PL EN


Preferencje help
Widoczny [Schowaj] Abstrakt
Liczba wyników
Tytuł artykułu

Erosive potential of calcium-supplemented citric acid on bovine enamel

Wybrane pełne teksty z tego czasopisma
Identyfikatory
Warianty tytułu
Języki publikacji
EN
Abstrakty
EN
Purpose: of this paper is to present results of wear resistance investigations of epoxy-hard coal composites produced by gravity casting Design/methodology/approach: In short introduction wear resistance of polymers is presented, methods used to prepare composites together with short characterization of physical properties of applied fillers are described. Wear resistance of the specimens was determined using Schopper-Schlobach method and APGi device. During the test, the rigidly fixed specimen moves with constant velocity along a rotating cylinder with abrasive paper type corundum P60 on its surface. Wear resistance of specimens was determined after 20 meters distance of abrasion under pressing load of10Nand expressed as the weight loss of the specimen after abrasion. Findings: Addition of the hard coal particles into the epoxy resin matrix caused a decrease of the wear resistance. Wear resistance decreased in a little extend with increasing filler content. Statistical analysis of achieved results showed that the influence of hard coal on wear resistance is significant comparing neat resin and filled resin but is not significant comparing composites with different solid particles content. Practical implications: Tested composite materials can be applied among others in electrical or chemical industry where electrical properties are important but wear resistance is not so important. Originality/value: New types of epoxy-hard coal graded composites were tested. It was demonstrated that by proper gravity casting technology control it is possible to produce graded composites for which hard coal particles do not deteriorate the wear resistance in significant extend.
Rocznik
Strony
175--181
Opis fizyczny
Bibliogr. 30 poz.
Twórcy
  • Academic Centre for Dentistry, Pl. Akademicki 17, 41-902 Bytom, Poland
autor
  • Institute of Engineering Materials and Biomaterials, Silesian University of Technology, ul. Konarskiego 18a, 44-100 Gliwice, Poland
  • Institute of Engineering Materials and Biomaterials, Silesian University of Technology, ul. Konarskiego 18a, 44-100 Gliwice, Poland
  • Department of Pediatric Dentistry, Medical University of Silesia, Pl. Traugutta 2, 41-800 Zabrze, Poland
  • Department of Chemistry, Medical University of Silesia, ul. Jordana 19, 41-808 Zabrze, Poland
  • Institute of Engineering Materials and Biomaterials, Silesian University of Technology, ul. Konarskiego 18a, 44-100 Gliwice, Poland
Bibliografia
  • [1] J.O. Grippo, M. Simring, T.A. Coleman, Abfraction, abrasion, biocorrosion and the enigma of noncarious cervical lesions, a 20-year perspective, Journal of Esthetic and Restorative Dentistry 24 (2012) 10-25.
  • [2] L.A. Dobrzański, Ł. Reimann, Influence of Cr and Co on hardness and corrosion resistance CoCrMo alloys used on dentures, Journal of Achievements in Materials and Manufacturing Engineering 49 (2011) 193-199.
  • [3] T. Imfeld, Dental erosion. Definition, classification and links, European Journal of Oral Sciences 104 (1996) 151-155.
  • [4] J.H. Meurman, J.M. ten Cate, Pathogenesis and modifying factors of dental erosion, European Journal of Oral Sciences 104 (1996) 199-206.
  • [5] D.T. Zero, Etiology of dental erosion, Extrinsic factors, European Journal of Oral Sciences 104 (1996) 162-177.
  • [6] British Soft Drinks Association. Long term commitment for long term success. The 2012 UK Soft Drinks Report.
  • [7] T. Stefański, L. Postek-Stefańska, Possible ways of reducing dental erosive potential of acidic beverages, Australian Dental Journal, 2014 (in press).
  • [8] J.D. Featherstone, A. Lussi, Understanding the chemistry of dental erosion, Monographs in Oral Science 20 (2006) 66-76.
  • [9] A. Lussi, T. Jaeggi, D. Zero, The role of diet in the aetiology of dental erosion, Caries Research 38/1 (2004) 34-44.
  • [10] M.E. Barbour, D.M. Parker, G.C. Allen, K.D. Jandt, Human enamel erosion in constant composition citric acid solutions as a function of degree of saturation with respect to hydroxyapatite, Journal of Oral Rehabilitation 32 (2005) 16-21.
  • [11] M.E. Barbour, D.M. Parker, G.C. Allen, K.D. Jandt, Enamel dissolution in citric acid as a function of calcium and phosphate concentrations and degree of saturation with respect to hydroxyapatite, European Journal of Oral Sciences 111 (2003) 428-433.
  • [12] D.A. Straub, Calcium supplementation in clinical practice: A review of forms, doses, and indications, Nutrition in Clinical Practice 22 (2007) 286-296.
  • [13] M.J. Larsen, B. Nyvad, Enamel erosion by some soft drinks and orange juices relative to their pH, buffering effect and contents of calcium phosphate 33 (1999) 81-87.
  • [14] J.A. Hughes, N.X. West, D.M. Parker, R.G. Newcombe, M. Addy, Development and evaluation of a low erosie blackcurrant juice drink in vitro and in situ, 1. Comparison with orange juice, Journal of Dentistry 27 (1999) 285-289.
  • [15] T. Scaramucci, M.A.P. Sobral, G.J. Eckert, D.T. Zero, A.T. Hara: In situ evaluation of the erosive potential of orange juice modified by food additives, Caries Research 46 (2012) 55-61. [16] T. Attin, K. Meyer, E. Hellwig, W. Buchalla, A.M. Lennon, Effect of mineral supplements to citric acid on enamel erosion, Archives of Oral Biology 48 (2003) 753-759. [17] T. Attin, K. Weiss, K. Becker, W. Buchalla, A. Wiegand, Impact of modified acidic soft drinks on enamel erosion, Oral Diseases 11 (2005) 7-12.
  • [18] A.C. Magalhães, S.M. Moraes, D. Rios, M.A. Buzalaf, Effect of iron supplementation of a commercial soft drink on tooth enamel erosion, Food additives and contaminants, Chemistry, analysis, control, exposure and risk assessment 26 (2009) 152-156.
  • [19] A.C. Magalhães, S.M. Moraes, D. Rios, A. Wiegand, M.A. Buzalaf, The erosive potential of 1% citric acid supplemented by different minerals: an in vitro study, Oral Health and Preventive Dentistry 8 (2010) 41-45. [20] J. Klimek, E. Hellwig, G. Ahrens, Fluoride taken up by plaque, by the underlying enamel and by clean enamel from three fluoride compounds, Caries Research 16 (1982) 156-161.
  • [21] K.D. Jandt, Probing the future in functional soft drinks on the nanometre scale - towards tooth friendly soft drinks, Trends in Food Science and Technology 17 (2006) 263-271.
  • [22] N. Schlueter, A. Hara, R.P. Shellis, C. Ganss, Methods for the Measurement and Characterization of Erosion in Enamel and Dentine, Caries Research 45/1 (2011) 13-23.
  • [23] D.T. Zero, In situ Caries Models, Advances in Dental Research 9 (1995) 214-230.
  • [24] T.H. Grenby, M. Mistry, T. Desai, Potential dental effects of infants’ fruit drinks studied in vitro, British Journal of Nutrition 64 (1990) 273-283.
  • [25] A.T. Hara, D.T. Zero, Analysis of the erosive potential of calicum-containing acidic beverages, European Journal of Oral Sciences 116 (2008) 60-65.
  • [26] P. Malara, A. Kloc-Ptaszna, L.A. Dobrzański, M. Górniak, T. Stefański, Effect of water dilution and alcohol mixing on erosive potential of orange juice on bovine enamel, Archives of Materials Science and Engineering 62 (2013) 15-21.
  • [27] S. Hooper, N.X. West, N. Sharif, S. Smith, M. North, J. De’Ath, D.M. Parker, A. Roedig-Penmnan, M. Addy, A comparison of enamel erosion by a new sports drink compared to two proprietary products: a controlled, crossover study in situ, Journal of Dentistry 32 (2004) 541-545.
  • [28] M.C. Venables, L. Shaw, A.E. Jeukendrup, A. Roedig- Penman, M. Finke, R.G. Newcombe, J. Parry, A.J. Smith, Erosive effect of a new sports drink on dental enamel during exercise, Medicine and Science in Sports and Exercise 37 (2005) 39-44.
  • [29] N.J. Cochrane, Y. Yuan, G.D. Walker, P. Shen, C.H. Chang, C. Reynolds, E.C. Reynolds, Erosive potential of sports beverages, Australian Dental Journal 57 (2012) 1-6.
  • [30] L.A. Dobrzański, Report on the main areas of the materials science and surface engineering own research, Journal of Achievements in Materials and Manufacturing Engineering 49 (2011) 514-549.
Typ dokumentu
Bibliografia
Identyfikator YADDA
bwmeta1.element.baztech-455ad5ac-27d2-4c68-95e6-3053325c43a0
JavaScript jest wyłączony w Twojej przeglądarce internetowej. Włącz go, a następnie odśwież stronę, aby móc w pełni z niej korzystać.