PL EN


Preferencje help
Widoczny [Schowaj] Abstrakt
Liczba wyników
Tytuł artykułu

Synteza paskowych szyków antenowych na podłożu ferroelektrycznym

Wybrane pełne teksty z tego czasopisma
Identyfikatory
Warianty tytułu
EN
Synthesis of microstrip antenna arrays on ferroelectric substrate
Języki publikacji
PL
Abstrakty
PL
W pracy przedstawiono nową metodę syntezy anten paskowych, przydatnych do zastosowań w systemach adaptacyjnych. Proponowana metoda polega na poszukiwaniu optymalnych kształtów charakterystyk promieniowania pojedynczych radiatorów w szyku antenowym (przez zmianę przenikalności elektrycznej podłoża ferroelektrycznego radiatora paskowego) bez konieczności stosowania przesuwników fazy i tłumików. W pracy przedstawione wyniki syntezy oraz porównanie proponowanej metody z ogólnie stosowanymi.
EN
ln modern radio system smart beamforming is often required. Communications antennas must offer a large number of operating modes (including pencil and shaped beams with fast switching between them) in order to ensure the best coverage of the service area. Therefore in designing smart antennas one of the main challenges is to provide a prescribed shaped antenna pattern that simultaneously suppresses interference signals (which locations are either known or unknown). As a rule this problem is solved with the use of phased-array antennas. This type of array consists of multiple stationary antenna elements which are fed coherently and use variable phase or time-delay control at each element to scan the beam to given angles in space. Variable amplitude control is sometimes also provided for pattern shaping. Performance of each radiating element bas significant influence on the parameters of antenna array, e.g. pattern, beamwidth, directivity gain, sidelobes, cross-polarization levels etc. Reducing the cost of phased array antennas has recently become the subject of considerable interest. The most prominent obstacle to this is the cost of current phase shifter elements (p-I-n diodes, MESFETs, ferrite). AIl of these are expensive, constituting a significant portion of the total receive-array cost. Additionally, p-I-n diodes and MESFETs introduce significant losses. These losses necessitate additional amplification of signal thus complicate the overall system design. New developments in MEMS and ferroelectric technologies promise low loss/high performance phase shifters. Both technologies provide low losses with beam capabilities, high isolation, good power handling ability, and low intermodulation distortion. Ferroelectrics are beneficial for applications operating at microwaves range, offering large phase shift per loss, low losses (0.2-0.3 dB, depending on frequency and matching), and large power handling capability. Bulk ferroelectric are beneficial for large phased array antennas because acceptable radiation characteristics may be achieved with fewer elements, lower cost, smaller size, and weight and lower power consumption. The design of a low-cost antenna array with 2D steering capability is very important for radiocommunication. As the satellite and mobile wireless communications technologies continue to utilize higher frequencies in the 20 to 60 GHz range, the design of a phased array antenna becomes prohibitively expensive. Also the realization od 2D scanning capability to track the satellite or to provide adequate urban communications systems becomes increasingly difficult to realize at a sufficiently low-cost suitable for the consumer market. The aim of this paper is to present a new method of array pattern synthesis by taking into consideration pattern of each radiator specially of the ferroelectric one. Radiating elements employing ferroelectric materials may give much better performance compared with ferrite ones, because of their high power handling capability, low drive power, full military temperature range of operation and low cost. The main feature of the ferroelectric antennas is the change of ferroelectric material permittivity with an applied dc control voltage. The permittivity change by varying the dc bias enables to create different radiation patterns. This permits to use such radiating element in several applications, e.g. smart antenna arrays. In this paper, new method of pattern synthesis of antenna arrays without phase shifters and attenuators has been presented. This concept is based on utilizing voltage-controlled ferroelectric array, where variable pattern of each antenna element is used to synthesize array pattrern.
Rocznik
Strony
67--80
Opis fizyczny
Bibliogr. 10 poz.
Twórcy
  • Instytut Radioelektroniki, Politechnika Warszawska, ul. Nowowiejska 15/19, 00-665, Warszawa
autor
  • Instytut Radioelektroniki, Politechnika Warszawska, ul. Nowowiejska 15/19, 00-665, Warszawa
Bibliografia
  • 1. J. Modelski, Y. Yashchyshyn: Voltage-controlled ferroelectric microstrip antenna for phased arrays. 2000 IEEE Intern. Symp. on Antennas and Propagation and USNC/URSI National Radio Science Meeting., Utah, Salt Lake City (USA), July 2000, pp. 506-509.
  • 2. J. Modelski, Y. Yashchyshyn: Investigations of the Microstrip Antenna on Ferroelectric Sub¬strates. 30" European Microwave Conference, Paris (France), October 2000, pp. 162-165.
  • 3. J. B. L. Rao, D. P. Patel and V. Krichevsky: Voltage-Controlled Ferroelectric Lens Phased Arrays. IEEE Trans. Antennas and Propagation, 1999, AP-47, No 3, pp. 458-468.
  • 4. V. K. Varadan, D. K. Ghodgaonkar, V. V. Varadan, J. F. Kelly and P. Glikerdas: Ceramic Phase Shifters for Electronically Steerable Antenna Systems. Microwave Journal, 1992, MJ-35, No 1, pp. 116-127.
  • 5. J. Modelski, Y. Yashchyshyn: New type of Microstrip Antenna with Ferroelectric Layer. XIII Intern. Conf. On Microwaves, Radar and Wireless Communications MIKON'2000, Wrocław (Poland), May 2000, pp. 583-586.
  • 6. Е. М. Ящишин: Сегнетоелектрицна мгкросмужкова антена. Вгсник НУ"ЛП" N9.387 „Радгоелектронгка, та телекомунгкацгг", Львгв (Украина), 2000, сс. 222-231.
  • 7. R. С. Наnsеп: Phased Аrrау Antennas. John Wiley & Sопs, Inc. 1998, р. 486.
  • 8. R. J. Maillou x: Phased Array Antenna Handbook. Artech House. 1994, p. 525.
  • 9. Р. А. Монзиго, Т. У. Миллер: Агаптивные антенные решетки. Введеные в теорию. Пер. с англ. под ред. В.А. Лексаченко. М. Радио и связь, 1986, с. 446
  • 10. Б. Уидроу, С. Стирнз: Адаптивная обработка сугналов. Пер. с англ. Ю.К. Сальникова под ред. В.В. Шахгильдяна. М. Радио и связь, 1989, с. 440.
Typ dokumentu
Bibliografia
Identyfikator YADDA
bwmeta1.element.baztech-article-BWA2-0009-0081
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.