The influence of a complete lower denture destabilization on the pressure of the mucous membrane foundation

• Autorzy: Żmudzki J. , Chladek G. , Kasperski J.
• Języki publikacji: EN

Abstrakty

EN

The results of previous studies on the pressures beneath the mucous membrane-supported dentures are contrary to the prevailing pain sensations and discomfort reported in practice. In this work, a FEM analysis of large displacements was used for calculation of the contact stresses beneath a lower denture that accompany destabilization under the realistic oblique mastication forces and stabilization of a non-working flange at the balancing contacts. The pressure on the surface of a mucous membrane beneath a denture that was loaded in a stable manner with a vertical occlusal force of 100 N was lower than the pain threshold. It was even more surprising as the extremely unfavorable lower denture foundation conditions were selected for this analysis. The lateral mastication forces destabilized the denture by means of tilting it and reducing its supporting area. Significant pressures calculated for the destabilization are consistent with the clinically observed decrease or a complete lack of chewing efficiency in the cases of unfavorable foundation conditions. A fundamental importance of the balancing contacts for the chewing efficiency was confirmed quantitatively. A remarkable development which has been achieved in the modeling of the denture functioning conditions is crucial for further biomechanical investigations of the mucous membrane-supported dentures, as well as for the implant-retained dentures.

Słowa kluczowe

EN

contact; denture pain; finite element method; force; pressure; stress

PL

kontakt; boląca proteza; metoda elementów skończonych; skuteczność; ciśnienie; stres

• Wydawca: Oficyna Wydawnicza Politechniki Wrocławskiej
• Czasopismo: Acta of Bioengineering and Biomechanics
• Rocznik: 2012
• Tom: Vol. 14, no. 3
• Strony: 67--73
• Opis fizyczny: Bibliogr. 34 poz., rys.

Twórcy

autor

Żmudzki J.

autor

Chladek G.

autor

Kasperski J.

• Institute of Material Science and Biomaterials, Silesian University of Technology, Katowice,

Bibliografia

• [1] SPIECHOWICZ E., Protetyka stomatologiczna, PZWL, Warszawa, 1992.
• [2] BRUNELLO D.L., MANDIKOS M.N., Construction faults, age, gender, and relative medical health: factors associated with complaints in complete denture patients, J. Prosthet. Dent., 1998, 79, 545–554.
• [3] JAINKITTIVONG A., ANEKSUK V., LANGLAIS V., Oral mucosal conditions in elderly dental patient, Oral. Diseases., 2002, 8(4), 218–223.
• [4] PANEK H., DOBOSZ A., SOSNA-GRAMZA M., NAPADŁEK P., Analiza dolegliwości zgłaszanych przez pacjentów dotyczących przeszłości protetycznej, Dent. Med. Probl., 2004, 41(3), 489–498.
• [5] EMAMI E., de GRANDMONT P., ROMPRÉ P.H., BARBEAU J., PAN S., FEINE J.S., Favoring Trauma as an Etiological Factor in Denture Stomatitis, J. Dent. Res., 2008, 87(5), 440–444.
• [6] TAKAYAMA Y., SASAKI H., GOTO M., MIZUNO K., SAITO M., YOKOYAMA A., Morphological factors of mandibular edentulous alveolar ridges influencing the movement of dentures calculated using finite element analysis, J. Prosthodont. Res., 2011, 55, 98–103.
• [7] INOUE S., KAWANO F., NAGAO K., MATSUMOTO N., An in vitro study of the influence of occlusal scheme on the pressure distribution of complete denture supporting tissues, Int. J. Prosthodont., 1996, 9(2), 179–187.
• [8] KAWASAKI T., TAKAYAMA Y., YAMADA T., NOTANI K., Relationship between the stress distribution and the shape of the alveolar residual ridge – three-dimensional behaviour of a lower complete denture, J. Oral. Rehabil., 2001, 28, 950–957.
• [9] TANAKA M., OGIMOTO T., KOYANO K., OGAWA T., Denture wearing and strong bite force reduce pressure pain threshold of edentulous oral mucosa, J. Oral. Rehabil., 2004, 31(9), 873–878.
• [10] OGAWA T., TANAKA M., OGIMOTO T., OKUSHI N., KOYANO K., TAKEUCHI K., Mapping, profiling and clustering of pressure pain threshold (PPT) in edentulous oral mucosa, J. Dent., 2004, 32, 219–228.
• [11] MIYASHITA K., SEKITA T., MINAKUCHI S., HIRANO Y., KOBAYASHI K., NAGAO M., Denture mobility with six degrees of freedom during function, J. Oral. Rehabil., 1998, 25(7), 545–552.
• [12] JAISSON M., LESTRIEZ P., TAIAR R., DEBRAY K., Finite element modelling of the articular disc behaviour of the temporo-mandibular joint under dynamic loads, Acta of Bioengineering and Biomechanics, 2011, 13(4), 85–91.
• [13] CZYŻ M., ŚCIGAŁA K., JARMUNDOWICZ W., BĘDZIŃSKI R., Numerical model of the human cervical spinal cord – the development and validation, Acta of Bioengineering and Biomechanics, 2011, 13(4), 51–58.
• [14] RANC H., ELKHYAT A., SERVAIS C., MAC-MARY S., LAUNAY B., HUMBERT Ph., Friction coefficient and wettability of oral mucosal tissue: Changes induced by a salivary layer, Colloids Surf. A, 2006, 276, 155–161.
• [15] SAJEWICZ E., Effect of saliva viscosity on tribological behaviour of tooth enamel, Tribol. Int., 2009, 42(2), 327–332.
• [16] ZIENKIEWICZ O.C., TAYLOR R.L., The Finite Element Method for Solid and Structural Mechanics, Sixth Edition, Elsevier Butterworth–Heinemann, 2005.
• [17] TAKAYAMA Y., SASAKI H., GOTO M., MIZUNO K., SAITO M., YOKOYAMA A., Morphological factors of mandibular edentulous alveolar ridges influencing the movement of dentures calculated using finite element analysis, J. Prosthodont. Res., 2011, 55(2), 98–103.
• [18] CHUN H.J., PARK D.N., HAN C.H., HEO S.J., HEO M.S., KOAK J.Y., Stress distributions in maxillary bone surrounding overdenture implants with different overdenture attachments, J. Oral. Rehabil., 2005, 32(3), 193–205.
• [19] DAAS M., DUBOIS G., BONNET A.S., LIPINSKI P., RIGNONBRET C., A complete finite element model of a mandibular implant-retained overdenture with two implants: comparison between rigid and resilient attachment configurations, Med. Eng. Phys., 2008, 30(2), 218–225.
• [20] BARBIER L., SLOTEN J.V., KRZESINSKI G., Van Der PERRE E.S., Finite element analysis of non-axial versus axial loading of oral implants in the mandible of the dog, J. Oral. Rehabil., 1998, 25, 847–858.
• [21] CHENG Y.Y., LI J.Y., FOK S.L., CHEUNG W.L., CHOW T.W., 3D FEA of high-performance polyethylene fiber reinforced maxillary dentures, Dent. Mater., 2010, 26(9), e211–219.
• [22] ŻAK M., KUROPKA P., KOBIELARZ M., DUDEK A., KALETA-KURATEWICZ K., SZOTEK S., Determination of the mechanical properties of the skin of pig foetuses with respect to its structure, Acta of Bioengineering and Biomechanics, 2011, 13(2), 37–43.
• [23] JÓZEFOWICZ W., Results of studies on elasticity moduli of the soft tissues of the denture-bearing area, (in Polish), Prot. Stom., 1970, 20(3), 171–176.
• [24] OHGURI T., KAWANO F., ICHIKAWA T., MATSUMOTO N., Influence of occlusal scheme on the pressure distribution under a complete denture, Int. J. Prosthodont., 1999, 12(4), 353–358.
• [25] ROEDEMA W.H., Relationship between the width of the occlusal table and pressures under dentures during function, J. Prosthet. Dent., 1976, 36, 24–34.
• [26] TAVELIN D., PSILLAKIS J., Adjustment of Complete Denture Occlusion with the Coble Balancer: A Case Report, Columbia Dent. Rev., 2006–2007, 11, 15–18.
• [27] DUBOJSKA A.M., WHITE G.E., PASIEK S., The importance of occlusal balance in the control of complete dentures, Quintessence Int., 1998, 29(6), 389–394.
• [28] MICHAEL C.G., JAVID N.S., COLAIZZI F.A., GIBBS D.H., Biting strength and chewing forces in complete denture wearers, J. Prosthet. Dent., 1990, 63, 549–553.
• [29] SLAGTER A.P., BOSMAN F., Van der GLAS H.W., Van der BILT A., Human jaw-elevator muscle activity and food comminution in dentate and edentulous state, Arch. Oral. Biol., 1993, 38, 195–205.
• [30] OGATA K., SATOH M., Centre and magnitude of vertical forces in complete denture wearers, J. Oral. Rehab., 1995, 22(2), 113–119.
• [31] ŻMUDZKI J., CHLADEK G., KASPERSKI J., Single implantretained dentures: loading of various attachment types under oblique occlusal forces, Journal of Mechanics in Medicine and Biology, (2012), 12(5), in press.
• [32] CHLADEK G., WRZUŚ-WIELIŃSKI M., The evaluation of selected attachment systems for implant-retained overdenture based on retention characteristics analysis, Acta of Bioengineering and Biomechanics, 2010, 12(3), 76–83.
• [33] CHLADEK G., MERTAS A., BARSZCZEWSKA-RYBAREK I., NALEWAJEK T., ŻMUDZKI J., KRÓL W., ŁUKASZCZYK J., Antifungal Activity of Denture Soft Lining Material Modified by Silver Nanoparticles – A Pilot Study, International Journal of Molecular Sciences, 2011, 12(7), 4735–4744.
• [34] CHLADEK G., BARSZCZEWSKA-RYBAREK I., ŁUKASZCZYK J., Developing the procedure of modifying the denture soft liner by silver nanoparticles, Acta of Bioengineering and Biomechanics, 2012, 14(1), 23–29.