Analysis of z-axis kinematics influence on measurement result

• Autorzy: Gruza M. , Harmatys W , Gąska P. , Gąska A. , Sładek J.

Identyfikatory

DOI

10.12913/22998624/2373

• Języki publikacji: EN

Abstrakty

EN

CMMs accuracy depend on a number of factors. In spite of using various methods for CMM correction, the differences can be observed in the metrological capability be¬tween the areas in the measuring volume of CMM. Authors attempted to estimate the impact of one of potential CMM accuracy influencing factors, a CMM Z-axis position during measurement, on measurement result. This article presents performed experi¬ments and obtained results.

Słowa kluczowe

EN

CMM accuracy; CMM kinematics

• Wydawca: Lublin University of Technology ; Polish Society of Ecological Engineering (PTIE), Branch of PTIE in Lublin
• Czasopismo: Advances in Science and Technology. Research Journal
• Rocznik: 2015
• Tom: Vol. 9, nr 26
• Strony: 109–--112
• Opis fizyczny: Bibliogr. 8 poz., fig., tab.

Twórcy

autor

Gruza M.

• Laboratory for Coordinate Metrology (M-10), Faculty of Mechanical Engineering, Cracow University of Technology, Jana Pawła II 37, 31-864 Kraków, Poland

autor

Harmatys W

• Laboratory for Coordinate Metrology (M-10), Faculty of Mechanical Engineering, Cracow University of Technology, Jana Pawła II 37, 31-864 Kraków, Poland

autor

Gąska P.

• Laboratory for Coordinate Metrology (M-10), Faculty of Mechanical Engineering, Cracow University of Technology, Jana Pawła II 37, 31-864 Kraków, Poland

autor

Gąska A.

• Laboratory for Coordinate Metrology (M-10), Faculty of Mechanical Engineering, Cracow University of Technology, Jana Pawła II 37, 31-864 Kraków, Poland

autor

Sładek J.

• Laboratory for Coordinate Metrology (M-10), Faculty of Mechanical Engineering, Cracow University of Technology, Jana Pawła II 37, 31-864 Kraków, Poland

Bibliografia

• 1. Gąska A.: Modeling the accuracy of coordinate measurement with use of Monte Carlo method. Ph.D. Dissertation, Cracow University of Technology, 2011.
• 2. Sładek J. Accuracy of coordinate measurements. Cracow University of Technology, Cracow 2013.
• 3. Weckenmann A., EstlerT., PeggsG., McMurtryD.: Probing systems in dimensional metrology. CIRP Annals Manufacturing Technology, 53, 2, 657–684.
• 4. Gąska A., Gruza M., Gąska P., Karpiuk M., Sładek J.: Identification and correction of coordinate measuring machine geometrical errors using Laser Tracer systems. Advances in Science and Technology Research Journal, 7, 20, 2013, 17–22.
• 5. Hocken R.J., Pereira P.H. (eds.): Coordinate measuring machines and systems. Second edition, CRC Press, 2012. 6. Sładek J.:Modelowanie i ocena dokładności maszyn oraz pomiarów współrzędnościowych. Praca habilitacyjna. Wydział Mechaniczny, Politechnika Krakowska, 2001.
• 7. Weekers W.G., Schellekens P.H.J.: Compensation for dynamic errors of coordinate measuring machines. Measurement 20, 3, 1997, 197–209.
• 8. ISO 10360 part 5, 2010. CMMs using single and multiple stylus contacting probing systems. Second edition.