Tytuł artykułu
Autorzy
Wybrane pełne teksty z tego czasopisma
Identyfikatory
Warianty tytułu
Recycling of glass-reinforced polyester laminates
Konferencja
Materiały V Kongresu Technologii Chemicznej : Poznań, 11-15 września 2006 r.
Języki publikacji
Abstrakty
Przedstawiono wyniki badań nad możliwościami recyklingu materiałowego utwardzonych żywic poliestrowych wzmocnionych włóknami szklanymi. Zaproponowano sposoby zastosowania rozdrobnionych laminatów do produkcji lekkich przekładek oraz jako napełniaczy w polimerobetonach.
Waste glass-reinforced polyester laminates were comminuted to <4 mm, glass fibers 32% in a <0.5-mm (fraction amt. 35%) and 47% in a >2.5-mm fraction (fraction amt. 43.2%), av. glass content 42%, and compressed with fly-ash microspheres, 18– 35%, added to minimize the share of a polyester resin, 15–30% (used as binder), for 2 hrs./80°C into 220 × 350 ×10-mm light core plates. The plates contg. recyclate 55, microspheres 18, and resin 27% had d. 1.71 g/cm3, bending strength 23 MPa (25% better than standard), and bending modulus 4476 MPa. The plate’s compression strength was only slightly lower than that of a standard laminate. The other compns. were inferior. Also the standard formulation of polymer concrete viz., quartz flour 14, sand 30, gravel 44, and polyester resin 12%, was modified by adding 5%, or by substituting 3–5%, recyclate for quartz flour. The resulting polymeric concretes had bending strengths higher by 12–25% and compression strength lower by 4– 55%. The addn of the recyclate was optimum at 5%, the best was 2 or 5% quartz flour replaced by 2% of 2–2.5-mm or 5% of >4-mm recyclate fraction.
Wydawca
Czasopismo
Rocznik
Tom
Strony
913--914
Opis fizyczny
Bibliogr. 5 poz., rys., tab.
Twórcy
autor
- Politechnika Szczecińska, kgoracy@ps.pl
Bibliografia
- 1. W. Nowaczek, Polymer Recycling 2000, 5, 91.
- 2. W. Nowaczek, Polimery 1999, 44, 758.
- 3. A.K. Błędzki, K. Gorący, Mechanics of Composite Materials 1993, 29, 473.
- 4. K. Gorący, A.K. Błędzki, Polimery 1994, 39, 507.
- 5. J.V. Milewski, H.S. Katz, Handbook of reinforcement for plastics, Van Nostran Reinhold, New York 1987.
Typ dokumentu
Bibliografia
Identyfikator YADDA
bwmeta1.element.baztech-article-AGHM-0042-0040