Optimal Mass Diffusion Transfer in Solids Using Heat Transfer Similarities

• Autorzy: Jaber Samar , Alahmer Ali , Borowski Gabriel , Alsaqoor Sameh

Identyfikatory

DOI

10.12913/22998624/111694

• Języki publikacji: EN

Abstrakty

EN

A new concept of solid-solid mass diffusion fin was introduced in this paper. The authors described the mass diffusion in fluid flows to analyze the transfer process in solids and its applications, especially in metallurgical research. Using the advantage of the similarity between heat transfer and mass diffusion transfer will make this issue more practical. The authors suggested a new approach to determine the maximum mass diffusion transfer between two solids by implementing of the extended surface on each solid, where the optimal mass diffusion between solids is required. Then, meshing the surfaces together in order to increase the transfer efficiency was carried out. A complete analysis of the extended surfaces design (diffusion fins), its efficiency and effectiveness were presented. Moreover, mathematical models of each consideration were constructed. The authors found that the total surface efficiency increased along with the number of mass diffusion fins attached to the base, but its effectiveness did not. The mass diffusion for an extended plate increased the total mass diffusion transfer between two materials.

Słowa kluczowe

EN

diffusion transfer; Fick's Law; diffusion resistance

PL

transfer dyfuzyjny; prawo Ficka; opór dyfuzyjny

• Wydawca: Lublin University of Technology ; Polish Society of Ecological Engineering (PTIE), Branch of PTIE in Lublin
• Czasopismo: Advances in Science and Technology. Research Journal
• Rocznik: 2019
• Tom: Vol. 13, no 4
• Strony: 54--59
• Opis fizyczny: Bibliogr. 17 poz., fig., tab.

Twórcy

autor

Jaber Samar

• Mechanical Engineering Dept., School of Engineering Technology, Al Hussein Technical University, Jordan
• Mechanical Engineering Department, American University of Madaba, Madaba, Jordan

autor

Alahmer Ali

• Department of Mechanical Engineering, Tafila Technical University, P. O. Box 179, 66110 Tafila, Jordan
• Department of Alternative Energy Technology, Faulty of Engineering and Technology, Al-Zaytoonah University, Jordan

autor

Borowski Gabriel

• Faculty of Environmental Engineering, Lublin University of Technology, ul. Nadbystrzycka 40B, 20-618 Lublin, Poland

autor

Alsaqoor Sameh

• Department of Mechanical Engineering, Tafila Technical University, P. O. Box 179, 66110 Tafila, Jordan
• Renewable Energy Engineering Department, Faculty of Engineering, Al-Isra University, Amman, Jordan

Bibliografia

• 1. Callister W., 2013. Materials science and engineering: An introduction. John Wiley & Sons.
• 2. Cengel Y. and Ghajar A., 2014. Heat and mass transfer: fundamentals and applications. April 4, McGraw-Hill Education.
• 3. Chatterji S., 1995. On the applicability of Fick’s second law to chloride ion migration through portland cement concrete. Cement and Concrete Research, 25(2), 299–303.
• 4. Crank J., 1975. The mathematics of diffusion. Clarendon Press.
• 5. Fried E., 1969. Thermal conduction contribution to heat transfer at contacts. Academic Press London,
• 6. Incropera F.P., Dewitt D., Bergman T.L., Lavine S.A., 2011. Principles of heat and mass transfer. John Wiley & Sons.
• 7. Harper R. and W. Brown, 1922. Mathematical equations for heat conduction in the fins of air-cooled engines. NACA Report No. 158,
• 8. Holman J.P., 2009. Heat transfer. McGraw-Hill Education.
• 9. Lehner F.K., 1979. On the validity of Fick’s law for transient diffusion through a porous medium. Chemical Engineering Science, 34(6), 821–825.
• 10. Mejlbro L., 1996. The complete solution of Fick’s second law of diffusion with time-dependent diffusion coefficient and surface concentration. Technical University of Denmark.
• 11. Milligen B.P.V., et al., 2005. On the applicability of Fick’s law to diffusion in inhomogeneous systems. European Journal of Physics, 26(5), 913–925.
• 12. Nowacki W., 1976. Dynamic problems of diffusion in solids. Engineering Fracture Mechanics, 8(1), 261–266.
• 13. Paradisi P. et al., 2001. The fractional Fick’s law for non-local transport processes. Physica A: Statistical Mechanics and its Applications, 293(1), 130–142.
• 14. Valdes-Parada F.J., Ochoa-Tapia J.A., Alvarez- Ramirez J., 2007. Effective medium equations for fractional Fick’s law in porous media. Physica A: Statistical Mechanics and its Applications, 373(Supplement C), 339–353.
• 15. Webb S.W. and Pruess K., 2003. The use of Fick’s law for modeling trace gas diffusion in porous media. Transport in Porous Media, 51(3), 327–341.
• 16. Zeng L. et al., 2014. Experimental measure mass diffusion transparency. Solid State Communications, 186 (Supplement C), 23–27.
• 17. Zill D.G., 2016. Advanced engineering mathematics. Jones & Bartlett Learning.

Uwagi

Opracowanie rekordu w ramach umowy 509/P-DUN/2018 ze środków MNiSW przeznaczonych na działalność upowszechniającą naukę (2019).