Procedure for multi-material modelling of concept prototypes

• Autorzy: Biesinger B. , Grzesiak A.
• Konferencja: Rapid Production 2004. Innovation ‒ Knowledge ‒ Industry (1st International Conference; 29 September-1 October 2004; Wrocław)
• Języki publikacji: EN

Abstrakty

EN

A concept and realisation of an experimental system that allows building a multi-material prototype using the layer-by-layer technique is presented in this paper. The research involves testing of a combination of different materials and fundamental analysis about material combinations and application principles. It consists of two identically constructed extruders, which are addressed via their own control system. Hereby it became possible to use two different materials for the layer-by-layer manufacturing of a construction unit. The advantage of this almost geometry-independent arrangement consists of using both extrusions on one slice level. Thermoplastic materials were considered for this purpose (e.g. adhesion characteristics) and a quality control system was adapted in order to adjust process parameters accurately.

Słowa kluczowe

EN

concept modelling; multi material modelling; rapid manufacturing

• Wydawca: Oficyna Wydawnicza Politechniki Wrocławskiej
• Czasopismo: Prace Naukowe Instytutu Technologii Maszyn i Automatyzacji Politechniki Wrocławskiej. Konferencje
• Rocznik: 2004
• Tom: Vol. 85, nr 42
• Strony: 35--40
• Opis fizyczny: Bibliogr. 7 poz., rys.

Twórcy

autor

Biesinger B.

• Fraunhofer-Institut für Produktionstechnik und Automatisierung

autor

Grzesiak A.

• Fraunhofer-Institut für Produktionstechnik und Automatisierung

Bibliografia

• [1] RÖSENER, B.; KICKEL, J.; NAUNDORF, G.: Elektrisch funktionsfähige Prototypen ohne Spritzgieβformen. In: PLUS Produktion von Leiterplatten und Systemen 5 (2003), S. 123-129.
• [2] WOHLERS, T.; GRIMM, T.: The Real Cost of RP, In: Time-Compression Technologies, March/April 2002.
• [3] SEEFRIED M.; SIGL M.: Rapid Technologien - Status Quo. In: Seminarberichte IWB 62 (2002), S. 1.1-1.129
• [4] CHARTIER T.; CHAPUT C.; DOREAU F.; LOISEAU M.: Stereolithography of structural complex ceramic parts. In: Journal of Materials Science 37 (2002), S. 3141-3147
• [5] ONAGURUWA S.; BOSE S.; BANDYOPADHYAY A.: Fused deposition of ceramics (FDC) and composites, In: Solid Freeform Fabrication Proceedings, (2001), S. 224-231
• [6] RAUH,W.: Virtuelle Produkte und Rapid Prototyping. In: Produkte mit technischer Intelligenz entwickeln, herstellen and betreiben, Fraunhofer IPA-Technologie-Forum (1999), Band F42, S. 17-22.
• [7] WESTKÄMPER, E.; KOCH, K. U.; BIESINGER, B.: Innovative Generative Manufacturing of 3-Dimensional Structures In: Production Engineering 9 (2002), Nr. 1, S. 43-46.