine; indirect injection

PL

emisja spalin; silnik wysokoprężny; wtrysk pośredni

• Wydawca: Łukasiewicz Research Network - Institute of Aviation ; European Science Society of Powertrain and Transport KONES Poland ; Wydawnictwo Instytutu Technicznego Wojsk Lotniczych
• Czasopismo: Journal of KONES
• Rocznik: 2017
• Tom: Vol. 24, No. 1
• Strony: 239--245
• Opis fizyczny: Bibliogr. 2 poz., rys.

Twórcy

autor

Lisowski M.

• West Pomeranian University of Technology in Szczecin Department of Automotive Engineering Piastow Av. 19, 70-310 Szczecin, Poland tel.:[phone]

autor

Gołębiewski W.

• West Pomeranian University of Technology in Szczecin Department of Automotive Engineering Piastow Av. 19, 70-310 Szczecin, Poland tel.:[phone]

Bibliografia

• [1] Wojniak, A.,Wcisło, S., Harnas, M., Silniki wysokoprężne dla motoryzacji, Journal of KONES, Vol. 7, No. 1-2.
• [2] ANDORIA, Instrukcja obsługi, Silnik wysokoprężny 4CT90-1BE, W.S.W., Andoria, 2000.

Uwagi

PL

Opracowanie ze środków MNiSW w ramach umowy 812/P-DUN/2016 na działalność upowszechniającą naukę (zadania 2017).