PL EN


Preferencje help
Widoczny [Schowaj] Abstrakt
Liczba wyników
Tytuł artykułu

Numerical analysis of needle punching machine journal bearings operation

Wybrane pełne teksty z tego czasopisma
Identyfikatory
Warianty tytułu
Konferencja
International Textile Conference IMTEX 2000 (IV ; 5-6.06.2000 ; Łódź, Poland)
Języki publikacji
EN
Abstrakty
EN
Nonwoven materials as the products in the range of flat textiles are relatively new structures. Stitch nonwoven have been found very wide application in clothing industry, medicine and civil engineering. This field of textiles production has generated not only new methods of production but also new - up to now not known - manufacturing machines as well as it has influenced the development of new variation of traditional machines. These machines are more and more sophisticated with high parameters of operation and high sensitivity on the exploitation errors. They are equipped in the systems of continuos monitoring of both technological parameters of stitching and sensitive nodes of mechanisms of needle punching machine. The base of diagnostic knowledge based on the experimental investigation has own restrictions. Active experiments can not be carried-out on the real needle punching machines because these are large and very expensive objects. Passive experiments need longer time of investigations. Most of needle punching machines have the driving system of stitching bench by crank-crosshead mechanism. In considered solution this design, realised by eccentric drive, was assumed. The consideration concerning balancing and mass distribution can be found in [1] and was neglected here has been. The crank bearings were calculated by means of procedure given in the standard DIN 31652. The results have been given in paper [1] too. This paper concerns the analysis of main bearings of simple needle punching machines in the conditions of dynamic loads. The consideration are for the steady-state motion on the idle run of machine.
Rocznik
Tom
Strony
341--347
Opis fizyczny
Bibliogr. 6 poz.
Twórcy
autor
  • Technical University of Łódź, Group of Technical Mechanics
  • Technical University of Łódź, Institute of Machine Design
Bibliografia
  • [1] Kapusta H., Dynamic analysis of needle machine. Own report. PŁ. 1998.(in polish).
  • [2] Jędrzejewski J., Mechanics of crankshaft systems of combustion engines. 1986. (in polish).
  • [3] Strzelecki S., Dynamic Characteristics of 3-Lobe Offset Journal Bearing. Proceedings of the International Tribology Conference in Australia. 6-9 December 1998. Brisbane, Australia. 243-248.
  • [4] Strzelecki S., Someya T., Maximum Oil Film Pressure and Temperature of Dynamically Loaded Journal Bearing. Proceedings of the 5th International Tribology Conf. in Australia. 6-9 December 1998. Brisbane, 219-224.
  • [5] Carl T., Das zylindrische Gleitlager unter konstanter und sinisformiger Belastung. Eine experimentelle Untersuchung. Diss. TH Fridericana Karlsruhe. 1962.
  • [6] Strzelecki S., Maximum pressure and stresses in the dynamically loaded journal bearing with the peripheral oil groove. Journal of KONES 1997 Vol.2 No. 1 KONES'97. 23rd International Scientific Conference on Combustion Engines. Bielsko-Biala, Poland 1997, 433-438
Typ dokumentu
Bibliografia
Identyfikator YADDA
bwmeta1.element.baztech-article-LOD1-0027-0040
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.