Tytuł artykułu
Treść / Zawartość
Pełne teksty:
Identyfikatory
Warianty tytułu
Języki publikacji
Abstrakty
The quality of the silicon-buried oxide bonded interface of SOI devices created by thin Si film transfer and bonding over pre-patterned cavities, aiming at fabrication of DG and SON MOSFETs, is studied by means of chargepumping (CP) measurements. It is demonstrated that thanks to the chemical activation step, the quality of the bonded interface is remarkably good. Good agreement between values of front-interface threshold voltage determined from CP and I-V measurements is obtained.
Rocznik
Tom
Strony
61--66
Opis fizyczny
Bibliogr.7 poz., rys., tab.
Twórcy
autor
autor
autor
autor
autor
autor
autor
- Institute of Microelectronics and Optoelectronics, Warsaw University of Technology Koszykowa st 75, 00-662 Warsaw, Poland, ggluszko@elka.pw.edu.pl
Bibliografia
- [1] F. Balestra, S. Cristoloveanu, M. Benachir, J. Brini, and T. Elewa, “Double-gate silicon-on-insulator MOSFET with volume inversion”, IEEE Electron Dev. Lett., vol. 8, pp. 410–412, 1987.
- [2] T. M. Chung, B. Olbrechts, U. Södervall, S. Bengtsson, D. Flandre, and J.-P. Raskin, “Planar double-gate SOI MOS devices: fabrication by wafer bonding over pre-patterened cavities and electrical characterization”, Solid-State Electron., vol. 51, no. 2, pp. 231–238, 2007.
- [3] S. I. Lai, H. Y. Lin, and C. T. Hu, “Effects of surface treatment on wafer direct bonding process”, Mater. Chem. Phys., vol. 83, pp. 265–272, 2004.
- [4] D. Flandre et al., “Fully depleted SOI CMOS technology for heterogeneous micropower, high-temperature or RF microsystems”, Solid-State Electron., vol. 45, pp. 541–549, 2001.
- [5] T. Ouisse et al., “Adaptation of the charge pumping technique to gated PIN diodes fabricated on silicon on insulator”, IEEE Trans. Electron Dev., vol. 38, pp. 1432–1444, 1991.
- [6] A. Jakubowski, W. Marciniak, and H. M. Przewłocki, Diagnostic Measurements in LSI/VLSI Integrated Circuits Production. Singapore: World Scientific, 1991.
- [7] M. Bruel, “Silicon on insulator material technology”, Electron. Lett., vol. 31, pp. 1201–1202, 1995.
Typ dokumentu
Bibliografia
Identyfikator YADDA
bwmeta1.element.baztech-article-BAT8-0009-0068