Charging of the cast iron lapping tools

• Autorzy: Barylski A.
• Konferencja: Mechanics 2002 / International Scientific Conference (III; 1-3.08.2002; Rzeszów; Poland)
• Języki publikacji: EN

Abstrakty

EN

The manual charging can be applied to a single - disk lapper, for which the tool is rotated. The changing time is relatively long. The efficiency and the quality of the charging is not very high, due to the difficulties of the uniformly distribution of the abradent micrograins. An additional problem is that the compression of the charging elements is not constant, which causes differences in the micrograin penetration of the lapping tool face. From some time, research has been done about machine surface charging. lntroducing a mechanical drive should eliminate the fundamental faults of the manual charging.

Słowa kluczowe

EN

lapping tool; cast iron; charging with abrasive

PL

docierak; stop żelaza; żeliwo; zbrojenie materiałem ściernym

• Wydawca: Oficyna Wydawnicza Politechniki Rzeszowskiej
• Czasopismo: Zeszyty Naukowe Politechniki Rzeszowskiej. Mechanika
• Rocznik: 2002
• Tom: z. 58 [193]
• Strony: 53--56
• Opis fizyczny: Bibliogr. 5 poz., rys.

Twórcy

autor

Barylski A.

• Wrocław Technical University, Poland

• Gdańsk University of Technology, Polan

Bibliografia

• 1. Barylski A.: Contamination of graphite with abrasive during lapping of cast iron. Stud. i Mater. Gorz. Osr. Bad. I Ekspertyz Nauk., 1985, Ref. T.IV, 1-2, 303-316.
• 2. Barylski A.: Fundamentals of flat surface lapping with single-disk. Zesz. Nauk. P.Gdan., 1992, 491, 3-196.
• 3. Barylski A.: Theoretical and experimental fundaments of flat surface lapping on disk lapping machine. Proceedings of the 7th International Precision Engineering Seminar, Kobe, 1993, Suppl., 1-15.
• 4. Jascericun P.I., Zajcev A.G., Barbotko A.I.: Tonkije dovodocnyje process obrabotki detalej masin i proborov. Minsk, Nauka i Technika, 1976.
• 5. Ulegin V.G., Ogorodnikov A.P.: Fiziceskaja suscnost sarzirovanija. Almazy, 1973, 12, 10-16.