Tytuł artykułu
Autorzy
Wybrane pełne teksty z tego czasopisma
Identyfikatory
Warianty tytułu
Języki publikacji
Abstrakty
The work presents test results of microhardness of surface layer of HS 6-5-2 high-speed steel from areas overlapping remelting. The surface layer of the steel was remelted using the GTAW method. The microhardness was measured using the Vickers method. The work shows that the area, where the heat influence zone of the second remelting overlapping on the first remelting zone is characterizes by the microhardness lower about approx. 200 HV0,065.
Czasopismo
Rocznik
Tom
Strony
25--28
Opis fizyczny
Bibliogr. 2 poz., rys., wykr.
Twórcy
autor
autor
- Institute of Technics, Rzeszow University, Rejtana 16 B, 35-310 Rzeszów, dziedzic@univ.rzeszow.pl
Bibliografia
- [1] L. Dobrzański, E. Hajduczek, L. Nowosielski, Physical metallurgy and heat treatment of tool material, WNT, Warsaw, 1990 (in Polish).
- [2] A. Dziedzic, The microstructure of HS 6-5-2 steel in the areas overlapping remelting obtained by the use of GTAW method, A paper is intended to be published in Archives of Foundry Engineering, Vol. 8, Katowice-Gliwice 2008.
Typ dokumentu
Bibliografia
Identyfikator YADDA
bwmeta1.element.baztech-article-BPZ3-0035-0005