Performance of reinforced concrete beams cast with different percentages of GGBS replacement to cement

• Autorzy: Hawileh R. A. , Abdalla J. A. , Fardmanesh F. , Shahsana P. , Khalili A.

Identyfikatory

DOI

10.1016/j.acme.2016.11.006

• Języki publikacji: EN

Abstrakty

EN

The aim of this paper is to study the effect of using Ground Granulated Blast Furnace Slag (GGBS) as a partial replacement to cement in reinforced concrete (RC) beams. A total of eight beams were cast with different percentages of GGBS replacement of 0%, 50%, 70%, and 90%, respectively. The performance of the tested specimens were evaluated and compared to that of a control beam without GGBS (0%). In addition, the concrete compressive and tensile strength of the different concrete mixes were evaluated and compared. Overall, test results indicated that the compressive and tensile strength of the different mixtures were quite similar. In addition, the performance of RC beams with GGBS replacement up to 70% is similar to that without GGBS. However, the stiffness and strength for the beam specimens with 90% GGBS were lower than that without GGBS by 16% and 6%, respectively. It was also concluded that the use of high percentage of GGBS up to 70% as a replacement to cement is practical and will not comprise the performance of RC beams. Furthermore, such replacement will contribute to the reduction in CO2 emission (carbon footprint) and therefore encourage the use of such sustainable and green concrete.

Słowa kluczowe

EN

ground granulated blast furnace slag; cement; compressive strength; flexural strength; reinforced concrete beam

PL

cement; wytrzymałość na ściskanie; wytrzymałość na zginanie; beton zbrojony; belka betonowa

• Wydawca: Springer ; Wrocław University of Science and Technology
• Czasopismo: Archives of Civil and Mechanical Engineering
• Rocznik: 2017
• Tom: Vol. 17, no. 3
• Strony: 511--519
• Opis fizyczny: Bibliogr. 42 poz., fot., rys., tab., wykr.

Twórcy

autor

Hawileh R. A.

• Department of Civil Engineering, American University of Sharjah, P.O. Box 26666, Sharjah, United Arab Emirates

autor

Abdalla J. A.

• Department of Civil Engineering, American University of Sharjah, P.O. Box 26666, Sharjah, United Arab Emirates

autor

Fardmanesh F.

• Department of Civil Engineering, American University of Sharjah, P.O. Box 26666, Sharjah, United Arab Emirates

autor

Shahsana P.

• Department of Civil Engineering, American University of Sharjah, P.O. Box 26666, Sharjah, United Arab Emirates

autor

Khalili A.

• Department of Civil Engineering, American University of Sharjah, P.O. Box 26666, Sharjah, United Arab Emirates

Bibliografia

• [1] S. Teng, T.Y.D. Lim, B.S. Divsholi, Durability and mechanical properties of high strength concrete incorporating ultra fine Ground Granulated Blast-furnace Slag, Construction and Building Materials 40 (2013) 875–881.
• [2] B. O'Rourke, C. McNally, M.G. Richardson, Development of calcium sulfate-GGBS – Portland cement binders, Construction and Building Material 23 (1) (2009) 340–346.
• [3] S.O. Ogbeide, Developing an optimization model for CO2 reduction in cement production process, Engineering Science and Technology Review 3 (1) (2010) 85–88.
• [4] E. Benhelal, G. Zahedi, E. Shamsaei, A. Bahadori, Global strategies and potentials to curb CO2 emissions in cement industry, The Journal of Cleaner Production 51 (2013) 142–161.
• [5] K.H. Yang, K.H. Lee, J.K. Song, M.H. Gong, Properties and sustainability of alkali-activated slag foamed concrete, The Journal of Cleaner Production 68 (2014) 226–233.
• [6] R. Kajaste, M. Hurme, Cement industry greenhouse gas emissions e management options and abatement cost, The Journal of Cleaner Production 112 (5) (2016) 4041–4052.
• [7] G. Hebert, J.B. D'Espinose de Lacaillerie, N. Roussel, An environmental evaluation of geopolymer based concrete production: reviewing current research trends, The Journal of Cleaner Production 19 (11) (2011) 1229–1238.
• [8] K.H. Yang, J.K. Song, K.I. Song, Assessment of CO2 reduction of alkali-activated concrete, The Journal of Cleaner Production 39 (2013) 265–272.
• [9] K.H. Yang, Y.B. Jung, M.S. Cho, S.H. Tae, Effect of supplementary cementitious materials on reduction of CO2 emissions from concrete, The Journal of Cleaner Production 103 (2015) 774–783.
• [10] R. Siddique, R. Bennacer, Use of iron and steel industry by-product (GGBS) in cement paste and mortar, Resources, Conservation and Recycling 69 (2012) 29–34.
• [11] Z. Sun, C. Young, Bleeding of SCC pastes with fly ash and GGBFS replacement, Journal of Sustainable Cement-Based Materials 3 (3–4) (2014) 220–229.
• [12] S.D. Wang, A.S. Read, Slag blended cement and concrete, Science and Technology for the Built Environment 3 (1) (1996) 27–34.
• [13] S. Kumar, R. Kumar, A. Bandopadhyay, T.C. Alex, B.R. Kumar, S.K. Das, S.P. Mehrotra, Mechanical activation of granulated blast furnace slag and its effect on the properties and structure of Portland slag cement, Cement and Concrete Composites 30 (8) (2008) 679–685.
• [14] F. Bellmann, J. Stark, Activation of blast furnace slag by a new method, Cement and Concrete Research 39 (8) (2009) 644–650.
• [15] E.R. Grist, K.A. Paine, A. Heath, J. Norman, H. Pinder, The environmental credentials of hydraulic lime-pozzolan concretes, The Journal of Cleaner Production 93 (2015) 26–37.
• [16] B.H. Nagaratnam, M.E. Rahman, A.K. Mirasa, M.A. Mannan, S. O. Lame, Workability and heat of hydration of self-compacting concrete incorporating agro-industrial waste, The Journal of Cleaner Production 112 (1) (2015) 882–894.
• [17] A. Oner, S. Akyuz, An experimental study on optimum usage of GGBS for the compressive strength of concrete, Cement & Concrete Composites 29 (6) (2007) 505–514.
• [18] G. Babu, S.R. Kumar, Efficiency of GGBS in concrete, Cement and Concrete Research 30 (7) (2000) 1031–1036.
• [19] C. Bilim, C.D. Atis, H. Tanyildizi, O. Karahan, Predicting the compressive strength of ground granulated blast furnace slag concrete using artificial neural network, Advances in Engineering Software 40 (5) (2009) 334–340.
• [20] V.B. Bouny, M. Dierkens, X. Wang, A. Soive, M. Saillio, M. Thiery, B. Thauvin, Ageing and durability of concrete in lab and in field conditions: investigation of chloride penetration, Journal of Sustainable Cement-Based Materials 2 (2) (2013) 67–110.
• [21] S.C. Bostanc, M. Limbachiya, H. Kew, Portland slag and composites cement concretes: engineering and durability properties, The Journal of Cleaner Production 112 (1) (2016) 542–552.
• [22] G. Osborne, Durability of Portland blast-furnace slag cement concrete, Cement and Concrete Composites 21 (1) (1998) 11–21.
• [23] A. Cheng, R. Huang, J.K. Wu, C.H. Chen, Influence of GGBS on durability and corrosion behavior of reinforced concrete, Material Chemistry and Physics 93 (2–3) (2005) 404–411.
• [24] L. Bertolini, Steel corrosion and service life of reinforced concrete structures, Structure and Infrastructure Engineering 4 (2) (2008) 123–137.
• [25] I.B. Topcu, A.R. Boga, Effect of ground granulate blast-furnace slag on corrosion performance of steel embedded in concrete, Materials and Design 31 (7) (2010) 3358–3365.
• [26] S.J. Barnett, S.G. Millard, J.H. Bungey, Strength development of mortars containing ground granulated blast-furnace slag: effect of curing temperature and determination of apparent activation energies, Cement and Concrete Research 36 (3) (2005) 434–440.
• [27] S.E. Chidaic, D.K. Panesar, Evolution of mechanical properties of concrete containing ground granulated blast furnace slag and effects on the scalling resistance test at 28 days, Cement and Concrete Composite 30 (2) (2007) 63–71.
• [28] Z. Chen, Y. Yang, Y. Yao, Quasi-static and dynamic compressive mechanical properties of engineered cementitious composite incorporating ground granulated blast furnace slag, Materials and Design 44 (2013) 500–508.
• [29] P. Dinakar, K.P. Sethy, U.C. Sahoo, Design of self-compacting concrete with ground granulated blast furnace slag, Materials and Design 43 (2013) 161–169.
• [30] C.J. Tsai, R. Huang, W.T. Lin, H.N. Wang, Mechanical and cementitious characteristics of ground granulated blast furnace slag and basic oxygen furnace slag blended mortar, Materials and Design 60 (2014) 267–273.
• [31] D. Chithra, M. Nazeer, Strength and chloride permeability studies on ground granulated blast furnace slag admixed medium strength concrete, in: IEEE Proc. International Conf. on Green Technologies (ICGT), 2012, 103–106.
• [32] K.H. Mo, U.J. Alengaram, M.Z. Jumaat, M.Y.J. Liu, J. Lim, Assessing some durability properties of sustainable lightweight oil palm shell concrete incorporating slag and manufactured sand, The Journal of Cleaner Production 112 (1) (2015) 763–770.
• [33] E.G. Taengua, M. Sonebi, P. Crossett, S. Taylor, P. Deegan, L. Ferrara, A. Pattarini, Performance of sustainable SCC mixes with mineral additions for use in precast concrete industry, Journal of Sustainable Cement-Based Materials 5 (3) (2016) 157–175.
• [34] A. Islam, U.J. Alengaram, M.Z. Jumaat, I.I. Bashar, The development of compressive strength of ground granulated blast furnace slag-palm oil fuel ash-fly ash based geopolymer mortar, Materials and Design 56 (2014) 833–841.
• [35] K.Y. Yeau, E.K. Kim, An experimental study on corrosion resistance of concrete with ground granulate blast-furnace slag, Cement and Concrete Research 35 (2005) 1391–1399.
• [36] M.K. Khan, U. Ghani, Effect of blending of portland cement with ground granulated blast furnace slag on the properties of concrete, in: Proc. of the 29th Conference on Our World in Concrete & Structures, Premier PTE LTD, Singapore, (2004) 329–334.
• [37] M. Elchalakani, T. Aly, E. Abu-Aisheh, Sustainable concrete with high volume GGBFS to build Masdar city in the UAE, Case Studies in Construction Materials 1 (2014) 10–24.
• [38] S.P. Sangeetha, P.S. Joanna, Flexural behaviour of reinforced concrete beams with GGBS, International Journal of Civil Engineering and Technology 5 (3) (2014) 124–131.
• [39] S. Patel, B. Balakrishna, Flexural behaviour of reinforced concrete beams replacing GGBS as cement and slag sand as fine aggregates, International Journal of Civil and Structural Engineering Research 2 (1) (2014) 66–75.
• [40] European Standard EN 197-1, Cement: Part 1: Composition, Specifications and Conformity Criteria for Common Cements, Brussels, CEN, 2001.
• [41] European Standard BS EN 15167-1, Ground Granulated Blast Furnace Slag for Use in Concrete, Mortar and Grout. Definitions, Specifications and Conformity Criteria, CEN, Brussels, 2006.
• [42] ACI Committee 318, Building Code Requirements for Structural Concrete and Commentary, American Concrete Institute, Farmington Hills (MI), 2011. p. 503.

Uwagi

PL

Opracowanie ze środków MNiSW w ramach umowy 812/P-DUN/2016 na działalność upowszechniającą naukę (zadania 2017)