Changing the load-kinematic parameters of bevel gears with biconvex-concave teeth during operation

• Autorzy: Kuznetsova A.
• Języki publikacji: EN

Abstrakty

EN

The change in the shape of biconvex-concave teeth profile as a result of bevel gears teeth wear was established experimentally. The wear influence on the tooth curvature radiuses, the rolling and sliding velocities of mating profiles and the teeth contact stresses was examined. The characteristics, which affected the wear process, were determined. A three-dimensional picture of the teeth wear distribution was presented.

Słowa kluczowe

EN

biconvex-concave teeth; bevel gear; wear; curvature radiuses; gear ratio; rolling velocity; sliding velocity; contact stresses

PL

zużycie; promień krzywizny; pezełożenie dynamiczne; prędkość toczenia; prędkość poślizgu

• Wydawca: Oficyna Wydawnicza Uniwersytetu Zielonogórskiego
• Czasopismo: International Journal of Applied Mechanics and Engineering
• Rocznik: 2012
• Tom: Vol. 17, no. 3
• Strony: 885--892
• Opis fizyczny: Bibliogr. 10 poz., tab., wykr.

Twórcy

autor

Kuznetsova A.

• Donetsk National Technical University 58, Artem St., 83001 Donetsk, UKRAINE,

Bibliografia

• Drozdov Y.N., Pavlov V.G. and Puchkov V.N. (1986): Friction and wear in extreme conditions. - Handbook, Moscow, Mechanical Engineering, 224 p.
• Kuang J.H. and Lin A.D. (1999): The effect of tooth wear on the vibration spectrum of a spur gear pair. - Design Engineering Technical Conference, paper DETC99/VIB-8102.
• Kuznetsova A.V. (2011): Measurement of teeth wear of bevel gears with circular biconvex-concave teeth by laser scanning. - Bulletin of the Eastern National University named after Volodymyr Dal, Lugansk, No.11 (165), Part 2, pp.77-85.
• Moldavski L.A., Finkelstein Z.L. and Verklov B.A. (1981): Damages types and durability of transmissions of mining machines. - Moscow, Nedra, 190 p.
• Myga J.R. (1976): Tooth wear influence on the size of the dynamic forces. - Ph.D. Thesis, University of Silesia, Gliwice.
• Onishchenko V. (1999): Durability prognostication of hard gear based on the modeling of teeth wear. - Gliwice, Mechanika, 131 p.
• STP 12.44.28.028 -76 (1976): Bevel gears with circular biconvex-concave teeth. - Standard of Enterprise, Moscow, vol.28 p.
• Voynarovskiy J. and Onishchenko V.P. (2000): Teeth wear effect on dynamic characteristics of the gear. - Ukrainian Scientific and Technical Journal. Vibrations in Appliances and Technologies, Vinnitsa State Agricultural University, Vinnitsa, No.1, pp.34-42.
• Wilk A. (1981): Influence of technological parameters and structural dynamics of gear teeth. - Scientific Papers of Silesian University of Technology, Mechanics, No.679, Gliwice, 108 p.
• Winkelbach S., Molkenstruck S. and Friedrich M. Wahl (2006): Low-cost laser range scanner and fast surface registration approach. - DAGM, LNCS 4174, pp.718-728.