Obtaining and Analyzing the Al₂O₃-ZrO₂ Ceramic Layers on Metallic Substrate

• Autorzy: Lutcanu Marian , Coteață Margareta , Bernevig Mihai Adrian , Nechifor Cristina-Delia , Cazacu Marius Mihai , Paraschiv Petronela , Istrate Bogdan , Bădărău Gheorghe , Sandu Ioan Gabriel , Cimpoeșu Nicanor

Identyfikatory

DOI

10.24425/amm.2022.137780

• Języki publikacji: EN

Abstrakty

EN

In this case ceramic layers from Metco ZrO₂ and Al₂O₃ powders mixture (25/75; 50/50 and 75/25) were obtained through atmospheric plasma spraying (APS) after five passes on low carbon steel substrate. The sample surfaces mechanically grinded (160-2400) before and after ceramic layer deposition. Powder’s mixtures and the surface of ceramic thin layers were analyzed through: scanning electron microscopy (SEM). In order to understand the effect of surface wettability of the ceramic layers, before and after grinding the surface, three different liquids were used. Experimental results confirm the modification of the steel substrate surface characteristic from hydrophilic to hydrophobic when the ceramic layer was deposited. Surface free energy of hydration increases for all the samples with zirconia percentage addition before polishing process.

Słowa kluczowe

EN

ceramic layer; atmospheric plasma spraying; SEM; EDS

• Wydawca: Institute of Metallurgy and Materials Science of Polish Academy of Sciences ; Committee of Materials Engineering and Metallurgy of Polish Academy of Sciences
• Czasopismo: Archives of Metallurgy and Materials
• Rocznik: 2022
• Tom: Vol. 67, iss. 2
• Strony: 479--485
• Opis fizyczny: Bibliogr. 18 poz., fot., rys., tab., wykr., wzory

Twórcy

autor

Lutcanu Marian

• Gheorghe Asachi Technical University of Iasi, Faculty of Materials Science and Engineering, Prof. dr. doc. D. Mangeron no. 41 Street, 700050 Iasi, Romania
• Gheorghe Asachi Technical University of Iasi, Department of Physics, 700050 Iasi, Romania

• https://orcid.org/0000-0002-4177-3881

autor

Coteață Margareta

• Gheorghe Asachi Tech Univ Iasi, Dept Machine Mfg Technol, 59A D Mangeron Blvd, Iasi 700050, Romania

• https://orcid.org/0000-0003-0443-1441

autor

Bernevig Mihai Adrian

• Gheorghe Asachi Technical University of Iasi, Faculty of Materials Science and Engineering, Prof. dr. doc. D. Mangeron no. 41 Street, 700050 Iasi, Romania

• https://orcid.org/0000-0003-2364-3589

autor

Nechifor Cristina-Delia

• Gheorghe Asachi Technical University of Iasi, Department of Physics, 700050 Iasi, Romania

• https://orcid.org/0000-0003-1971-3521

autor

Cazacu Marius Mihai

• Gheorghe Asachi Technical University of Iasi, Department of Physics, 700050 Iasi, Romania

• https://orcid.org/0000-0002-7297-6411

autor

Paraschiv Petronela

• Gheorghe Asachi Technical University of Iasi, Department of Sport, 700050 Iasi, Romania

• https://orcid.org/0000-0002-9259-6109

autor

Istrate Bogdan

• Gheorghe Asachi Tech Univ Iasi, Fac Mech Engn 43 D Mangeron St, Iasi 700050, Romania

• https://orcid.org/0000-0003-0817-3523

autor

Bădărău Gheorghe

• Gheorghe Asachi Technical University of Iasi, Faculty of Materials Science and Engineering, Prof. dr. doc. D. Mangeron no. 41 Street, 700050 Iasi, Romania

• https://orcid.org/0000-0003-4233-5231

autor

Sandu Ioan Gabriel

• Gheorghe Asachi Technical University of Iasi, Faculty of Materials Science and Engineering, Prof. dr. doc. D. Mangeron no. 41 Street, 700050 Iasi, Romania

• https://orcid.org/0000-0002-8135-4083

autor

Cimpoeșu Nicanor

• Gheorghe Asachi Technical University of Iasi, Faculty of Materials Science and Engineering, Prof. dr. doc. D. Mangeron no. 41 Street, 700050 Iasi, Romania

• https://orcid.org/0000-0003-4373-017X

Bibliografia

• [1] S.M. Dezfuli, M. Sabzi, Deposition of ceramic nanocomposite coatings by electroplating process: a review of layer-deposition mechanisms and effective parameters on the formation of the coating. Ceram. Int. 45, 21835-21842 (2019). DOI: https://doi.org/10.1016/j.ceramint.2019.07.190
• [2] Q. Chang, L. Zhang, X. Liu, D. Peng, G. Meng, Preparation of crack-free ZrO2 membrane on Al2O3 support with ZrO2-Al2O3 composite intermediate layers, J. Membrane Sci. 250, 105-111 (2005). DOI: https://doi.org/10.1016/j.memsci.2004.10.020
• [3] S. Sathish, M. Geetha, Comparative study on corrosion behavior of plasma sprayed Al2O3, ZrO2, Al2O3/ZrO2 and ZrO2/Al2O3 coatings, Trans. Nonferrous Met. Soc. China 26 1336-1344 (2016). DOI: https://doi.org/10.1016/s1003-6326(16)64236-X
• [4] C. Florea, C. Bejinariu, C. Munteanu, N. Cimpoesu, Preliminary Results on Complex Ceramic Layers Deposition by Atmospheric Plasma Spraying, Advanced Materials Engineering and Technology V, Book Series: AIP Conference Proceedings 1835, UNSP 020053 (2017). DOI: https://doi.org/10.1063/1.4983793
• [5] C.D. Florea, C. Munteanu, N. Cimpoesu, I.G. Sandu, C. Baciu, C. Bejinariu, Characterization of Advanced Ceramic Materials Thin Films Deposited on Fe-C Substrate, Rev. de Chimie 68, 11 (2017).
• [6] B. Istrate, J.V. Rau, C. Munteanu, I.V. Antoniac, V. Saceleanu, Properties and in vitro assessment of ZrO2-based coatings obtained by atmospheric plasma jet spraying on biodegradable Mg-Ca and Mg-Ca-Zr alloys, Ceram. Int. Part: B 46, 15897-15906 (2020). DOI: https://doi.org/10.1016/j.ceramint.2020.03.138
• [7] C.C. Paleu, C. Munteanu, B. Istrate, S. Bhaumik, P. Vizureanu, M.S. Baltatu, V. Paleu, Microstructural Analysis and Tribological Behavior of AMDRY 1371 (Mo-NiCrFeBSiC) Atmospheric Plasma Spray Deposited Thin Coatings, Coatings, 10 1186 (2020). DOI: https://doi.org/10.3390/coatings10121186.
• [8] H.Y. Erbil, Surface Chemistry of Solid and Liquid Interfaces, Blackwell Publishing Ltd (2006), ISBN-10: 1-4051-1968-3.
• [9] C.J. Van Oss, Interfacial Forces In Aqueous Media; Marcel Dekker Inc.: New York, NY, USA (1994).
• [10] M.S. Baltatu, P. Vizureanu, A.V. Sandu, C. Munteanu, B. Istrate, Microstructural analysis and tribological behavior of Ti-based alloys with a ceramic layer using the thermal spray method, Coatings 10, 1216 (2020). DOI: https://doi.org/10.3390/coatings10121216
• [11] M. Benchea, S. Cretu, Surface roughness influence on active surfaces geometry and modified rating life of rolling contacts, IOP Conference Series-Materials Science and Engineering 724, 012025 (2020). DOI: https://doi.org/10.1088/1757-899X/724/1/012025
• [12] I. Oancea, C. Bujoreanu, M. Budescu, M. Benchea, C.M. Gradinaru, Considerations on sound absorption coefficient of sustainable concrete with different waste replacements, J. Clean. Prod. 203, 301-312 (2018). DOI: https://doi.org/10.1016/j.jclepro. 2018.08.273, 2018.
• [13] C. Bujoreanu, S. Irimiciuc, M. Benchea, A fractal approach of the sound absorption behaviour of materials. Theoretical and experimental aspects, Int. J. Nonlin. Mech. 103, 127-137 (2018). DOI: https://doi.org/10.1016/j.ijnonlinmec.2018.05.005
• [14] D.H. Kaelble, Dispersion-polar surface tension properties of organic solids. J. Adhes 2, 66-81 (1970).
• [15] A.V. Sandu, M.S. Baltatu, M. Nabialek, A. Savin, P. Vizureanu, Characterization and Mechanical Proprieties of New Timo Alloys Used for Medical Applications, Materials 12 (18), 2973 (2019). DOI: https://doi.org/10.3390/ma12182973
• [16] M. Rankl, S. Laib, S. Seeger, Surface tension properties of surface-coatings for application in biodiagnostics determined by contact angle measurements. Coll. Surf. B. Biointerf. 30, 177-186 (2003). DOI: https://doi.org/10.1016/s0927-7765(03)00085-7
• [17] R.S. Faibish, W. Yoshida, Y. Cohen, Contact Angle Study on Polymer-Grafted Silicon Wafers. J. Coll. Interf. Sci. 256, 341-350 (2002). DOI: https://doi.org/10.1006/jcis.2002.8612
• [18] A. Tandjaoui, M. Cherif, L. Carroz, J. Sanchez, R. Reboud, C. Garnier, T. Duffar, Investigation of liquid oxide interactions with refractory substrates via sessile drop method, J. Mater. Sci. 51, 1701-1712 (2016). DOI: https://doi.org/10.1007/s10853-015-9504-0

Uwagi

1. This work was supported by a grant of the Romanian Ministry of Education and Research, CNCS - UEFISCDI, project number PN-III-P1-1.1-TE-2019-1921, within PNCDI III.

2. Opracowanie rekordu ze środków MEiN, umowa nr SONP/SP/546092/2022 w ramach programu "Społeczna odpowiedzialność nauki" - moduł: Popularyzacja nauki i promocja sportu (2022-2023).