Analysis of parameters variability of compression ring and cylinder liner collaboration during engine operation

• Autorzy: Serdecki W. , Krzymień P.
• Języki publikacji: EN

Abstrakty

EN

Construction of piston-rings-liner assembly of contemporary engines of low and medium power secures a long time reliable operation. In the case of engines of higher output, e.g. marine and railway ones still occur failures caused by improper collaboration of piston rings and cylinder liner. One can mention variations in collaboration surface and difficulties with supply and proper distribution of lubricating oil over the entire surface of cylinder liner among the most important ones. Changes in value of parameters characteristic for compression ring and cylinder liner collaboration that occur during engine run have been analyzed in the following study. Attention has been paid to the ability of ring contact with the liner, especially those features that cause the formation of light slots between ring face and liner surface. Drafts presented in the paper show the results of compression ring pressure distribution and the geometry of light slots carried out for technical data of the earth moving machine engine. Simulation computations take into account both the effect of engine operation cycle phase and selected stages of its run as well.

Słowa kluczowe

EN

IC engine; liner deformation; piston ring; ring elastic pressure

PL

silnik spalinowy; deformacje liniowe; pierścień tłokowy; pierścień elastyczny ciśnienia

• Wydawca: Faculty of Ocean Engineering and Ship Technology, Gdańsk University of Technology
• Czasopismo: Journal of Polish CIMAC
• Rocznik: 2014
• Tom: Vol. 9, no 1
• Strony: 121--128
• Opis fizyczny: Bibliogr. 9 poz., rys., wykr.

Twórcy

autor

Serdecki W.

• Institute of Combustion Engines and Transport Poznań University of Technology 3, Piotrowo St., 60 965 Poznań tel.[phone]

autor

Krzymień P.

• Institute of Combustion Engines and Transport Poznań University of Technology 3, Piotrowo St., 60 965 Poznań tel.[phone]

Bibliografia

• [1] Bardzimashvili T., Kell j., Romelashvili E., Distortion inside a piston bore. Michigan State University MTH 844, 2004.
• [2] Bronsztajn I.N., Siemiendiajew K.A., Matematyka. PWN, Warszawa 1986.
• [3] Iskra A., Studium konstrukcji i funkcjonalności pierścieni w grupie tłokowo-cylindrowej. Wydawnictwo PP, Poznań 1996.
• [4] Mittler R., Mierbach A., Richardson D., Understanding the Fundamentals of piston ring axial motion and twist and the effects on blow - by. Proceedings of the Internal Combustion Engine Division ASME, ICES2009-76080.
• [5] Serdecki W., Determination of compression ring wall pressure distribution. Journal of POLISH CIMAC. Energetic aspects, Gdańsk 2010, Vol. 5, No.1.
• [6] Serdecki W., Analysis of relations between the compression ring characteristic parameters. Journal of POLISH CIMAC. Energetic aspects, Gdańsk 2011, Vol.6, No.2.
• [7] Serdecki W., Analysis of ring pressure distribution on a deformed cylinder face. Journal of POLISH CIMAC. Energetic aspects, Gdańsk 2012, Vol. 7, No. 1.
• [8] Serdecki W., Krzymień P., An analysis of phenomena accompanying ring collaboration with worn cylinder surface. W: Combustion Engines, No. 2/2013.
• [9] Serdecki W., Variability of compression ring pressure against the deformed cylinder wall during engine operation. Journal of POLISH CIMAC Energetic aspects, Gdańsk 2013, Vol. 8.