Analysis of combustion process of a charge of natural gas in laboratory combustion chamber

• Autorzy: Sendyka B. , Noga M.
• Języki publikacji: EN

Abstrakty

EN

The article contains an analysis of investigation results of the combustion process of a charge of natural gas mixture with air. Investigations were carried for charges of stoichiometric composition and lean ones for various initial pressures in the combustion chamber. Ignition of the mixture was indicated by an ignition plug supplied from a direct ignition device. Measurements comprise a digital record of the pressure course in the chamber. Values of pressure increment in the chamber during the combustion process were analyzed. A diagram of pressure increment values dependent on charge composition and initial pressure in the combustion chamber was elaborated. Evaluation of particular results permits to determine potential possibilities of gas - air charge combustion.

• Wydawca: Łukasiewicz Research Network - Institute of Aviation ; European Science Society of Powertrain and Transport KONES Poland ; Wydawnictwo Instytutu Technicznego Wojsk Lotniczych
• Czasopismo: Journal of KONES
• Rocznik: 2005
• Tom: Vol. 12, No. 3-4
• Strony: 219--224
• Opis fizyczny: Bibliogr. 11 poz., rys.

Twórcy

autor

Sendyka B.

• Cracow University of Technology Institute of Automobiles and Internal Combustion Engines 31-864 Kraków al. Jana Pawła II 37 tel.: [phone] fax: [phone]

autor

Noga M.

• Cracow University of Technology Institute of Automobiles and Internal Combustion Engines 31-864 Kraków al. Jana Pawła II 37 tel.: [phone] fax: [phone]

Bibliografia

• [1] Alizon F., Guibert P., Dumont P., DuPont A., “Convective Heat Transfers in the Combustion Chamber of an Internal Combustion Engine Influence of In-Cylinder Aerodynamics”, SAE, Warrendale 2004.
• [2] Catania A. E., Spessa E., Misul D., Martorana G., “Conversion of a Multivalve Gasoline Engine to Run on CNG”, SAE, Warrendale 2000.
• [3] Gilaber P., Pinchon P., “Measurements and Multidimensional Modeling of Gas-Wall Heat Transfer in a S.I. Engine”, SAE, Warrendale1988.
• [4] Karkoszka P., "Samochodowe niekonwencjonalne systemy zapłonowe", WKiŁ, Warszawa 1988.
• [5] Kordziński C., "Zapłon elektryczny trakcyjnych silników spalinowych", WKiŁ, Warszawa 1969.
• [6] Kowalewicz A., "Tworzenie mieszanki i spalanie w silnikach o zapłonie iskrowym", WKiŁ, Warszawa 1984.
• [7] Misul D., Mittica A., Spessa E., Catania A.E., “Refined Two-Zone Heat Release Model for Combustion Analysis in SI Engines”, The Fifth International Symposium on Diagnostics and Modeling of Combustion in Internal Combustion Engines, Nagoya 2001.
• [8] Rychter T., Teodorczyk A., "Modelowanie matematyczne roboczego cyklu silnika tłokowego", PWN Warszawa 1990.
• [9] Spessa E., Catania A.E., Misul D., Vassallo A., “Analysis of Combustion Parameters and Their Relation to Operating Variables and Exhaust Emissions in An Upgraded Multivalve Bi-Fuel CNG SI Engine”, SAE, Warrendale 2004.
• [10] Szargurt J., "Termodynamika techniczna", Wydawnictwo Politechniki Śląskiej, Gliwice 1997.
• [11] Yamamoto Y., Sato K., Matsumoto S., Tsuzuki S., “Study of Combustion Characteristics of Compressed Natural Gas as Automotive Fuel”, SAE, Warrendale 2004.