Study of Nb-Zn co-doped Ba(Ti,Zr)O3 ceramics

• Autorzy: Wang Y. , Zhuang Z. , Zhou J.
• Języki publikacji: EN

Abstrakty

EN

The surface coating processing technique was used to modify hydrothermally synthesized- Ba(Ti,Zr)O3 (BTZ) with an Nb-organic compound and Zn-organic compound in an organometallic precursor (Nb-EDTA and Zn-EDTA), which were coated on the powders uniformly. The sintering temperature was decreased and dense ceramics were obtained with well-developed grain growth at 1300 °C. Both increasing the amount of Nb–Zn and decreasing the Nb/Zn ratio greatly promoted grain growth. On increasing the Nb/Zn ratio, the Curie point temperature was markedly lowered, accompanied by a large decrease in the corresponding dielectric maximum and a simultaneous enhancement of the ferroelectric relaxor characteristic. At Nb/Zn = 2, the Curie temperature was monotonously lowered with increasing Nb–Zn content. The shift rate of the phase transition point of Nb–Zn co-doped BTZ was 6.5 °C/mol %. The corresponding dielectric maximum was enhanced rapidly from 9020 for a 0.35 mol % Nb–Zn doped sample to more than 12000 for a 0.90 mol % Nb–Zn doped sample.

Słowa kluczowe

EN

dielectric properties; barium titanate zirconium; Nb-Zn Co-doped; microstructure

PL

związki baru; właściwości dielektryczne; mikrostruktura; materiały ceramiczne

• Wydawca: De Gruyter
• Czasopismo: Materials Science Poland
• Rocznik: 2007
• Tom: Vol. 25, No. 1
• Strony: 121--127
• Opis fizyczny: Bibliogr. 11 poz.

Twórcy

autor

Wang Y.

autor

Zhuang Z.

autor

Zhou J.

• State Key Laboratory of New Ceramics and Fine Processing, Department of Materials Science and Engineering, Tsinghua University, Beijing 100084, China,

Bibliografia

• [1] NEIMAN S.M., J. Mater. Sci., 23 (1988), 3973.
• [2] FANG T.T., WU P.H., Mater. Chem. Phys., 72 (2002), 346.
• [3] HENNINGS D., SCHNELL A., SIMON G., J. Am. Ceram. Soc., 65 (1982), 539.
• [4] BUSCAGLIA M.T., BUSCAGLIA V., VIVIANI M., J. Eur. Ceram. Soc., 20 (2000), 1997.
• [5] WANG Y.L., LI L.T., QI J.Q., GUI Z., Ceram. Int., 28 (2002), 657.
• [6] HANSEN P., HENNINGS D., SCHREINEMACHER H., J. Electroceram., 2 (1998), 85.
• [7] WATANABE K., OHSATO H., KISHI H., OKINO Y., Solid State Ionics, 108 (1998), 129.
• [8] ABICHT H.P., ÖLTZKE D.V., SCHMIDT H., Mater. Chem. Phys., 51 (1997), 35.
• [9] BRUNO S.A., SWANSON D.K., J. Am. Ceram. Soc., 76 (1993), 1233.
• [10] ARMSTRONG T.R., MORGENS L.E., MAURICE A.K., BUCHANAN R.C., J. Am. Ceram. Soc., 72 (1989), 605.
• [11] CHAN N.H., SMYTH D.M., J. Am. Ceram. Soc., 67 (1984), 285.