Understanding Geotechnical Embankment Washout Due to Overtopping: Insights From Physical Tests

• Autorzy: Urbaniak Mikołaj , Zamiar Krzysztof , Kostecki Stanisław

Identyfikatory

DOI

10.2478/sgem-2024-0025

• Języki publikacji: EN

Abstrakty

EN

Understanding the erosion process of an earth dam and flood embankment composed of noncohesive, homogeneous soils due to overflow is crucial for determining the quantity and rate of water release. This is necessary to assess the consequences of a failure, analyze the risk, and develop appropriate crisis management procedures. Despite numerous studies in this area, the process of breach evolution is not fully explored. The article presents the results of physical experiments carried out in the field laboratory of the Wrocław University of Science and Technology for a dam with a height of 0.50 m that closes a reservoir with a capacity of 14.4 m³, whose width is significantly greater than the final width of the breach. The scenario analyzed assumes that water overflows the embankment crest, as it is the most common cause of embankment failure based on dam disaster databases. At the same time, the amount of water accumulated in the reservoir is the largest possible for this scenario, suggesting that such a catastrophe may have the most severe consequences. Based on the results obtained from three experiments, four repeatable phases of erosion evolution were identified and described: (I) the initiation phase, (II) the vertical erosion phase, (III) the lateral erosion phase, divided into two cycles, and (IV) the reservoir emptying phase without further propagation of the breach. The outflow rate of the water from the reservoir was also analyzed, allowing the determination of the outflow hydrograph for each test. Hydrographs showed differences between individual experiments; however, the average erosion rate was similar for all tests. Furthermore, the final width of the breach created each time was between 2.2 and 2.5 H (where H is the height of the embankment) and the volume of eroded soil ranged from 0.52 to 0.59 m³. The article also highlights the methodology to calculate the water outflow hydrograph.

Słowa kluczowe

EN

dam safety; flood risk management; overtopping; embankment dam; laboratory tests; breach parameters; breach mechanism

• Wydawca: De Gruyter
• Czasopismo: Studia Geotechnica et Mechanica
• Rocznik: 2024
• Tom: Vol. 46, nr 4
• Strony: 328--336
• Opis fizyczny: Bibliogr. 12 poz., rys., tab.

Twórcy

autor

Urbaniak Mikołaj

• Wroclaw University of Science and Technology Wroclaw, Poland

autor

Zamiar Krzysztof

• Wroclaw University of Science and Technology Wroclaw, Poland

autor

Kostecki Stanisław

• Wroclaw University of Science and Technology Wroclaw, Poland

Bibliografia

• [1] Abdellatif Mohamed, M. M., & El-Ghorab, E. A. S. (2016). Investigating scale effects on breach evolution of overtopped sand embankments. Water Science, 30(2), 84–95. https://doi.org/10.1016/j.wsj.2016.10.003
• [2] Asghari Tabrizi, A., Elalfy, E., Elkholy, M., Chaudhry, M. H., & Imran, J. (2017). Effects of compaction on embankment breach due to overtopping. Journal of Hydraulic Research, 55(2), 236–247. https://doi.org/10.1080/00221686.2016.1238014
• [3] Ashraf, M., Soliman, A. H., El-Ghorab, E., & Zawahry, A. El. (2018). Assessment of embankment dams breaching using large scale physical modeling and statistical methods. Water Science, 32(2), 362–379. https://doi.org/10.1016/j.wsj.2018.05.002
• [4] Bento, A. M., Amaral, S., Viseu, T., Cardoso, R., & Ferreira, R. M. L. (2017). Direct Estimate of the Breach Hydrograph of an Overtopped Earth Dam, 143 (6). https://doi.org/10.1061/(ASCE)HY.1943-7900.000129
• [5] Chinnarasri, C., Jirakitlerd, S., & Wongwises, S. (2004). Embankment dam breach and its outflow characteristics. Civil Engineering and Environmental Systems, 21(4), 247–264. https://doi.org/10.1080/10286600412331328622
• [6] Coleman, S. E., Andrews, D. P., & Webby, M. G. (2002). Overtopping Breaching of Noncohesive Homogeneous Embankments. https://doi.org/10.1061/ASCE0733-94292002128:9829
• [7] Kansoh, R. M., Elkholy, M., & Abo-Zaid, G. (2020). Effect of Shape Parameters on Failure of Earthen Embankment due to Overtopping. KSCE Journal of Civil Engineering, 24(5), 1476–1485. https://doi.org/10.1007/s12205-020-1107-x
• [8] Li, Y., Tian, C., Wen, L., Chen, A., Wang, L., Qiu, W., & Zhou, H. (2021). A study of the overtopping breach of a sand-gravel embankment dam using experimental models. Engineering Failure Analysis, 124. https://doi.org/10.1016/j.engfailanal.2021.105360
• [9] Orendorff, B., Rennie, C. D., & Nistor, I. (2011). Using PTV through an embankment breach channel. Journal of Hydro-Environment Research, 5(4), 277–287. https://doi.org/10.1016/j.jher.2010.12.003
• [10] Soliman, A. (2015). Hydrological Impacts of Renaissance Dam Failure on the Downstream up to the High Awan Dam, Ph.D Thesis. Faculty of Engineering, Cairo University, Giza, Egypt.
• [11] Webby, M.G. (1995). Discussion of „Peak outflow from breached embankment dam”. Journal of Water Resources Planning and Management, 1996, 122(4), 316–317.
• [12] Zhong, Q., Wang, L., Chen, S., Chen, Z., Shan, Y., Zhang, Q., Ren, Q., Mei, S., Jiang, J., Hu, L., & Liu, J. (2021). Breaches of embankment and landslide dams - State of the art review. In Earth-Science Reviews (Vol. 216). Elsevier B.V. https://doi.org/10.1016/j.earscirev.2021.103597