Palm oil-based cutting fluids

• Autorzy: Raadnui S. , Mahathanabodee S.
• Konferencja: Third International Conference ITC 2004
• Języki publikacji: EN

Abstrakty

EN

There are no exact figures available as to how many machining operation are carried out without using "cutting fluids" or "coolants". However, there is no doubt that wet machining is applied very much more frequently than dry machining. Also, the oil embargo of 1973 brought needed attention to alternatives for petroleum oils. In addition, the pressure for increased use of vegetable oils in lubricants, due to both environmental and health and safety considerations, specifically on cutting fluids, is likely to continue. In addition, economic trends are likely to make vegetable oils increasingly more attractive than in the past in many areas of the globe. All these factors will probably result in an increase use of vegetable oil as lubricants. In this work, systematic research on palm oil-based cutting fluids characteristics assessment will be carried out.

Słowa kluczowe

EN

palm oil; cutting fluids

PL

obróbka skrawaniem; smar; chłodziwo obróbkowe

• Wydawca: Oficyna Wydawnicza Uniwersytetu Zielonogórskiego
• Czasopismo: International Journal of Applied Mechanics and Engineering
• Rocznik: 2004
• Tom: Vol. 9, no spec.
• Strony: 129--134
• Opis fizyczny: Bibliogr. 6 poz., fot., rys., tab.

Twórcy

autor

Raadnui S.

• Machinery Health Monitoring and Tribology Labolatory Department of Production Engineering, Faculty of Engineering King Mongkut's Institute of Technology North Bangkok (KMITNB) 1518 Pibulsongkram Road, Bang-Sue, 10800, Bangkok, THAILAND

autor

Mahathanabodee S.

• Machinery Health Monitoring and Tribology Labolatory Department of Production Engineering, Faculty of Engineering King Mongkut's Institute of Technology North Bangkok (KMITNB) 1518 Pibulsongkram Road, Bang-Sue, 10800, Bangkok, THAILAND

Bibliografia

• [1] ASTM D-2270 (1993): Practicing for calculating viscosity index from kinematic viscosity at 40°C and 100°C. - I vol.05.01, Petroleum Products and Lubricants (I): D 56 - D 2596.
• [2] ASTM D-445 (1994): Test method for kinematic viscosity of transparent and opaque liquids. - vol.05.01, Petroleum Products and Lubricants (I): D 56 - D 2596.
• [3] ASTM D-6078-97 (1997): standard test method for evaluating lubricity of diesel fuels by the scuffing load ball-on cylinder lubricity evaluator (SLBOCLE). - vol.05.02, Petroleum Products and Lubricants (II): D 2597 - D 5357.
• [4] El-wadany et al. (1996): Tool condition monitoring in drilling using vibration signature analysis. - Internationa Journal of Machine Tools Manufacturing, vol.36, No.6, pp.687-711.
• [5] Honary L.A. (1996): An investigation of the use of soybean oil in hydraulic system. - Bioresource Technology Journal vol.56, pp.41-47.
• [6] Machado A.R. and Wallbank J. (1997): The effect of extremely low lubrication volumes in machining. - Wear Journal vol.210, pp.76-82.