FEM Simulation of Deep Drawing Process of Aluminium Alloys

• Autorzy: Slota J. , Gajdos I. , Jachowicz T. , Siser M , Krasinskyi V.
• Języki publikacji: EN

Abstrakty

EN

This paper presents results of research with FEM simulation of sheet metal forming process. The two types of aluminium alloys from 5XXX and 6XXX series, which are used in automotive industry, were compared. The computer simulation and numerical analysis of deep drawing cup test were used to predict the ability of the forming of these alloys. The plasticity model Hill'90 was used for stamping simulations. The results of numerical simulation were validated by real experiment using sheet metal testing machine Erichsen 145-60. Both results were compared with regard to prediction accuracy in changes of thickness and ear profile.

Słowa kluczowe

EN

deep drawing; Al alloys; sheet metal; numerical simulation

• Wydawca: Polskie Towarzystwo Promocji Wiedzy ; Lublin University of Technology
• Czasopismo: Applied Computer Science
• Rocznik: 2015
• Tom: Vol. 11, no 4
• Strony: 7--19
• Opis fizyczny: Bibliogr. 7 poz., fig., tab.

Twórcy

autor

Slota J.

• Technical University of Košice, Faculty of Mechanical Engineering, Institute of Technologies and Management, Mäsiarska 74 St., 04001 Košice, Slovakia

autor

Gajdos I.

• Technical University of Košice, Faculty of Mechanical Engineering, Institute of Technologies and Management, Mäsiarska 74 St., 04001 Košice, Slovakia

autor

Jachowicz T.

• Lublin University of Technology, Faculty of Mechanical Engineering, Department of Polymer Processing, Nadbystrzycka 36 St.

autor

Siser M

• Technical University of Košice, Faculty of Mechanical Engineering, Institute of Technologies and Management, Mäsiarska 74 St., 04001 Košice, Slovakia

autor

Krasinskyi V.

• Lviv Polytechnic National University, Department of Chemical Technology of Plastics, S. Bandery 12 St., 79013 Lviv, Ukraine

Bibliografia

• [1] Zhou J., Wang B., Lin J., Fu L.: Optimization of an aluminium alloy anti-collision side beam hot stamping process using a multi-objective genetic algorithm. Archives of Civil and Mechanical Engineering, Vol. 13, 2013, pp. 401-411.
• [2] Abe Y., Ohmi T., Mori K., Masuda T.: Improvement of formability in deep drawing of ultra-high strength steel sheet by coating of die. Journal of Mechanical Processing Technology, Vol. 214, 2014, pp. 1838-1843.
• [3] Millerw S. et al.: Recent development in aluminium alloys for the automotive industry. Material Science and Engineering, A280, 2000, pp. 37-49.
• [4] Mao T., Altan T.: Aluminium sheet forming for automotive applications. Part I., Stamping Journal, 2013.
• [5] Zhou J., Wang B., Jin J., Fu L., Ma W.: Forming defects in aluminium alloy hot stamping of side-door impact beam. Transactions of Nonferrous Metals Society of China, Vol. 24, 2014, pp. 3611-3620.
• [6] Laurent H., Coër J., Manach P. Y., Oliveira M. C., Menezes L. F.: Experimental and numerical studies on the warm deep drawing of an Al-Mg alloy. International Journal of Mechanical Sciences, Vol. 93, 2015, pp. 59-72.
• [7] Bruschi S. et al.: Testing and modelling of material behaviour and formability in sheet metal forming. CIRP Annals – Manufacturing Technology, Vol. 63, 2014, pp. 727-749.