Impact of an external, so called box, module on gases composition of the ROVER 2.0 CDTI engine

• Autorzy: Prajwowski K.
• Języki publikacji: EN

Abstrakty

EN

Environmental impact of the motor vehicle has been felt in every stage of the motor vehicle operation. In the initial phase of the operation, when the vehicle is new, the amount of pollutants getting into the environment is less than at the end of its life, before the scrapping. This is connected with wearing the engine during its operation. However, the need for better performance through the chiptuning or the Box type devices are quite common nowadays, but the impact on the environment may not exceed the permitted emission limits. The article describes the external, so-called Box, module and its impact on the change of the injector opening time, and also on the change of the ROVER 2.0 CDTi engine power and torque. The simplicity of this device lies in the fact that such a modification can be made by everyone who follows the installation instructions. It is not necessary to conduct the program reading, like in the case of a program exchange in the EEPROM or programming via the diagnostic connector EOBD. The external module (box) is connected between the ECU and the Common Rail injectors. Thus, the control program does not change, but the injector opening time is adequately increased.

Słowa kluczowe

EN

combustion engines; impact on power; torque; composition of the gases; chiptuning

• Wydawca: Łukasiewicz Research Network - Institute of Aviation ; European Science Society of Powertrain and Transport KONES Poland ; Wydawnictwo Instytutu Technicznego Wojsk Lotniczych
• Czasopismo: Journal of KONES
• Rocznik: 2013
• Tom: Vol. 20, No. 3
• Strony: 323--329
• Opis fizyczny: Bibliogr. 10 poz., rys.

Twórcy

autor

Prajwowski K.

• West Pomeranian University of Technology, Szczecin Department of Motor Vehicle Use Piastów Av. 17, 70-310 Szczecin, Poland tel.:[phone], fax: [phone]

Bibliografia

• [1] Blam, M., Mocy, przybywaj, Auto EXPERT Nr 6/2008, Wydawnictwo Vogel Business Media, Warszawa 2008.
• [2] Myszkowski, S., Podstawy tuningu silnika, auto EXPERT nr 11/2008, Wydawnictwo Vogel Business Media, Warszawa 2008.
• [3] Prajwowski, K., Impact of an external, so called Box, module on power and torque of the FIAT 1.3 JTD motor, Journal of KONES Powertrain and Transport, Vol. 19, No. 1, 2012.
• [4] Słupska, E., Słupski, M., Chip-tuning, Auto Moto Serwis Nr 12/2010, Wydawnictwo Instalator Polski, Warszawa 2007.
• [5] Staszewski, M., Kilka słów o chiptuningu, Serwis motoryzacyjny nr 4/2009, Polska Izba Stacji Kontroli Pojazdów, Warszawa 2009.
• [6] Artykuł redakcyjny, Metody zwiększania mocy silników, auto EXPERT nr 3/2007, Wydawnictwo Vogel Business Media, Warszawa 2007.
• [7] Instrukcja obsługi „ROVER 75” Publikacja, Nr RCL 0548LAN 01/2003, MG Rover Group Limited 2001.
• [8] http://www.44tuning.pl/chip-tuning-rover-75-2.0-cdti-131-km.
• [9] http://vtechdyno.eu/.
• [10] http://www.v-tronic.pl/show.php?element=hamownia.